Effect of Surfactant Type and Concentration on Surfactant Migration,Surface Tension,and Adhesion of Latex Films

The effect of surfactant type and concentration on the migration behavior of surfactant in a latex film was investigated. Two types of surfactant, including an anionic (sodium lauryl sulfate, SLS) and a non-ionic (nonylphenol ethoxylate, average number of ethylene oxide units = 40, NP-40) surfactant, were used in an emulsion polymerization of methyl methacrylate butyl acrylate copolymer (MMA–BA). The total amount of surfactant was varied in three levels, i.e., 1.5, 3, and 4.5 wt%, and the surfactants were used both pure and in a mixture state. The surfactant migration to the film–air (F–A) and film–substrate (F–S) interfaces of the latex films was determined by using an attenuated total reflection-Fourier transform infrared (ATR-FTIR) method. In addition, the adhesion of the latex films to glass substrates was measured by a pull-off test. The results showed that the migration of anionic surfactant to the interfaces was greater than the non-ionic one. It was also found that the use of non-ionic surfactant along with anionic surfactant could decrease the migration of the anionic surfactant to the interfaces.     

Ti扩散铌酸锂光波导特性的热固定技术

在Ti扩散铌酸锂光波导中,因光致折变效应而导致光波导特性漂移.在光波相干性的导波光学器件中,光致折变效应的影响尤为严重.本文报道了稳定光致折变效应的热固定技术实验结果;并提出在光波导特性的热固定过程中,不是H~+离子起主导作用这一看法.     

快脉冲直线变压器驱动源模块的原理及实验

 介绍了直线型变压器驱动源（LTD）产生快脉冲的基本原理及技术优势,阐述了快脉冲LTD模块设计的要点,设计了输出脉冲上升时间小于100 ns的快脉冲LTD模块,并进行了初步的实验研究。实验得到该LTD模块充电±16 kV时,短路放电的电流峰值为23.7 kA,电流振荡1/4周期为69.6 ns;充电±50 kV驱动0.85 Ω负载时,电流峰值为41.4 kA,上升时间为36.8 ns（10%~90%）和60.8 ns（0~100%）。     

New Operator Identities and Combinatorics Studied by Virtue of IWOP Technique

Using the coherent state representation we derive some new operator identities and study some mathematical relations in combinatorics. The technique of integral within an ordered product (IWOP) of operators plays an essential role in realizing our goal.     

Fabrication of a curved linear grating by using a laser direct writer system

We present the lithography technique to fabricate a curved linear grating by using a Cartesian coordinates laser direct writer (LDW) system. The grating with the period of 15 μm is made on the convex lens surface. This is a new application of the LDW system. After the chromium coating and the photoresist removing procedures, a convex reflecting grating is obtained.     

Recent study of nanomaterials prepared by inert gas condensation using ultra high vacuum chamber

The ultra high vacuum chamber was developed in the Department of Nuclear Physics, University of Madras with the funding from DST, India. This UHV chamber is used to prepare nanocrystalline materials by inert gas condensation technique (IGCT). Nanocrystalline materials such as PbF₂, Mn²⁺-doped PbF₂, Sn-doped In₂O₃ (ITO), ZnO, Al₂O₃, Ag₂O, CdO, CuO, ZnSe:ZnO etc., were prepared by this technique and characterized. Results of some of these materials will be presented in this paper. In solid-state²⁰⁷Pb NMR on PbF₂ a separate signal due to the presence of grain boundary has been observed. The structural phase transition pressure during the phase transformation from the cubic phase to orthorhombic phase under high pressure shows an increase with the decrease in grain size. Presence of electronic centres in nanocrystalline PbF₂ is observed from Raman studies and the same has been confirmed by photoluminescence studies. Al₂O₃ was prepared and⁵⁶Fe ions were implanted. After implantation segregation of⁵⁶Fe ions was examined by SEM. The oxidation properties of ITO were studied by HRTEM. As against the expectation of oxide coating on individual nanograins of In-Sn alloy, ITO nanograins grew into faceted nanograins on heat treatment in air and O₂ atmosphere. The growth of ITO under O₂ atmosphere showed pentagon symmetry. The PMN was initially prepared by solid-state reaction. Further, this PMN relaxor material will be used to convert into nanocrystalline PMN by IGCT with sputtering and will be studied     

