Polymorphism in mercury(I) selenite(IV): preparation, crystal structures of α-, β-and γ-Hg2SeO3, and thermal behavior of the α- and β-modification

Mercury(I) selenite(IV) is polymorphic and crystallizes at least in three modifications, named α-, β-and γ-Hg₂SeO₃. Polycrystalline β-Hg₂SeO₃ was prepared by precipitation of a concentrated mercurous nitrate solution with selenous acid. Hydrothermal treatment of the colorless β-Hg₂SeO₃ powder in demineralized water at 250°C (10 days) yields light-yellow single crystals of α-Hg₂SeO₃ which show the highest density of the three modifications. Colorless needle-shaped single crystals of β-Hg₂SeO₃ and very few single crystals of γ-Hg₂SeO₃ co-crystallize from strongly diluted Hg₂(NO₃)₂ and H₂SeO₃ solutions and were grown by a diffusion technique. All crystal structures were solved and refined from single crystal diffractometer data sets and are based on Hg₂²⁺ dumbbells and trigonal pyramidal SeO₃²⁻ anions as the main building units. A common structural feature of all modifications is the formation of open channels extending parallel to the shortest crystallographic axis. The non-bonding orbitals of the Se^IV atoms are stereochemically active and protrude into the channels. Upon heating in an open system under N₂ atmosphere, both α- and β-Hg₂SeO₃ decompose in a well-separated three-step mechanism. The first step (T > 250°C) involves disproportionation into elementary mercury and α-HgSeO₃ which at ca. 400°C subsequently transforms into β-HgSeO₃. The second step between T = 400 and 500°C is accompanied by a loss of Hg and SeO₂ and the formation of the basic salt Hg₃SeO₆. In the third step, at temperatures between T = 500° and 600°C, this material decomposes completely. Upon heating in a closed system (sealed silica capillaries), β-Hg₂SeO₃ transforms between 320-340°C into the more dense α-Hg₂SeO₃ which on further heating likewise converts into elementary mercury and β-HgSeO₃.     

钇对Nd-Fe-Al-Ni非晶合金热稳定性与晶化行为的影响

采用差示扫描量热法（DSC）、X射线衍射（XRD）和透射电镜（TEM）研究了Y对Nd-Fe-Al-Ni非晶合金热稳定性和晶化行为的影响。结果表明,淬火态的Nd60Fe20Al10Ni10-xYx（x=0,2）合金基本为非晶组织同时还含有少量的淬态相,Y的加入抑制了淬态相的析出。加入Y后,非晶合金的晶化开始温度和晶化峰值温度都向高温方向移动,证明其热稳定性提高。Y的加入改变了合金的晶化方式和最终晶化产物,使非晶基体中析出的晶化相更加弥散圆整细小。并且Y具有在化学上钝化氧杂质的作用,从而抑制了氧的有害作用。利用Kissinger方程获得了Nd60Fe20Al10Ni8Y2非晶合金的晶化开始和晶化峰值激活能分别为1.21和1.16 eV。     

水煤浆添加剂与煤之间的相互作用规律研究 Ⅰ. 复合煤颗粒间的相互作用对水煤浆流变性的影响

使用12种不同分散剂对14种不同变质程度的煤进行了成浆性实验，分析了182个水煤浆(CWS)样品的流变性。结果表明，低变质程度和高灰煤浆多呈屈服假塑性，煤的性质起主导作用；变质程度高且灰分较低煤浆的流变性，主要依赖于分散剂的结构与性质；分子结构单元立体空间效应大，疏水基团与亲水基团呈立体间隔分布的分散剂，易形成屈服假塑性CWS；分子线度长，亲水基团与疏水基团呈线性间隔分布的分散剂，易形成胀塑性CWS。复合煤粒间的相互作用方式是决定CWS流变特性的关键。     

1,2-丁二醇共聚对聚对苯二甲酸乙二醇酯结晶行为及力学性能的影响

为了探索生物基乙二醇中的1,2-丁二醇(1,2-BDO)作为共聚单体对生物基聚对苯二甲酸乙二醇酯(PET)的结晶行为和力学性能的影响。 本文合成了生物基PET均聚物和不同1,2-BDO共聚单元摩尔分数的系列生物基PET共聚物(共聚单体摩尔分数分别为2.0%、2.7%和5.6%),并采用傅里叶变换红外光谱仪(FTIR)、差示扫描量热仪(DSC)和力学测试等技术手段研究了其结晶行为和力学性能。 结果表明,随着1,2-BDO共聚单元摩尔分数的增加,PET共聚物的熔融温度、结晶速率及结晶度均明显降低,表明1,2-BDO共聚单体的引入破坏了PET分子链的规整性,阻碍了PET链段的结晶。 PET材料的拉伸强度随着1,2-BDO共聚单元摩尔分数的增加而降低,而弯曲强度和弯曲模量略有升高。     

压力流驱动电色谱分析方法及其若干色谱行为

压力流驱动电色谱分析方法是一种新型色谱技术。它组合了ＨＰＬＣ和电泳两种技术，为分离提供了更多可控制的因素。介绍了压力流驱动电色谱的装置和毛细管电色谱柱的装置方法，从理论上讨论了影响电色谱分离的因素并用实验数据加以证明。最后尝试性地将电色谱法用于测定香蕉样品中萨索啉（Ｓａｌｓｏｌｉｎｏｌ）等的含量。     

