Study on the Baryon State X Produced in the Process J／ψ→p＋X,X→p＋P

The decay process J/ψ→p X X→p P，where p,p and P are the proton,antiproton and pseudoscalar states,respectively,has been studied in terms of the angular distribution and the generalized moment analysis methods.The result shows that we can identify the spin,but cannot determine the parity of the baryon resonance state X produced in the process J/ψ→p X X→p P.     

Mode beating in spot-size converter lasers

An anomalous modulation in the wavelength spectrum has been observed in lasers with spot-size converters. This intensity modulation is shown to be caused by beating between the fundamental lasing mode and radiation modes in the taper. This results in a periodic modulation in the net gain spectrum, which causes wavelength jumps between adjacent net gain maxima, and a drive current dependent spectral width that is expected to affect system performance. The amplitude of this spectral modulation is reduced significantly by either using an angled rear-facet which reflects the beating radiation modes away from the laser axis, or by using a nonlinear, adiabatic taper.     

分置式斯特林制冷机失效分析

斯特林制冷机是红外探测器组件中一个关键的组成部分。目前我国斯特林制冷机的性能指标与国外同类产品差距缩短 ,但可靠性问题一直没有很好解决。文中介绍了斯特林制冷机的原理、双活塞对动型分置式斯特林制冷机的结构特点及表征参数 ;通过对产品研制开发过程中成品率低的原因分析 ,揭示了主要失效机理 ,对改进工艺和设计起到了参考和指导作用。     

狭缝式高速摄影机胶片的计算机判读

根据狭缝摄影机胶片的成象原理,运用数字图象处理技术,对狭缝式高速摄影机胶片判读工作的计算机化进行研究.应用结果表明,该技术先进实用,极大地提高了判读的精度和效率,将是这种胶片判读技术的发展方向.     

基于频域方法的三维物体分层重现

基于频域方法实现了数字记录和再现三维物体离轴全息图.通过频谱对应关系求得各个面的频谱分布,使用数字滤波方法,成功地消除了零级衍射和共轭像;通过改变再现距离,分别获取了三维物体各个截面的再现像.     

上海基础房价相关指标及走势的分析与研究

基础房价的相关指标及其走势一直是大众关心的热门话题．本文通过对上海基础房价相关指标的分析，建立了市场房价走势的两个数学模型．模型一：在相关性分析的基础上利用主成分分析消除指标间的共线性，再用回归拟合房价模型并进行预测；模型二：在相关性分析的基础上利用核估计方法预测出房价．继呵对2005年下半年的房价走势进行了预测，得出的结果与实际情况相吻合．     

Ion implantation induced by Cu ablation at high laser fluence

High energy laser plasma-produced Cu ions have been implanted in silicon substrates placed at different distances and angles with respect to the normal to the surface of the ablated target. The implanted samples have been produced using the iodine high power Prague Asterix Laser System (PALS) using 438 nm wavelength irradiating in vacuum a Cu target. The high laser pulse energy (up to 230 J) and the short pulse duration (400 ps) produced a non-equilibrium plasma expanding mainly along the normal to the Cu target surface. Time-of-flight (TOF) technique was employed, through an electrostatic ion energy analyzer (IEA) placed along the target normal, in order to measure the ion energy, the ion charge state, the energy distribution and the charge state distribution. Ions had a Boltzmann energy distributions with an energy increasing with the charge state. At a laser fluence of the order of 6 × 10⁶ J/cm², the maximum ion energy was about 600 keV and the maximum charge state was about 27+.In order to investigate the implantation processes, Cu depth profiles have been performed with Rutherford backscattering spectrometry (RBS) of 1.5 MeV helium ions, Auger electron spectroscopy (AES) with 3 keV electron beam and 1 keV Ar sputtering ions in combination with scanning electron microscopy (SEM). Surface analysis results indicate that Cu ions are implanted within the first surface layers and that the ion penetration ranges are in agreement with the ion energy measured with IEA analysis.     

Experimental identification of physical parameters of fluid-filled pipes using acoustical signal processing

A method is formulated for the identification of an unknown physical parameter of a fluid-filled pipe using the measurement of sound speed in the pipe. The method uses a simple formula which provides the relationship between the sound speed and a few physical parameters of the pipe: thickness, diameter, wall material constants and fluid constants. Once the sound speed in the pipe is measured, the simple formula can be used to extract one of the unknown parameters providing the remaining ones are known.The sound speed in the pipe is measured using a 3-transducer array. In order to demonstrate the potential of the technique the results of several measurements obtained in a water-filled steel pipe are presented.The required accuracy of the measurement of sound speed and of the specification of known parameters is analysed. The accuracy depends on the unknown parameter which is to be identified. For example, if the pipe thickness is the unknown parameter, the other parameters have to be known within a very narrow margin of error. On the contrary, if the fluid properties have to be identified the needed accuracy of known parameters gets much lower.     

Application of x-ray fluorescence analysis to investigation of the composition of gunshot residues

We have used x-ray fluorescence analysis to study the elemental composition of gunshot residues from smooth-bore and rifled-bore guns. We have established that it is possible to differentiate between types of projectiles (jacketed/lead), types of primers (corrosive/noncorrosive), and types of propellant powders (black/smokeless) by analysis of the elemental composition of the gunshot residues. We have shown that the mercury content in gunshot residues on the surface of the object carrying the residues steadily decreases as storage time increases. Despite this fact, mercury can be preserved as a component of gunshot residues on the object (cotton cloth) under room conditions for more than 45 days. __________ Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 73, No. 3, pp. 320–325, May–June, 2006.     

Synthesis and structures of nitroxyalkyl methylphosphonates

The reactions of ethylene glycol mononitrate and glycerol 1,3-dinitrate with methylphosphonic dichloride afforded new nitroxyalkyl methylphosphonates.