Effects of oxygen in gamma irradiated aromatic polyesters in film

The effect of gamma irradiation in air is investigated on four thermoplastic polyesters (PET, PBT, PEN, PCT-co-ET) in films containing aromatic rings, in order to evaluate the influence of aromatic density and the role of oxygen on radiation resistance. Physical-chemical-nuclear analyses were used to this purpose. EPR measurements were carried out to detect radical stability against oxygen permeation. Viscometric investigations reported a very similar trend for all the investigated polyesters: a chain break effect that decreases at the highest doses. FT-IR analyses focused on the formation of oxidized species. Positron annihilation spectra pointed out a decrease of the intensity of ortho-positronium formation, while its lifetime remains unchanged with radiation dose.     

Synthesis of dihalocarbene derivatives of estafiatin guaianolide

Adducts of dihalocarbenes generated from chloroform and bromoform were prepared by reaction with estafiatin guaianolide. Their structures were established by XSA. __________ Translated from Khimiya Prirodnykh Soedinenii, No. 5, pp. 453–455, September–October, 2007.     

纯锆上离子注入钇和镧后的表面分析

用金属蒸汽真空弧源，以40kV加速电压对纯锆样品分别进行了10¹⁶—10¹⁷/cm²的钇、镧离子注入，注入温度约为130℃.然后对注入样品进行表面分析.x射线光电子能谱分析表明，注入的钇以Y₂O₃形式存在，镧以La₂O₃形式存在.俄歇电子能谱表明，纯锆基体表面的氧化膜厚度随着离子注入剂量的增加而增加，当离子注入剂量达到10¹⁷/cm²时，氧化膜的厚度达到了最大值.卢瑟福背散射显示镧层的厚度约为30nm，同时直接观察到当离子注入剂量为(La+Y)10¹⁷/cm²时，纯锆样品表面发生了严重的溅射. 关键词： 纯锆 钇和镧离子共注入 卢瑟福背散射 x射线光电子能谱     

Mössbauer study of nanodimensional nickel ferrite – mechanochemical synthesis and catalytic properties

Iron–nickel spinel oxide NiFe₂O₄ nanoparticles have been prepared by the combination of chemical precipitation and subsequent mechanical milling. For comparison, their analogue obtained by thermal synthesis is also studied. Phase composition and structural properties of iron–nickel oxides are investigated by X-ray diffraction and Mössbauer spectroscopy. Their catalytic behavior in methanol decomposition to CO and methane is tested. An influence of the preparation method on the reduction and catalytic properties of iron–nickel samples is established.     

Morphological and chemical study of the initial growth of CdS thin films deposited using an ammonia-free chemical process

We study the initial growth stages of CdS thin films deposited by an ammonia-free chemical bath deposition process. This ammonia-free process is more environmentally benign because it reduces potential ammonia release to the environment due to its high volatility. Instead of ammonia, sodium citrate was used as the complexing agent. We used atomic force microscopy (AFM), Rutherford backscattering (RBS) and X-ray photoelectron spectroscopy (XPS) to investigate the morphological and chemical modifications at the substrate surface during the first initial stages of the CdS deposition process. Additionally, X-ray diffraction (XRD) and optical transmission spectroscopy measurements were carried out to compliment the study. XPS results show that the first nucleation centers are composed by Cd(OH)₂ which agglomerate in patterns of bands, as demonstrated by AFM results. It is also observed that the conversion to CdS (by anionic exchange) of the first nucleus begins before the substrate surface is completely covered by a homogenous film.     

Magnetic order in LaEuSrCuO studied [2pt] by Fe Mössbauer spectroscopy

⁵⁷Fe M?ssbauer effect studies of La_1.65Eu_0.20Sr_0.15CuO₄ doped with 0.5 at% ⁵⁷Fe performed in the temperature region 300 K > T > 4.2 K give an onset temperature for magnetic ordering of K. This temperature practically is the same as that found in Nd doped La_2-xSr_xCuO₄. It indicates that the magnetic ordering temperature in the LTT phase of rare earth (RE) doped La_2-xSr_xCuO₄ is independent of the RE moment. The direction of the ⁵⁷Fe magnetic moment in the magnetically ordered state is within the CuO₂ plane, while it has been found to be parallel to the c-axis in Nd doped La_2-xSr_xCuO₄. Received: 23 June 1998 / Accepted: 14 July 1998     

Rotational Motion of a Solute Molecule in a Highly Viscous Liquid Studied byC NMR: 1,3-Dibromoadamantane in Polymeric Chlorotrifluoroethene

The viscosity-dependent retarding effect of a polymeric solvent on the rotation of small solute molecules is investigated by¹³C NMR relaxation measurements. It is found that the relaxation data of 1,3-dibromoadamantane in highly viscous polymeric chlorotrifluoroethene can be explained neither by isotropic nor by realistic anisotropic tumbling in a single environment. The experimental data are rationalized in terms of fast exchange between at least two environments with correlation times differing by up to two orders of magnitude. The study shows that a uniform retardation of molecular tumbling by a polymeric solvent, desirable for shifting the NMR observation window in studies of intramolecular mobility, is not always feasible.     

Thickness of a silica-tethered poly(ethylene oxide) layer measured by spin labeling

EPR spectroscopy of labeled poly(ethylene oxide) (PEO) grafted on silica has been used to characterize the conformation and local dynamics of the chains. Grafted molecules of MW 2000 with grafting ratios of 0.045, 0.057, 0.126, and 0.42 molecules/nm² were in contact with benzene. The mobility of the label was compared with that observed for solution of PEO from very diluted to highly concentrated and even bulk PEO. Thus, the concentration inside the grafted layer could be evaluated and also the thickness, which evolves rather linearly with the grafting ratio. © 1995 John Wiley & Sons, Inc.     

Thermal decomposition of transition metal carboxylates

Dynamics of changes in microstresses during thermal decomposition of Cu(HCOO)₂ crystals and their effect on the thermal decomposition kinetics were studied by IR spectroscopy at 105 to 120 °C. The formation of solid intermediate HCOOCu was observed, and the dynamics of its accumulation was followed. Kinetic regularities of transformation of HCOO groups were compared with those for gas evolution.For Communication 1, see Ref. 1.Translated from Izvestiya va Akademii Nauk. Seriya Khimicheskaya, No. 2, pp. 350–354, February, 1996.     

STS investigations of temperature dependence of Au(1 1 1) surface state energy position

High temperature scanning tunneling spectroscopy (HT-STS) was used to investigate the electronic structure of Au(1 1 1) at different temperatures in the energy range 0-1 eV below the Fermi level. We concentrated on the influence of temperature on the Shockley surface state (SS) appearing on noble metals surface due to a surface projected bulk bang gap in [1 1 1] direction. The influence of temperature on the projected band gap edge (BE) was also investigated. The experiment was carried out in the temperature range 294-580 K. As the result of the experiment a delicate shift of the SS and the BE in direction of the Fermi level was reported.