Quantitation of memantine hydrochloride bulk drug and its tablet formulation using proton nuclear magnetic resonance spectrometry

The use of quantitative nuclear magnetic resonance spectrometry for the determination of non‐UV active memantine hydrochloride with relative simplicity and precision has been demonstrated in this study. The method was developed on a 500 MHz NMR instrument and was applied to determination of the drug in a tablet formulation. The analysis was performed by taking caffeine as an internal standard and D₂O as the NMR solvent. The signal of methyl protons of memantine hydrochloride appeared at 0.75 ppm (singlet) relative to the signal of caffeine (internal standard) at 3.13 ppm (singlet). The method was found to be linear (r² = 0.9989) in the drug concentration range of 0.025 to 0.80 mg/ml. The maximum relative standard deviation for accuracy and precision was <2. The limits of detection and quantification were 0.04 and 0.11 mg/ml, respectively. The robustness of the method was revealed by changing nine different parameters. The deviation for each parameter was also within the acceptable limits. The study highlighted possibility of direct determination of memantine hydrochloride in pure form and in its marketed tablet formulation by the use of quantitative NMR, without the need of derivatization, as is the requirement in HPLC studies. Copyright © 2016 John Wiley & Sons, Ltd.     

Cross‐linked poly(aryl ether sulfone) membranes for direct methanol fuel cell applications

Partially sulfonated poly(aryl ether sulfone) (PESS) was synthesized and methacrylated via reaction with glycidyl methacrylate (PESSGMA) and cross‐linked via radical polymerization with styrene and vinyl‐phosphonic acid (VPA). The chemical structures of the synthesized pre‐polymers were characterized via FTIR and ¹H NMR spectroscopic methods and molecular weight was determined via GPC. Membranes of these polymers were prepared via solution casting method. The crosslinking of the PESS polymer reduced IEC, proton conductivity, swelling in water, and methanol permeability of the membranes while increasing the modulus and the glass transition temperature. However, the introduction of the VPA comonomer increased the proton conductivity while maintaining excellent resistance to methanol cross‐over, which was significantly higher as compared with both PESS and the commercial Nafion membranes. Membranes of PESSGMA copolymers incorporating VPA, exhibited proton conductivity values at 60 °C in the range of 16–32 mS cm⁻¹ and methanol permeability values in the range of 6.52 × 10⁻⁹ – 1.92 × 10⁻⁸ cm² s⁻¹. © 2018 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2018 , 56, 558–575     

Characteristics of the magnetic analysis system for a compact MPR-type spectrometer

The magnetic proton recoil(MPR)spectrometer is a novel diagnostic instrument with high perfor-mance for measurements of neutron spectra in inertial confinement fusion(ICF)experiments and high power fusion devices.A compact MPR-type spectrometer dedicated to the research of pulsed deuterium-tritium(DT)neutron spectroscopy of special experimental conditions is currently under design.Analyses of the main parameters and performance of the magnetic analysis system through 3-D particle transport calculations and MonteCarlo simulations and calibration of the system performance as a test using CR-39 solid track detector and α particle from 239pu and 226Ra radioactive sources are presented in this paper.The results indicate that the magnetic analysis system will achieve a detection efficiency level of 10-5-10-4 at an energy resolution of 1.5%-2.1%,and fulfills the design goals of the spectrometer.     

Determination of MLN0128, an investigational antineoplastic agent,in human plasma by LC–MS/MS

