丙烯环氧化制环氧丙烷Fe-Al-P-O催化剂的研究

用溶胶-凝胶法制得了Fe-Al-P-O催化剂，采用IR、XRD、TEM、BET、TPR和微反等技术研究了催化剂的物化性质和反应性能。实验结果表明，Fe1/2-Al1/2-PO4由10 nm左右 FePO4和AlPO4微晶组合而成，其晶格氧的活泼性大于单纯FePO4，AlPO4在Fe1/2-Al1/2-PO4中起到分散FePO4微晶的作用；Fe1/2-Al1/2-PO4的反应性能与原料气组成密切相关，丙烯与O2的选择氧化产物主要是丙烯醛，原料气中加入H2后，反应产物以环氧丙烷为主，同时还有部分丙烯醛，原料气中引入水蒸气后，可进一步增加环氧丙烷的选择性及减少丙烯醛的产率；在0.1 MPa、200 ℃、C3H6/O2/H2/H2O/N2=1∶1∶1∶1∶6（mol比）和空速1 200 h－1条件下，丙烯的转化率为8.9％，环氧丙烷的选择性为81.0％。     

Effect of the extent of reduction of V2O5 on the adsorption of propylene and the oxidative dehydrogenation of propane to give propylene on V2O5 and V2O5/TiO2-SiO2

An increase in the propylene output in the oxidative dehydration of propane on V₂O₅/TiO₂-SiO₂ was observed after prior reduction of V₂O₅ in the reaction mixture to V₂O₄, which reduces the destructive chemisorption of propylene. A low titanium dioxide content in TiO₂-SiO₂ hinders the deep reduction of V₂O₅ to V₂O₃, which reduces the conversion of propane. __________ Translated from Teoreticheskaya i éksperimental’naya Khimiya, Vol. 43, No. 6, pp. 373–378, November–December, 2007.     

丙烯环氧化反应的高活性钼催化剂

在钼(Ⅵ),钒(Ⅴ)和钛(Ⅳ)等化合物存在下,丙烯与烷基过氧化氢的环氧化反应比传统的氯醇法有很多优点,其中以钼催化剂的性能最优,但目前报道的催化剂在反应过程中因易分解而降低了活性,并且丙烯与烷基过氧化氢的投料比过大(>3:1),丙烯循环次数过多。前文报道了钼烷基醇胺化合物对环已烯的环氧化反应,本文考察了钼烷基醇胺化合物对丙烯与叔丁基过氧化氢环氧化反应的催化性能。     

Ni2（OEt）2／SiO2催化二氧化碳与丙烯直接合成甲基丙烯酸的研究

 采用表面改性法制备了负载型Ni2（OEt）2／SiO2双核金属乙氧基配合物催化剂，利用示差量热、红外光谱和微反技术对催化剂的表面结构、热稳定性、化学吸附性质和催化活性进行了研究．结果表明，负载型双核金属乙氧基配合物Ni2（OEt）2／SiO2中的Ni2＋与载体SiO2表面的O2－以双齿配位形式键合；二氧化碳在催化剂表面存在桥式吸附态和碳酸单乙酯基物种两种吸附态，丙烯则只有一种分子吸附态；在适宜的反应条件下，二氧化碳和丙烯在Ni2（OEt）2／SiO2催化剂上的反应产物主要是甲基丙烯酸．根据实验结果，提出了二氧化碳和丙烯在Ni2（OEt）2／SiO2催化剂表面的反应机理，反应物分子共吸附于催化剂表面同一活性单元上，羧酸根和丙烯解离吸附态的形成是反应顺利进行的关键步骤．     

马来酸酐封端聚碳酸亚丙酯的大分子偶联反应

自从 1 969年井上祥平[1] 发现二氧化碳 (CO2 )可以同环氧化合物直接共聚合成脂肪族聚碳酸酯(APC)以来 ,这一学科领域受到科学家的广泛关注[2～ 8] .这是因为CO2 所产生的温室效应 ,成为使全球变暖的主要因素[9,10 ] .已经确定CO2 使气侯变暖占诸多因素中的 66% .目前大气中CO2 的体积浓度为 345ppmv,由于人类的各类活动每年以 1ppmv的速度递增 .因此 ,降低CO2 排放量已成为全人类共同关注的热点之一 .另一方面 ,CO2 的固定化以及消耗、利用显然是一个应积极鼓励的研究课题 .目前人们已经将CO2 同环氧乙烷 (EO)、环氧丙烷 (PO)、环…     

Heptane-soluble homogeneous zirconocene catalyst: Synthesis of a single diastereomer,polymerization catalysis,and effect of silica supports