Determination of methylated dibenzothiophenes in environmental sarnples by on-line HPLC-CGC

Concurrent solvent evaporation with a loop-type interface was used for on-line HPLC-CGC in the analysis of methylated dibenzothiophene (DBT) isomers in oil samples. The chromatographic behavior of 20 methyl DBT's was studied by HPLC on an aminopropylsilane DBTA phase and by GC on a selective methyl-phenylsilicone phase. That provided a method for analyzing by GC-flame photometric detection, the individual components of the DBT family, previously picked out of the crude oil matrix by HPLC. The GC oven temperature was shown to be critical during HPLC eluent introduction into the GC pre-column. Too high a temperature induced a severe broadening of early eluted peaks whereas a temperature too close to the boiling point of the liquid at the inlet pressure induced double peaks. Optimized conditions were retained on this basis and may be used for the analysis of other families of polyaromatic hydrocarbons.     

常压升温下油煤浆表观黏度变化的研究

为探讨煤直接液化工艺中油煤浆表观黏度随温度升高的变化规律，利用高温黏度计测定了煤浆体系的黏度，考察了溶剂、煤浆浓度、煤中含水量和不同显微组分等因素以及剪切速率、配浆温度、溶胀作用等对煤浆黏度 温度特性的影响。研究结果表明，低温下影响煤浆黏度变化的主要因素是溶剂本身的性质，煤浆的表观黏度随温度升高而降低；随温度继续升高在较宽温度范围内黏度变化不大，这是由溶剂性质以及煤在溶剂中的溶胀行为共同作用的结果；当温度达到约220℃后继续升高温度溶胀作用逐渐占优势，从而导致煤浆体系的表观黏度逐渐增大。     

Synthesis, Crystal Structure and Inhibition of the K562 Cell Proliferation of N＇-Tertbutylaminocarbonyl-N-2-chlorophenoxyacetylthiourea

The title compound N'-tert-butylaminocarbonyl-N-2-chlorophenoxyacetylthiou- rea has been synthesized for the first time. Complete assignments were achieved by IR, 1H NHR and single-crystal X-ray diffraction analyses. The inhibitory rate of the cellular growth of K562 cells (chronic myeloid 1eukemic cells) was measured using MTT [3-(4,5-dimethylthiazo-2-y1)-2,5-di- phenyltetra-zolium bromide] assay. The cell apoptosis was assessed by agarose gel electrophoresis to find that the title compound has antiproliferation and apoptosis inducing effects on K562 cells. In order to investigate the relationship between structure and activity of the target compound, we report its crystal structure and biological behavior in the present paper. Crystallographic data: C14H18- ClN3O3S, Mr = 343.82, orthorhombic, space group Pnma, a = 19.786(6), b = 6.789(2), c = 12.938(4) , V = 1738.0(9) 3, Z = 4, Dc = 1.314 g/cm3, F(000) = 720, μ(MoKα) = 0.354 mm-1, R = 0.0378 and wR = 0.0941. The molecule is a planar structure.     

苯并噁嗪中间体/蛭石插层纳米复合物热固化行为的研究

通过对双酚A型苯并嗪中间体 (BOZ A) 蛭石插层纳米复合物固化过程的分析表明长链烷基铵阳离子对BOZ A的热开环聚合反应没有表现出催化作用 ,也不影响纳米复合物的结构形态 .不同蛭石含量的插层纳米复合物 ,在形成不同纳米分散状态的纳米复合物的过程中 ,蛭石晶片对BOZ A的热开环聚合具有明显不同的阻碍作用 ,蛭石含量为 3%的插层纳米复合物 16 0℃的凝胶化时间较纯树脂延长约 7min ,活化能升高约8kJ mol,固化反应热焓降低约 14J g ,使得固化物的固化程度较纯树脂降低约 7%～ 10 % ,阻碍作用最大 ,其它含量的次之     

Gas chromatographic and mass spectrometric characterization of isomeric alkylthiophenes (C20) and their occurrence in deep sea sediments

Six isomeric C₂₀ alkylthiophenes were synthesized in order to prove the occurrence of such compounds in various deep sea sediments. As expected from the analogy with the corresponding saturated hydrocarbons, 2- and 3-heptadecylthiophene have considerably longer relative retention times than the isomeric isoprenoid compounds, i.e. 2- and 3-(4,8,12-trimethyltridecyl)thiophene and 3- and 4-methyl-2-(3,7,11-trimethyldodecyl)thiophene. Covats retention indices for all compounds were determined by isothermal analysis at 190°C on two different silicone-coated capillary columns. The mass spectra of the monoalkylated thiophenes show a base peak at m/z 98 corresponding to a Mcafferty rearrangement product in the case of the 3-substituted isomers, whereas a simple benzylic cleavage dominates in the mass spectra of 2-alkylthiophenes. 4-Methyl-2-(3,7,11-trimethylodecy)thiophene is an exception from this simple rule because also shows the McLafferty rearrangement as dominant fragmentation. Two of the isoprenoid thiophenes are prominent compounds in various deep sea sediments.