二氧化碳与丙烯直接合成甲基丙烯酸用CuPMo／TiO2催化剂的研究

 用溶胶－凝胶法以磷钼酸（MPA）的铜盐溶液水解钛酸四丁酯制备了CuPMo／TiO2催化剂，并用ICP，XRD，TG－DTA，IR，TPD－MS和微反技术研究了催化剂的化学组成、热稳定性、化学吸附性质和催化性能．结果表明：杂多钼酸盐与TiO2表面通过O2－桥发生键联．在623K下，杂多阴离子仍保持其原有的Keggin结构；CO2在Lewis酸位Cu（Ⅱ）和Lewis碱位Cu－O－Mo桥氧的协同作用下形成卧式吸附态Cu（Ⅱ）←O－（CO）←（O－－Cu）；丙烯以分子吸附态在催化剂上吸附；在空速1500h－1，压力1MPa和温度563K的反应条件下，丙烯的转化率为4．2％，甲基丙烯酸的选择性为96％．     

Gas-stirred solvent extraction with propylene carbonate for separation and direct polarographic determination of thallium (III)

Gas-stirred propylene carbonate (PC) extraction can be performed by bubbling nitrogen without loss of volume. This extraction technique has proved to be highly useful for the separation and subsequent direct polarographic estimation of Tl(III) in the recovered PC phase. Tl(III) can be determined by differential-pulse polarography over the concentration range of 0.4 10 g ml^–1 without any interferences due to most metal ions such as Pb(II), Bi(III), Cu(II), Sb(III) and As(III). This proposed technique would be possible to use as a simple extraction step prior to the final estimation by instrumental method of analysis such as atomic absorption spectrometry or spectrophtometry.     

环氧乙烷和环氧丙烷共聚体系的等温结晶和熔融

环氧乙烷（ＥＯ）和环氧丙烷（ＰＯ）共聚体系的等温结晶前期符合Ａｖｒａｍｉ方程。ＰＯ组分含量增加，Ａｖｒａｍｉ指数ｎ值由１．８到２．４，体系的结晶生长速率与共聚体系的组成和结晶度有关，ＥＯ／ＰＯ共聚体系的平衡熔点随ＰＯ含量的增加而降低。随Ｔｃ增大，△Ｈｍ与△Ｓｍ呈线性降低。     

离子液体［bmim］HSO4中合成的苯胺与环氧丙烷共聚物的电催化性能

 采用恒电流电解法,在1-丁基-3-甲基咪唑硫酸氢盐(［bmim］HSO4)离子液体中合成了苯胺与环氧丙烷共聚物(PAN-PPO). 扫描电镜观察表明, PAN-PPO由直径小于80 nm的纳米纤维组成. PAN-PPO对草酸氧化具有较好的电催化活性. 采用电化学原位红外光谱技术对草酸的电催化氧化进行了简单的分析.     

Activation of Carbon Dioxide and Synthesis of Propylene Carbonate

Cycloaddition of carbon dioxdie and propylene oxide to propylene carbonate catalyzed by tetra-tert-butyl metal phthalocyanine in the presence of tributylamine(TBA) shows higher yield than catalyzed by unsubstituted metal phthalocyanine.Comparing different catalysts of diverse metals,(t-Bu)4PcMg is more active than (t-Bu)PcFe ,But(t-Bu)4PcCo and (t-Bu)4PcNi only have low catalytic activities towards the reaction.Moreover,the yield will increase as the temperature increases.     

ZnGA-MMT catalyzed the copolymerization of carbon dioxide with propylene oxide

Zinc glutarate (ZnGA) synthesized from zinc oxide and glutarate acid was dispersed on the surface of acid-treated montmorillonite (MMT) in quinoline to prepare ZnGA-MMT catalyst. The results of X-ray diffraction (XRD) and Fourier transform infrared spectroscopy (FTIR) measurements indicated that the ZnGA on the surface of acid-treated MMT had the same crystalline structure as pure ZnGA. Copolymerization between CO₂ and propylene oxide (PO) was carried out under optimized reaction conditions using ZnGA-MMT catalyst, consequently giving poly(propylene carbonate) (PPC) with high molecular weight in a very high yield (115.2 g polymer per gram of ZnGA). The obtained PPCs were investigated using ¹³C NMR and FTIR spectra, showing a completely alternating structure. Differential scanning calorimetry (DSC) and thermogravimetric analysis (TGA) examinations showed the PPCs with a high transition temperature of 38 °C and a very high decomposition temperature (>250 °C) due to the presence of MMT residual in polymer.     

A density functional study of propylene glycol conversion to propanal and propanone of various acid-catalyzed reaction models: a water-addition effect

The acid-catalyzed models on reaction mechanisms of pinacol rearrangement of propylene glycol conversion to propanal and propanone have been investigated using the density functional method at 298.15 K. Thermodynamic quantities of activation steps of four water-addition models were obtained. The number of added water interacting with the transition states of three concerted pathways has obviously affected the product ratio. The relative energetic profiles of the conversion reactions of all solvation models have been comparatively displayed. Estimation of the percent ratio of product composition computed from activation free energies of each acid-catalyzed reaction model was carried out. The percent ratios of propanal and propanone were decreased as the number of added water increased.     

丙烯气相直接环氧化Au/TiO2催化剂的研究

在H2和O2共存条件下，金催化剂催化丙烯气相直接环氧化反应是近年来发展起来的一种新型环氧丙烷(PO)合成技术．本文采用沉积沉淀法制备了一系列Au／TiO2催化剂，考察了反应溶液的pH值、Au负载量、沉淀剂以及焙烧温度等因素对催化剂丙烯环氧化催化性能的影响．结果表明制备条件对催化性能有明显影响：反应溶液的pH值为7．5及Au负载量为2．4％时所得催化剂活性最好；当以Na2CO3、NaOH等含Na^ 物质作为沉淀剂时，催化性能明显优于Li^ 、K^ 等其它碱金属离子；400℃焙烧制得的催化剂活性较好，在50℃低温反应条件下，环氧丙烷得率可达1．3％．HRTEM结果表明，催化剂中Au组分高度分散于载体表面，且随着焙烧温度的增加Au粒因发生聚集而变大，从而影响了催化剂的活性．表面XPS分析证实，活性较好的Au／TiO2催化剂中活性组分Au除部分呈氧化态外，主要是以金属态的形式存在．