二硫化锡纳米片阻变存储器的制备与性能

采用水热法合成了尺寸为50~100 nm的二硫化锡纳米片,并首次以二硫化锡作为阻变层材料的阻变存储器（Cu/PMMA/SnS₂/Ag,PMMA=聚甲基丙烯酸甲酯）,对其阻变性能进行了研究。结果表明： Cu/PMMA/SnS₂/Ag阻变存储器的开关比约10⁵,耐受性2.7×10³。在上述2项性能指标达到较优水平的同时,开态与关态电压分别仅约为0.28与-0.19 V。     

High pressure inactivation of Clostridium botulinum type E endospores in model emulsion systems

Clostridium botulinum type E is a cold-tolerant, neurotoxigenic, endospore-forming organism, primarily associated with aquatic environments. High pressure thermal (HPT) processing presents a promising tool to enhance food safety and stability. The effect of fat on HPT inactivation of C. botulinum type E spores was investigated using an emulsion model system. The distribution of spores in oil-in-water (O/W) emulsions and their HPT (300–750?MPa, 45–75?°C, 10?min) inactivation was determined as a function of emulsion fat content (30–70% (v/v) soybean oil in buffer). Approximately 26% and 74% of the spores were located at the oil–buffer interface and the continuous phase, respectively. Spore inactivation in emulsion systems decreased with increasing oil contents, which suggests that the fat content of food plays an important role in the protection of C. botulinum type E endospores against HPT treatments. These results can be helpful for future safety considerations.     

基于Web的实时漆包线材生产设备监控平台设计

为了实现漆包机生产的远程监控,设计了一款基于Web的实时漆包机远程监控平台。该平台使用模块化,可扩展的设计方案,采用了Spring MVC的后台Web应用程序框架,基于Modbus协议的数据交互,Ajax方式的网络数据异步提交以及无刷新的图表显示技术。传统的监控平台只能通过以太网在企业内部访问,而该平台可接入互联网,可实现随时随地通过电脑及或者移动终端对生产设备各部分的温度点、电机风机转速、耗电量统计的实时监视,对温度的上下限及电机转速进行远程控制,接收设备状态异常的实时报警,数据存储分析。实验测试表明,该平台的实时性和稳定性均能达到车间生产的要求。     

Adaptive RAKE receiver in chaos based pilot-added DS-CDMA system

This paper presents the theoretical analysis of adaptive multiuser RAKE receiver scheme in frequency selective fading channel for direct-sequence code division multiple access (DS-CDMA) system. Least mean square (LMS) algorithm is used to estimate the channel coefficients. Chaotic sequences are used as spreading sequence and corresponding bit error rate (BER) in closed form is derived for imperfect channel estimation conditions. Performances of chaotic sequences are compared with pseudorandom noise (PN) sequences. Under perfect synchronization assumption, various simulation results are shown to investigate the performance of the proposed system.     

Characteristic X-ray detector: In-situ imaging of radioactive contaminant distributions

The characteristic X-ray detector (CXRD), a CsI(Tl) scintillator with a 50-mm diameter, is a directional X-ray sensor that measures characteristic X-rays from radioactive material, such as ¹³⁷Cs, and identifies the direction of radioactive contamination. We evaluated a CXRD and visualized the distribution of radioactivity in the contaminated area near the Fukushima Dai-ichi nuclear power station, where the ambient dose equivalent rate was 2.1 μSv/h at 1 m above ground level. We found a good correlation between the characteristic X-ray fluxes and the distribution of radioactive contaminants with a 0.823 Pearson product–moment correlation coefficient.     