MLN0128, an mTOR kinase inhibitor, is currently undergoing clinical investigation for treatment of a variety of cancers. To support this work, an LC–MS/MS method has been developed for the determination of MLN0128 in human plasma. A structural analog STK040263 was used as the internal standard. Both MLN0128 and the IS were first extracted from plasma using methyl tert ‐butyl ether; then separated on a Waters XTerra® MS C₁₈ column using a mobile phase consisting of methanol–acetonitrile–10.0 mm ammonium formate (34:6:60, v /v/v) at a flow rate of 0.300 mL min⁻¹. Quantitation of MLN0128 was done by positive electrospray ionization tandem mass spectrometry in multiple‐reaction‐monitoring mode. This method has a total run time of <4 min with the retention times of 1.95 and 2.94 min for the IS and MLN0128, respectively. The method has been validated per the US Food and Drug Administration guidance for bioanalytical method validation. It has a calibration range of 0.100–50.0 ng mL⁻¹ in human plasma with a correlation coefficient > 0.999. The overall assay accuracy and precision were ≤ ± 4 and ≤8%, respectively. The IS normalized recovery of MLN0128 was 98–100%. The stability studies showed that MLN0128 was stable under all tested conditions. The method developed may be useful for clinical studies of MLN0128.     

Sensitive and specific LC‐ESI‐MS/MS method for determination of ZYDPLA1, a novel long‐acting dipeptidyl peptidase 4 inhibitor in rat plasma: An application for toxicokinetic study in rats

A rapid and highly specific assay was developed and validated for the estimation of ZYDPLA1 in rat plasma using liquid chromatography coupled to tandem mass spectrometry with positive electrospray ionization. Method validation comprised of parameters such as specificity, matrix effect, precision, accuracy, recovery, stability, etc. The assay procedure involved a simple protein precipitation of ZYDPLA1 and alprazolam (internal standard) from rat plasma using acetonitrile. Chromatographic separation was achieved with a gradient mobile phase comprising: (A) 0.2% ammonia in purified water; (B) 0.1% formic acid in isopropyl alcohol/methanol (1: 1 v /v); and (C) acetonitrile at a flow rate of 1 mL/min on an ACE‐5, C18 (4.6 × 50 mm) column with a run time of 5.5 min. The quantitation of ZYDPLA1 was achieved by the summation of four multiple reaction mode transitions (m/z 399.7 → 383.0, 399.7 → 276.10, 399.7 → 153.20 and 399.7 → 127.20), while that of the internal standard was by a single multiple reaction mode transition (m/z 309.10 → 281.00). The lower limit of quantitation achieved was 0.01 μg/mL and the method showed linearity from 0.01 to 25 μg/mL. The intra‐ and inter‐day precision (%CV) of the quality control samples was within 8.81% and accuracy was ±10% of nominal values. This novel method was applied for evaluation of toxicokinetics of ZYDLA1 in rats.     

Polyelectrolyte Nanocomposite Membranes Using Imidazole-Functionalized Nanosilica for Fuel Cell Applications

The preparation and characterization of a new type of nanocomposite polyelectrolyte membrane, based on DuPont Nafion/imidazole-modified nanosilica (Im-Si), for direct methanol fuel cell applications is described. Related to the interactions between the protonated imidazole groups, grafted on the surface of nanosilica, and negatively charged sulfonic acid groups of Nafion, new electrostatic interactions can be formed in the interface of Nafion and Im-Si which result in both lower methanol permeability and also higher proton conductivity. Physical characteristics of these manufactured nanocomposite membranes were investigated by scanning electron microscopy, thermogravimetry analysis, differential scanning calorimetry, Fourier transform infrared spectroscopy, water uptake, methanol permeability, and ion-exchange capacity, as well as proton conductivity. The Nafion/Im-Si membranes showed higher proton conductivity, lower methanol permeability and, as a consequence, higher selectivity parameter in comparison to the neat Nafion or Nafion/silica membranes. The obtained results indicated that the Nafion/Im-Si membranes could be utilized as promising polyelectrolyte membranes for direct methanol fuel cell applications.     

