Radial sample load distribution under overload conditions: Analytical scale columns

The homogeneity of the sample load across the radial cross section of analytical scale columns was determined when operating under overload conditions. The study was performed using active flow technology columns operating in parallel segmentation mode. The outlet segmentation ratio was varied to enable different volume fractions of mobile phase, and thus sample, to elute from the peripheral and central flow regions of the column. The amount of solute exiting the peripheral and radial central exit ports was determined as a function of the flow segmentation ratio. The experimental data using an analytical scale column with dimensions, 100?×?4.6?mm, indicated that the sample load distribution was essentially uniform as a function of the column radial cross section.     

水面舰艇编队的最佳防空队形探讨

最佳防御队形以编队对来袭导弹的可探测面积尽可能大为前提,并以"抗饱和攻击能力"为衡量标准.各方向的可拦截批次受两方面因素限制:一是来袭导弹被发现时其与指挥舰的距离,一般距离越大,防御准备就越充分,可拦截批次就越大;二是护卫舰到来袭导弹轨迹的距离,一般距离越小,单次拦截时间就越短,可拦截批次就越大.定义以概率1可拦截批次最小的方向为最危险方向,经计算初始队形各方向可拦截的批次不等,通过"削峰补谷"的方式予以均衡和优化.若以拦截批次的期望为标准,最危险方向与以概率1可拦截的批次为标准的结果相同.如果得到空中预警机的信息支援,在最危险方向上编队就可更早地对距离指挥舰148.4km远的导弹发起拦截,增大编队的抗饱和攻击能力,但由于防空导弹射程限制,预警机提供的信,息支援无法得到充分利用,此时限制编队抗饱和攻击能力的主要矛盾转向防空导弹的射程.     

Environmental radioactivity of soils and sediments: Egyptian sector of the Nile valley

The activity concentrations of natural ⁴⁰K, ²³²Th, and ²³⁸U in 89 soil and 84 sediment samples collected over the entire Egyptian Nile River basin including the Nile delta are reported based on the results of epithermal neutron activation analysis. The average activity concentrations of ⁴⁰K, ²³²Th, and ²³⁸U equal to 15.3?±?6.6, 15.6?±?11.1 and 220?±?31 Bq/kg, respectively, are significantly lower than those reported for the Upper Continental Crust, World Average Sediments as well as World Average Soils, suggesting the presence of a considerable portion of mafic material, most probably originating from the Ethiopian High Plateau. Their average activity concentrations are statistically the same in soil and sediments, indicating that the Nile sediments and soil material are of the same origin. The main goal of this study was not only to estimate the radiological hazards but also to show the influence of sedimentary material transportable by the Blue Nile from the Ethiopian High Plateau. The different hazard indices like the radium equivalent, gamma index, external hazard as well as the internal hazard show a low radiological exposure either on direct contact or if local mud bricks are used in the construction of dwellings.     

Performance of a silicon monochromator under high heat load

The performance of a cryogenically cooled double‐crystal silicon monochromator was studied under high‐heat‐load conditions with total absorbed powers and power densities ranging from 8 to 780 W and from 8 to 240 W mm^?2, respectively. When the temperature of the first crystal is maintained close to the temperature of zero thermal expansion of silicon, the monochromator shows nearly ideal performance with a thermal slope error of 0.6 µrad. By tuning the size of the first slit, the regime of the ideal performance can be maintained over a wide range of heat loads, i.e. from power densities of 110 W mm^?2 (at total absorbed power of 510 W) to 240 W mm^?2 (at total absorbed power of 240 W).     

Some Aspects of the Mobility and Distribution of Toxic Heavy Metal Contaminants Insoil Profiles and River Sediments

Abstract

Investigations of the distribution and mobility of Pb, Ni, Cd and Hg have shown that Pb is strongly associated with humic substances in the top layer of soils and in river sediments, and that Pb shows the highest organophilicity. Ni is very organophilic, and Cd, somewhat less so. The hydrophilicity of Hg highly influences its movement in soil profiles and river sediments. The risk of contamination by these metals is characterized through the environment protection capacity (EPC_G) values which combine humus content and the quality and thickness of the humus layer in one parameter. The risk of contamination is highest at low EPC_G values. Increase of EPC_G decreases the risk of environmental contamination through binding of heavy metals to humic substances, decreasing their mobility.     

Allostatic load as a complex clinical construct: A case‐based computational modeling approach

Allostatic load (AL) is a complex clinical construct, providing a unique window into the cumulative impact of stress. However, due to its inherent complexity, AL presents two major measurement challenges to conventional statistical modeling (the field's dominant methodology): it is comprised of a complex causal network of bioallostatic systems, represented by an even larger set of dynamic biomarkers; and, it is situated within a web of antecedent socioecological systems, linking AL to differences in health outcomes and disparities. To address these challenges, we employed case‐based computational modeling (CBM), which allowed us to make four advances: (1) we developed a multisystem, 7‐factor (20 biomarker) model of AL's network of allostatic systems; (2) used it to create a catalog of nine different clinical AL profiles (causal pathways); (3) linked each clinical profile to a typology of 23 health outcomes; and (4) explored our results (post hoc) as a function of gender, a key socioecological factor. In terms of highlights, (a) the Healthy clinical profile had few health risks; (b) the pro‐inflammatory profile linked to high blood pressure and diabetes; (c) Low Stress Hormones linked to heart disease, TIA/Stroke, diabetes, and circulation problems; and (d) high stress hormones linked to heart disease and high blood pressure. Post hoc analyses also found that males were overrepresented on the High Blood Pressure (61.2%), Metabolic Syndrome (63.2%), High Stress Hormones (66.4%), and High Blood Sugar (57.1%); while females were overrepresented on the Healthy (81.9%), Low Stress Hormones (66.3%), and Low Stress Antagonists (stress buffers) (95.4%) profiles. © 2015 Wiley Periodicals, Inc. Complexity 21: 291–306, 2016     