Research activities at the PALS research infrastructure

The Prague Asterix Laser System (PALS) Research Infrastructure (RI) in Prague, one of only four kJ-class laser facilities in EU, has been offering its beam time to European researchers for already 14 years, since 2004 in the framework of the LASERLAB-Europe consortium. Till June 2014, the PALS RI has provided 4313 experimental days for a total of 41 projects with 303 international users from 42 different research institutions. Its principal experimental facility is a terawatt sub-ns iodine laser (1315?nm) with an optional plasma-based zinc XUV laser (21.2?nm), and an auxiliary Ti:Sapphire fs laser (1?J, 70?fs) exploited for femtosecond plasma probing and experiments with synchronised femtosecond and sub-nanosecond laser pulses at mean laser intensities of up to 30?PW/cm². The lasers are equipped with several target facilities and rich sets of instruments for both active and passive plasma diagnostics. The PALS main research areas include development and applications of secondary laser sources of high-energy ions and both coherent and non-coherent high-intensity XUV radiation, laboratory astrophysical and inertial fusion-relevant studies. In this paper, the main results having been achieved at PALS in the framework of LASERLAB-EUROPE international access activities during the last four years are highlighted.     

表面增强拉曼光谱在食品安全分析中的应用

拉曼光谱技术具有样品用量少、快速高效、无损分析等特点,表面增强拉曼光谱克服了常规拉曼光谱灵敏度低的缺点,可以获得更多物质结构信息,在现场快速筛查、检测和鉴别农兽残、限用或禁用添加剂分析检测中具有广阔的应用前景。本文综述了表面增强拉曼光谱在食品中农药残留、兽药残留和限/禁用添加剂检测中的研究进展,并展望了其发展前景。     

Third-Generation Solar Cells: Toxicity and Risk of Exposure

Solar energy is considered clean energy, and its use is predicted to increase in the near future. Most installed units today are crystalline solar cells, but the field is in constant development, and when the first dye sensitized solar cell was published by Grätzel and O'Reagan a new, third-generation, solar power was born. Highly toxic metals are used to produce the photovoltaic units today, and with the predicted increase in solar cell installation, the human health hazards of these panels could become an issue. Additionally, many of these materials are used in their nanoform, which is associated with an additional risk. In this article, we discuss the technology behind the third-generation solar cells with its valuable use of nanotechnology as well as the possible health hazard when such nanomaterials are used in solar power units. We will show that the main exposure will occur either during the development and production phases or at the end-of-life stage of the solar cells, where toxic material can leach into landfills, and subsequently into the environment and impact the ecosystem directly, or humans indirectly through edible plants or drinking water.     

A finite element method based comparative fracture assessment of carbon black and silica filled elastomers: Reinforcing efficacy of carbonaceous fillers in flexible composites

This study is focused on numerical investigation on fracture behaviors of carbon black (CB) and silica filled elastomeric composites. Finite element analysis (FEA) in compliance with multi-specimen method is used to calculate J-integral and geometry factor of the rubber composites up to a displacement of 20 mm for single edge notch in tension (SENT) and double edge notch in tension (DENT) specimens. An empirical relationship between crack tip opening displacement (CTOD) and crack advancement is established depending on notch to width ratio (NWR). The stress contours across the notches for SENT and DENT specimens is discussed briefly. It is found that fracture propagation resistance of CB filled elastomer is 125% more than that of silica filled elastomer. Although, Silica filled elastomer have good tensile strength and crosslink density but it fails to replace carbon black in terms of fracture properties. The critical J-integral for CB filled elastomer is 18.7% and 32.2% more than silica filled elastomer for SENT and DENT specimens respectively. The effect of specimen type on various fracture properties is also explored. The factor of safety is found to be significantly more in case of CB filled elastomers making them less vulnerable to crack propagation and catastrophic failure.     

磺酰脲类化合物在水稻田中的除草性能

水稻是我国重要的粮食作物,但杂草对水稻的产量和品质产生了严重影响。 化学防除是治理水稻田杂草最有效的途径。 文中设计合成了苯环2,6-取代和2,5-取代两个系列磺酰脲类化合物,并通过核磁共振波谱仪(NMR)和高分辨质谱仪(HRMS)等对其进行了结构表征。 通过水稻田除草活性和安全性测试发现化合物在水稻田中具有较好的除草活性,尤其是化合物10a对水稻田中的主要杂草稗草和醴肠除草活性(目测初筛防效大于90%)优于对照药醚苯磺隆和氯磺隆,安全性与之相当。