Electron Transfer between Hydrogen‐Bonded Pyridylphenols and a Photoexcited Rhenium(I) Complex

Two pyridylphenols with intramolecular hydrogen bonds between the phenol and pyridine units have been synthesized, characterized crystallographically, and investigated by cyclic voltammetry and UV/Vis spectroscopy. Reductive quenching of the triplet metal‐to‐ligand charge‐transfer excited state of the [Re(CO)₃(phen)(py)]⁺ complex (phen=1,10‐phenanthroline, py=pyridine) by the two pyridylphenols and two reference phenol molecules is investigated by steady‐state and time‐resolved luminescence spectroscopy, as well as by transient absorption spectroscopy. Stern–Volmer analysis of the luminescence quenching data provides rate constants for the bimolecular excited‐state quenching reactions. H/D kinetic isotope effects for the pyridylphenols are on the order of 2.0, and the bimolecular quenching reactions are up to 100 times faster with the pyridylphenols than with the reference phenols. This observation is attributed to the markedly less positive oxidation potentials of the pyridylphenols with respect to the reference phenols (≈0.5 V), which in turn is caused by proton coupling of the phenol oxidation process. Transient absorption spectroscopy provides unambiguous evidence for the photogeneration of phenoxyl radicals, that is, the overall photoreaction is clearly a proton‐coupled electron‐transfer process.     

燃料电池铂钴锰合金催化剂的制备及性能

为提高PtCo/C合金催化剂的电化学性能,采用微波法合成铂钴锰催化剂前驱体,经高温热处理形成合金,最后通过酸处理得到铂钴锰合金催化剂(PtCoMn/C)。电化学测试结果表明:适量锰的添加可提升PtCo/C催化剂的活性和耐久性。PtCoMn/C催化剂在 0.9 V(vs RHE)电压下的质量比活性(MA)达到 0.666 A·mg_Pt^-1,是传统 Pt/C 的 2.66 倍,是 PtCo/C 催化剂的 1.30 倍。在30 000圈催化剂加速耐久性测试中,PtCoMn/C合金催化剂的电化学活性面积(ECSA)和质量比活性(MA)仅下降6.9%和27.1%,均远低于Pt/C催化剂。     

钒液流电池用隔离膜研究进展

钒液流电池是近年来发展最为迅猛的储能电池之一。隔膜作为钒电池的重要组成部分直接关系到钒电池的转化储能效率和使用寿命。本文综述了近年来钒电池用隔离膜的发展现状。全氟磺酸质子交换膜(Nafion膜)作为当前使用最为广泛的隔膜,从传导机理、交换机理和表面涂覆、交联、复合等表面改性技术方面入手做了深入的研究,并对比分析了各种改性方法的优缺点。对磺化的特种工程塑料为主的非氟耐热型质子交换膜和功能化的聚烯烃隔膜在钒电池中的当前进展做了全面总结,并对钒液流电池用电池隔膜的发展方向做了展望。     

The role of benzoic acid in proline‐catalyzed asymmetric michael addition: A density functional theory study

In asymmetric Michael addition between ketones and nitroolefins catalyzed by L ‐proline, we observed that it was benzoic acid or its derivatives rather than other proton acid that could accelerate the reaction greatly, and different benzoic acid derivatives brought different yields. To explain the experimental phenomena, a density functional theory study was performed to elucidate the mechanism of proline‐catalyzed asymmetric Michael addition with benzoic acid. The results of the theoretical calculation at the level of B3LYP/6‐311+G(2df,p)//B3LYP/6‐31G(d) demonstrated that benzoic acid played two major roles in the formation of nitroalkane: assisting proton transfer and activating the nitro group. In the stage of enamine formation from imine, the energy profiles of benzoic acid derivatives were also calculated to investigate the reasons why different benzoic acid derivatives caused different yields. The results demonstrated that the pK_a value was the major factor for p‐substituted benzoic acid derivatives to improve the yields, whereas for m/o‐substituted benzoic acid derivatives, both pK_a value and electronic and steric effects could significantly increase the yields. The calculated results would be very helpful for understanding the reaction mechanism of Michael addition and provide some insights into the selection of efficient additives for similar experiments. © 2012 Wiley Periodicals, Inc.