Preparation and properties of water‐absorbent composites of chloroprene rubber,starch, and sodium acrylate

The effects of the amounts of starch, sodium acrylate (NaAA) and dicumyl peroxide (DCP) on the properties of chloroprene rubber (CR)/starch/NaAA composites prepared by melting method were investigated. The results showed that the addition of starch improved the mechanical properties, but decreased the water‐absorbing capacity of the composite, most likely due to the decrease in the local concentration of the main water‐absorbing material sodium polyacrylate and the increase in crosslinking density of the composite resulting from the reaction between starch and CR. This reaction was verified by the vulcanized curves, DSC curves, and the cut surface morphology. The as‐prepared composite demonstrated higher water‐absorbing capacity, resulting from the incorporation of NaAA. The mechanical properties decreased with increasing the DCP loading, and the water‐absorbing ratio is the maximum at 1.0 phr DCP. The tensile strength of the composite decreased significantly after water immersion, due to the absorbed water acting as a plasticizer. The extracted component from composites after water immersion is mainly sodium polyacrylate according to Fourier transform infrared (FT‐IR) spectroscopy analysis. The morphology of the composites before and after water immersion was observed by optical transmission microscopy (OTM). The results indicated that the starch exhibits a good dispersion state, and the water‐absorbing capacity results primarily from sodium polyacrylate. Copyright © 2010 John Wiley & Sons, Ltd.     

High‐Performance Magnetic Refrigerant Featuring One‐Dimensional Gd‐O Chains and O‐Gd3 Triangles

Magnetic cooling at low temperature has attracted intensive interest in cryogenics research, which may become important as cooling medium for long‐wave photon detectors to support space exploration. Here, we report a Gd‐based quaternary magnetic refrigerant material, Gd₅BSi₂O₁₃, containing chains of face‐shared GdO₉ polyhedra and geometrically frustrated OGd₃ triangles. Magnetic measurements indicate that Gd₅BSi₂O₁₃ exhibits a large magnetocaloric effect (MCE) about 1.74 times that of the practical magnetic refrigerant GGG (−ΔS_m=67.0 J kg⁻¹ K⁻¹). We analyzed the origin of the large MCE by comparing Gd^III‐containing compounds with different structures and concentrations of Gd^III.     

Electrochemical reductive dehalogenation of chlorobenzenes

Electrochemical dechlorination of 1,2,3,5-tetrachlorobenzene in methanol and chlorobenzene in dimethylsulfoxide with tetraalkylammonium salts as supporting electrolytes was carried out. The extent of dechlorination depends significantly on the electrode composition.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 6, pp. 1129–1133, June, 1995.     

Some Electrochemical Characteristics of Boron‐ and Phosphorus‐Doped Glassy Carbon Electrodes

Three glassy carbon (GC) samples: undoped and doped with boron or phosphorus, prepared at 1000 °C, were compared in respect to hydrodynamic current‐potential curves in acidic medium, cyclic voltammograms for Fe^3+/2+ and Fe(CN)₆^3?/4? and argentometric titrations of halides. Some experiments were also carried out using standard Tokai and Sigri GC and Ag electrode. It appeared that GC doped with boron and phosphorus exhibited significant increase in hydrogen evolution overpotential. As for the electrode kinetics (ΔE_p criterion), no significant difference was observed between doped and undoped electrodes. In the potentiometric titrations the phosphorus‐doped electrode was advantageous over the other GC and Ag electrodes as it enabled more precise end‐point detection.     

An investigation of microbore reverse-phase columns containing 3 μm packing materials

A procedure for packing 15 cm × 1 mm id reverse-phase microbore columns with 3 μm silicas obtained from different manufacturers is described. The speed of analysis and detection limits are compared to those obtained with a 50 cm × 1 mm id column packed with 10 μm ODS. The effect of detector time constant on the system, and flow rates on column efficiency are also examined.     

Heterotermetallic Indium Lithium Halostannates: Low‐Temperature Single‐Source Precursors for Tin‐Rich Indium Tin Oxides and Their Application for Thin‐Film Transistors