C,igahertz longitudinal acoustic phonons originating from ultrafast ligand field transitions in hematite thin films

The creation and propagation of longitudinal acoustic phonons （LAPs） in high quality hematite thin films （α-Fe203） epitaxially grown on different substrates （BaTiO3, SrTiO3, and LaAlO3） are investigated using the femtosecond pump- probe technique. Transient reflection measurements （AR/R） indicate the photo-excited electron dynamics, and the initial decay less than 1 ps and the slow decay of -500 ps are attributed to the electron-LO phonon coupling and electron-hole nonradiative recombination, respectively. LAPs in α-Fe2O3 film can be created by ultrafast excitation of the ligand field state, such as the ligand field transitions under 800-nm excitation as well as the ligand to metal charge-transfer with 400- nm excitation. The strain modulations of the sound velocity and the out-of-plane elastic properties are demonstrated in α-Fe2O3 film on different substrates.     

Improvement of ultrasound speckle image velocimetry using image enhancement techniques

Ultrasound-based techniques have been developed and widely used in noninvasive measurement of blood velocity. Speckle image velocimetry (SIV), which applies a cross-correlation algorithm to consecutive B-mode images of blood flow has often been employed owing to its better spatial resolution compared with conventional Doppler-based measurement techniques. The SIV technique utilizes speckles backscattered from red blood cell (RBC) aggregates as flow tracers. Hence, the intensity and size of such speckles are highly dependent on hemodynamic conditions. The grayscale intensity of speckle images varies along the radial direction of blood vessels because of the shear rate dependence of RBC aggregation. This inhomogeneous distribution of echo speckles decreases the signal-to-noise ratio (SNR) of a cross-correlation analysis and produces spurious results. In the present study, image-enhancement techniques such as contrast-limited adaptive histogram equalization (CLAHE), min/max technique, and subtraction of background image (SB) method were applied to speckle images to achieve a more accurate SIV measurement. A mechanical sector ultrasound scanner was used to obtain ultrasound speckle images from rat blood under steady and pulsatile flows. The effects of the image-enhancement techniques on SIV analysis were evaluated by comparing image intensities, velocities, and cross-correlation maps. The velocity profiles and wall shear rate (WSR) obtained from RBC suspension images were compared with the analytical solution for validation. In addition, the image-enhancement techniques were applied to in vivo measurement of blood flow in human vein. The experimental results of both in vitro and in vivo SIV measurements show that the intensity gradient in heterogeneous speckles has substantial influence on the cross-correlation analysis. The image-enhancement techniques used in this study can minimize errors encountered in ultrasound SIV measurement in which RBCs are used as flow tracers instead of exogenous contrast agents.     

Novel stability criteria for fuzzy Hopfield neural networks based on an improved homogeneous matrix polynomials technique

The global stability problem of Takagi-Sugeno(T-S) fuzzy Hopfield neural networks(FHNNs) with time delays is investigated.Novel LMI-based stability criteria are obtained by using Lyapunov functional theory to guarantee the asymptotic stability of the FHNNs with less conservatism.Firstly,using both Finsler’s lemma and an improved homogeneous matrix polynomial technique,and applying an affine parameter-dependent Lyapunov-Krasovskii functional,we obtain the convergent LMI-based stability criteria.Algebraic properties of the fuzzy membership functions in the unit simplex are considered in the process of stability analysis via the homogeneous matrix polynomials technique.Secondly,to further reduce the conservatism,a new right-hand-side slack variables introducing technique is also proposed in terms of LMIs,which is suitable to the homogeneous matrix polynomials setting.Finally,two illustrative examples are given to show the efficiency of the proposed approaches.     

RIBLL终端LASCAR闪烁体阵列探测器研制进展

介绍了RIBLL终端LASCAR闪烁体阵列探测器的工作原理和结构特点. 描述了为满足放射性核束实验的要求而对阵列所作的重要改进. 给出了LASCAR构型优化改造的工作设想和实施步骤. The principles and structure characteristics of LASCAR scintillator array detector at RIBLL terminal are described. Special emphases are laid upon the latest progress for the development of LASCAR array detector to meet the requirements of the RIB experiments. The working plan and steps for optimizing configuration of the LASCAR multi unit neutron scintillator array detector are also presented.