Polytetrafluoroethylene and metal structure convective-flow CO laser

A convective flow CO laser composed of polytetrafluoroethylene discharge tubes, nickel–chromium steel components, a cupric heat exchanger and other components is described. Operating in liquid nitrogen condition, output power of 60 W has been obtained from a non-selective cavity.     

Formation of p-type ZnO film on InP substrate by phosphor doping

ZnO thin film was initially deposited on InP substrate by radio frequency (rf) magnetron sputtering and the diffusion process was performed using the closed ampoule technique where Zn₃P₂ was used as the dopant source. To verify the junction formation of ZnO thin films, the electrical properties were measured, and the effects of Zn₃P₂ diffusion on ZnO thin films were investigated. It is observed that the electrical property of the film is changed from n-type to p-type by dopant diffusion effect. Based on the results, it is confirmed that ZnO thin films can be a potential candidate for ultraviolet (UV) optical devices.     

Voltage ‐ Current Study of an Atmospheric Dielectric Barrier Discharge

The discharge behaviour of an atmospheric dielectric barrier parallel plate discharge, used for surface treatment, is studied. Since an uniform plasma is preferable for surface treatment, filaments must be avoided in the discharge. The occurrence of filaments can be detected by measuring the current flowing through the discharge. Current and voltage measurements give an indication of the power consumption by the plasma. The power consumption of the plasma as function of the applied frequency is examined. (© 2007 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)     

Magnetic and magneto-optical properties of CoFeCrSiB amorphous ribbons

In this paper we investigate the surface magnetic properties of as-quenched (AQ) CoFeCrBSi ribbons prepared by planar flow casting method with using magneto-optic Kerr effect (MOKE). Measured hysteresis loops in longitudinal and transversal configurations enable us to obtain the information of ribbons surface magnetic properties. Moreover, we suggest new magneto-optic method, which is based on measurements of magneto-optical effects depending on DC current flowing through the ribbon. Experimental data of AQ ribbons are then compared with the model, which describes the influence of incidence angle on magneto-optical angles.     

气体放电等离子体特性测量I-V曲线不对称性的研究

利用气体放电双探针法研究了等离子体的I-V曲线中的电流I相对于电压V轴交点的不对称性,并提出2种可能的解释:一认为是由于两探针表面积不同引起的;二认为是由于探针所在处等离子体电位不等引起的.本文利用仪器的工艺误差和调换放电管电压的方法,对提出的2种可能原因分别进行验证,并指出第二种解释的合理性,并对其进行了理论分析.     

气体放电击穿过程的物理和数值研究

本文对低气压（１０＾－２Ｐａ）热阴极气体放电的击穿过程给出了物理描述和相应的双流体数学型，并发展了一种选择和调整未知初始条件的有效算法，可以通过伴随试射法得到对初始条件十分敏感的非线性两点边值常微分方程组的数值解，从而给出这类气体放电中击穿过程的定量描述。     

Numerical Analysis and Simulation Analysis for Space‐Time Data

Spatio temporal dynamics of the positive column of a dc neon glow discharge is studied and investigated experimentally and theoretically. Spatio temporal analysis by means of biorthogonal decomposition method (BOD) gives insights into the mechanism of irregularity and can be employed for characterization of spatio‐ temporal complexity. In the weak nonlinear region, the wave dynamics is approximated by an amplitude equation of the Ginzburg‐Landau equation (CGLE) with complex coefficients and an additional integral term based on a fluid model. In the present work we deal with irregular spatio‐temporal data. A comparison between the numerical analysis of the experimental data and simulation results are studied. A good agreement between the dynamical behaviour for experimental space‐time data and theoretical simulation space‐time results was obtained. (© 2006 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)     

电子碰撞诱导原子从低激态向高激态弛豫

本文根据空心阴极放电中电子能量分布的物理图象,分析了原子从低激态向高激态弛豫的可能途径。建立高低激态集居数密度增量的关系。讨论高激态集居数密度增量获得可观量的条件。根据此条件分别选取钠原子的基态3s~2S_(1/2)和铜原子的亚稳态4s~2D_(3/2)为与激光共振的下能级,并激发具有较大自发发射几率的3s~2S_(1/2)→3p~2P°_(1/2)(和3p~2P°_(3/2))和4s~2D_(3/2)→4p~2P°_(1/2)跃迁,在远离上能级的高激态上观测到敏化荧光,并精确测得这些态的自发发射系数比值,而在更高激态上没有观测到敏化荧光,表明讨论中提出的条件是合理的。     

Ultra trace analysis of refractory metals by solid state mass spectrometry — A comparison of GDMS,SSMS and SIMS

The analytical performance of a glow discharge quadrupole mass spectrometer is demonstrated using sintered tungsten as an example. The inherent problem of molecular interferences in glow discharge mass Spectrometry has been considerably reduced using neon as a complementing discharge gas. Particular attention has been paid to time dependences. Analytical figures of merit are presented.     

Novel Catalytic Dielectric Barrier Discharge Reactor for Gas-Phase Abatement of Isopropanol

Catalytic gas-phase abatement of air containing 250 ppm of isopropanol (IPA) was carried out with a novel dielectric barrier discharge (DBD) reactor with the inner catalytic electrode made of sintered metal fibers (SMF). The optimization of the reactor performance was carried out by varying the voltage from 12.5 to 22.5 kV and the frequency in the range 200–275 Hz. The performance was significantly improved by modifying SMF with Mn and Co oxide. Under the experimental conditions used, the MnO _x /SMF showed a higher activity towards total oxidation of IPA as compared to CoO _x /SMF and SMF electrodes. The complete destruction of 250 ppm of IPA was attained with a specific input energy of ∼235 J/L using the MnO _x /SMF catalytic electrode, whereas, the total oxidation was achieved at 760 J/L. The better performance of the MnO _x /SMF compared to other catalytic electrodes suggests the formation of short-lived active species on its surface by the in-situ decomposition of ozone.