The syntheses and structural elucidation of dimeric [Sn(OCyHex)₂] ( 1 ), its corresponding (cyclohexoxy)alkalistannates(II) [{M(OCyHex)₃Sn}₂] (M=Li ( 2 ), Na ( 3 ), K ( 4 )), and of the first heteroleptic heterotermetallic Li/In/Sn–haloalkoxide clusters [X₂In{LiSn₂(OCyHex)₆}] (X=Br ( 5 ), Cl ( 6 )) with a double seco‐norcubane core are reported. They represent suitable precursors for new amorphous indium tin oxide (ITO) materials as transparent conducting oxides with drastically reduced concentrations of expensive indium, while maintaining their high electrical performance. In fact, compounds 5 and 6 were successfully degraded under dry synthetic air at relatively low temperature, resulting in new semiconducting tin‐rich ITOs homogeneously dispersed in a tin oxide/lithium oxide matrix. The obtained particles were investigated and characterised by different analytical techniques, such as powder XRD, IR spectroscopy, SEM, TEM and energy‐dispersive X‐ray spectroscopy (EDX). The analytical data confirm that the final materials consist of tin‐containing indium oxide embedded in an amorphous tin oxide matrix. The typical broadening and shift of the observed indium oxide reflections to higher 2θ values in the powder XRD pattern clearly indicated that tin centres were successfully incorporated into the In₂O₃ lattice and partially occupied In³⁺ sites. Investigations by EDX mapping proved that Sn was homogeneously distributed in the final materials. Thin‐film field‐effect transistors (FETs) were fabricated by spin‐coating of silicon wafers with solutions of 5 in toluene and subsequent calcination under dry air (25–700 °C). The FETs prepared with precursor 5 exhibited excellent performances, as shown by a charge‐carrier mobility of 6.36×10^?1 cm² V^?1 s (calcination at 250 °C) and an on/off current ratio of 10⁶.     

Intracrystalline Diffusion in Mesoporous Zeolites

Specially synthesized extra‐large crystallites of zeolite LTA with intentionally added mesoporosity are used for an in‐depth study of guest diffusion in hierarchical nanoporous materials by the pulsed field gradient NMR technique. Using propane as a guest molecule, intracrystalline mass transfer is demonstrated to be adequately described by a single effective diffusivity resulting from the weighted average of the diffusivities in the two (micro‐ and meso‐) pore spaces. Gas‐kinetic order‐of‐magnitude estimates of the diffusivities are in satisfactory agreement with the experimental data and are thus shown to provide a straightforward means for predicting and quantifying the benefit of hierarchically structured nanoporous materials in comparison with their purely microporous equivalent.     

Host (nanopores of zeolite-Y)/guest (Co(II)-azamacrocyclic complexes) nanocomposite materials: synthesis,characterization and catalytic epoxidation of styrene with molecular oxygen

A series of Co(II) azamacrocyclic complexes, 12 Brunel, D, Bellocq, N, Sutra, P, Cauvel, A, Lasperas, M, Moreau, P, Di Renzo, F, Galarneau, A and Fajula, F. 1998. Coord. Chem. Rev., 178–180: 1085[Crossref], [Web of Science ®] , [Google Scholar]aneN₄, 14 De Vos, DE, Dams, M, Sels, BF and Jacobs, PA. 2002. Chem. Rev., 102: 3615[Crossref], [PubMed], [Web of Science ®] , [Google Scholar]aneN₄, Bzo₂ 12 Brunel, D, Bellocq, N, Sutra, P, Cauvel, A, Lasperas, M, Moreau, P, Di Renzo, F, Galarneau, A and Fajula, F. 1998. Coord. Chem. Rev., 178–180: 1085[Crossref], [Web of Science ®] , [Google Scholar]aneN₄ and Bzo₂ 14 De Vos, DE, Dams, M, Sels, BF and Jacobs, PA. 2002. Chem. Rev., 102: 3615[Crossref], [PubMed], [Web of Science ®] , [Google Scholar]aneN₄, have been encapsulated in the nanocavity of zeolite-Y by a one pot template condensation reaction. Co(II) complexes with azamacrocyclic ligands were entrapped in the nanocavity of zeolite-Y by a two-step process in the liquid phase: (i) adsorption of [bis(diamine)cobalt(II)], [Co(N–N)₂]-NaY, in the supercages of the zeolite, and (ii) in situ condensation of the cobalt(II) precursor complex with diethyloxalate. The new host/guest nanocomposite materials (HGNM) have been characterized by FTIR, DRS and UV-Vis spectroscopic techniques, XRD and elemental analysis, as well as nitrogen adsorption. These complexes (neat and HGNM) were used for epoxidation of styrene with O₂ as oxidant in different solvents. Electronic spectra of the reaction mixture indicated oxidation proceeds through a free radical mechanism.     

The Reagent‐depending Nitration of 1,3‐Dihydroxyacetone Dimer

Two highly energetic nitric acid esters were synthesized from the dimer of dihydroxyacetone. 1,3‐Dinitratoacetone ( 1 ) and its dimer 2,5‐bis(nitratomethyl‐2,5‐nitrato)‐1,4‐dioxane ( 2 ) were characterized by single‐crystal X‐ray diffraction, vibrational spectroscopy (IR and Raman), multinuclear NMR spectroscopy, and elemental analysis. The thermal behavior was investigated with DTA measurements. Although showing the same atomic stoichiometry, dimer 2 shows significantly higher sensitivities measured by BAM methods (drophammer and friction tester). Due to the high oxygen content of 62.2 %, 1 and 2 were evaluated as potential high energy dense oxidizers.