Bis(1-indenyl)-di[1′S, 2′R, 5′S)-methoxy]silane ( 1 ) was converted into a mixture of corresponding ansa-diastereomeric zirconocenes. Further purification afforded a single dia-stereomer, di[(1′S, 2′R, 5′S)-methoxy] silylene-bis[η⁵-1(R, R)-(+)-indenyl] dichlorozirconium ( 2 ), which is optically active and hydrocarbon soluble. Extremely rapid ethylene, propylene, and ethylene-hexene polymerizations were observed both in toluene and n-heptane solutions; for instance, at 50°C, activity for ethylene polymerization reaches ～ 1.5×10¹⁰ (g of PE/((mol of Zr) · [C₂H₄] · h). The “bare” zirconocenium ion generated from 2/TIBA/Ph₃CB(C₆F₅)₄ exhibits unusual polymerization behaviors; the polymerization activity increases monotonically with temperature of polymerization (T_p) up to a conventional polymerization condition (50–70°C), and the ¹³C NMR study shows that the isotactic poly-propylene obtained has fairly high [mmmm] methyl pentad distributions at high T_p (?25°C with [mmmm] ～ 0.93–0.75) and a perfect stereoregularity at low T_p (?0°C with [mmmm] > 0.99). The catalyst precursors 2 and Et(Ind)₂ZrCl₂ ( 3 ) supported on silica by different approaches produced poly(olefins) of different molecular weights and stereoregularities, and a methylaluminokane and Ph₃CB(C₆F₅)₄ free silica-supported zirconocene system was found to be activated by triisobutylaluminum. © 1995 John Wiley & Sons, Inc.     

Silver(I) Complexes with Nitrogen-Containing Noncyclic, Macrocyclic, and Macrobicyclic Ligands in Propylene Carbonate

Stability constants and thermodynamic data for complex formation of silver(I) with noncyclic, macrocyclic, and macrobicyclic ligands have been measured in propylene carbonate using potentiometric and calorimetric methods. All ligands containing two nitrogen donor atoms form extremely stable complexes. Only if substituents reduce the basicity of the nitrogen donor atoms, the stability of the complexes decreases drastically. However, the cryptand (221) forms the most stable complex of all ligands examined. In this case, the dimensions of the ligand cavity and of the cation are nearly identical.     

Morphology, crystallization behavior and properties of impact-modified polypropylene copolymer with or without sodium benzoate as a nucleating agent

 The morphology, crystallization behavior, and properties of an impact-modified polypropylene (PP) copolymer with or without sodium benzoate were investigated. The contents of ethylene–propylene rubber (EPR) in the reactor-made PP copolymer is about 15 wt%. For comparison, blends of PP and EPR containing the same EPR composition were prepared by melt-mixing. Morphological studies by scanning probe microscopy indicated that the impact-modified copolymer consists of three different phases, i.e., polyethylene, PP, and EPR phases, which is considerably different from the morphology of the conventional PP/EPR blend of the corresponding composition. The impact-modified PP copolymer exhibited a higher crystallization rate in terms of the lower crystallization half-time and thus higher thermal and mechanical properties, such as impact strength and hardness, than the PP/EPR blend did. The addition of sodium benzoate as a nucleating agent to the copolymer increased the crystallization rate and the mechanical properties. Received: 4 June 2001 Accepted: 31 October 2001     

Cationic Heteroconjugation Constants in the OHN+ and NHO+ Systems in Propylene Carbonate: Dependence on Difference in Basicity

Cationic heteroconjugation equilibria of more than ninety systems consisting of substituted pyridines, their N-oxides, and trimethylamine N-oxide, i. e., in systems with mixed hydrogen bridges of type OHN⁺ (NHO⁺) were studied in propylene carbonate. Both experimental systems without proton transfer, BH⁺/B₁, and those with proton transfer, B₁H⁺/B, were explored. The stability of the mixed hydrogen bridges, OHN⁺ (NHO⁺), is compared with that of the OHC⁺-type bridges. The influence of the difference in basicity of the conjugate base of the proton donor and the proton acceptor on the presence of the proton transfer equilibria, and, consequently, the possibility of determination of the cationic heteroconjugation constant values is discussed.     

The formation of cation-ligand complexes of tributylammonium cation with diethyl carbonate,ethylene carbonate,propylene carbonate, 4-butyrolactone,ethyl acetate,and cyclopentanone ino-dichlorobenzene at 25°C

The effects of adding millimolar quantities of a series of compounds containing the carbonyl function on the conductances of solutions (0.2 mM) of tri-n-butylammonium picrate ino-dichlorobenzene solvent at 25°C have been measured. Values of the complex formation constants K ₁ ⁺ for 1:1 cation-ligand complexes are derived from these data. The corresponding values of –G ₁ ⁰ at 25°C are (in kcal-mole ^–1 ): 4-butyrolactone, 4.29; propylene carbonate, 3.87; ethylene carbonate, 3.59; cyclopentanone, 3.42; ethyl acetate, 2.84; and diethyl carbonate, 2.78. These results together with earlier results from this laboratory are discussed in terms of the effects of structure on cation-ligand affinity.