Modelling sediment transport over partially non‐erodible bottoms

In‐depth‐averaged and cross‐section‐averaged morphodynamic models, based on explicit time integration, it may happen that the computed bed level becomes lower than the top level of a non‐erodible layer (e.g. concrete, bedrock or armoured layer). This is a standard pitfall, which has been addressed in different ways. In this paper, we present an original approach for avoiding computation of non‐physical bed levels, using an iterative procedure to correct the outward sediment fluxes. The procedure is shown to be computationally efficient while it achieves a high accuracy in terms of mass conservation. We compare our original approach with the existing Struiksma's method and with a reformulation of the problem in terms of mathematical optimization of a linear or nonlinear objective function under linear constraints. The new procedure has been incorporated into an existing finite volume morphodynamic model. It has been validated with several 1D benchmarks leading to configurations with sediment transport over non‐erodible bottom. The computation time has been verified not to increase by more than 15% compared with runs without non‐erodible bottom. Copyright © 2011 John Wiley & Sons, Ltd.     

Distribution of trace elements in flowing surface waters: Effect of seasons and anthropogenic practices in India

This study reports the distribution of Cr, Ni, Cu and Pb in waters, sediments, macrophytes and fish of the Yamuna River’s patch in Delhi (India). This is one of the most polluted stretches of rivers in the world. Water from this river is used fosr irrigation, industrial and domestic purposes, including drinking water. The effects of season and anthropogenic practices were identified. Almost zero dissolved oxygen and high levels of lead and phosphate indicate the polluted state of the aquatic system. The enrichment factors in sediments (with respect to reference site) vary in the range of 0.60–82.9% (Cr), 1.40–90.5% (Ni), 1.00–85.3% (Cu) and 3.80–86.6% (Pb). The toxic effects due to Ni and Pb could frequently be visible in aquatic life as their values fall above the probable effect level (36 mg Kg^?1 for Ni and 91.3 mg Kg^?1 for Pb). The metal contents in the macrophyte (Eichhornia crassipes) and the fish (Oreochromis niloticus) generally increase in the summer season. Cu and Pb accumulate preferentially in E. crassipes. The fish from these waters is unsuitable for human consumption as the levels of Cr, Cu and Pb are above the recommended limits. Significant spatial variations in parameters of water and sediments were confirmed via one-way analysis of variance. The Pearson’s correlation analysis suggests a common source of some of the metals. Principal component analysis highlighted domestic, and industrial waste and coal-fired thermal power plants as the metal sources. This study might act as a benchmark for other investigations focused on similarly affected surface aquatic systems due to agricultural and industrial activities.     

A re-examination of platinum-group element concentrations in the environmental certified reference material BCR-723

A detailed statistical examination of replicated data used to certify platinum-group elements (PGEs) in environmental reference material BCR-723 is presented. Certification of Pt, Pd, and Rh concentrations in BCR-723 was based on 16, eight, and nine accepted data sets, respectively. Each accepted data set contained six replicated measurements for each PGE, and the statistical properties of these concentration data were examined, i.e. 96 for Pt, 48 for Pd, and 54 for Rh. This level of investigation has received limited attention but is critical in furthering our understanding of PGE variability and representativeness. Concentrations of Pt, Pd, and Rh were shown to differ significantly between accepted data sets. Palladium and Pt differed in their quantification between detection techniques. Additionally, Pd and Pt concentrations varied significantly between laboratories using a similar definitive method (inductively coupled plasma-isotope dilution mass spectrometry). The distribution of Pd concentrations was found to be bimodal, with a secondary population exhibiting a contamination signal of about 15%. The secondary population, not previously reported in BCR-723, is likely a measurement artifact and not due to a nugget effect. Comparisons of BCR-723 with other environmental media from Europe, i.e. airborne particulate matter, tunnel dust, and road-deposited sediment, indicated that Pd is uncommonly low in BCR-723 (6.0?ng?g^?1) and is generally not representative in terms of its distribution relative to Pt and Rh. Serious consideration should be given to developing a new PGE certified environmental reference material.     

Simultaneous determination of cyromazine,melamine and their biodegradation products by ion-pair high-performance liquid chromatography

An ion-pair high-performance liquid chromatography with ultraviolet detection method for the determination of cyromazine, melamine and its biodegradation products (ammeline, ammelide, cyanuric acid and biuret) was developed. C18 column was utilised to separate the six analytes with a mobile phase consisting of perchloric acid-ammonia solution and acetonitrile, under gradient elution and variable flow rate. The detection wavelengths were 205 nm for cyanuric acid and biuret and 222 nm for cyromazine, melamine, ammeline and ammelide. For analysis of sediment samples, the extraction solution containing acetonitrile, ammonia and water (80:10:10 by volume) was used to extract the analytes from sediment matrix. Using the extraction method for the spiked sediment sample, high linearity of matrix-matched standard curve could be obtained for the six analytes. The method detection limit was 0.1 μg g^?1 for melamine and cyromazine, 0.2 μg g^?1 for ammeline and ammelide, 1.2 μg g^?1 for cyanuric acid and 1.0 μg g^?1 for biuret in sediment matrix. The recoveries of these compounds were 70.1–98.3% and the relative standard deviations were 0.5–4.4%. Finally, the proposed method was successfully applied to the analysis of the sediment sample near the wastewater outlet of a melamine-producing factory.