The Universal Plateau Structure of Lyapunov Exponents for Period Doubling Cascade Attractors

Using algebraic. analysis method for periodic orbits of Hknon map, we derive the boundary equations of stable window and Lyapunov exponent plateau region on the space of nonintegrability parameter A and dissipation parameter J. Ekom the real root of these equations, we obtain the plateau width of Lyapunov exponent W_p = A_p,max - A_p,min and the stable tvindorv width W_s = A_p,max - A_p,min for high periodic orbits. The calculated result of plateau structure ratio α4 = W_p/W_S for period-4 orbit agrees with the conjectural analytical formula: α4 = 2J²/(1+J⁴). Hence our result presents further evidence of universal dependence of Lyapunov exponent plateau structure on the dissipation parameter for period doubling cascade attractors of nonlinear system in transition from order to chaos.     

Seasonal Changes in Essential Oil Constituents of Cystoseira compressa: First Report

Marine macroalgae are well known to release a wide spectrum of volatile organic components, the release of which is affected by environmental factors. This paper aimed to identify the essential oil (EO) compounds of the brown algae Cystoseira compressa collected in the Adriatic Sea monthly, from May until August. EOs were isolated by hydrodistillation using a Clavenger-type apparatus and analyzed by gas chromatography coupled with mass spectrometry (GC–MS). One hundred four compounds were identified in the volatile fraction of C. compressa, accounting for 84.37–89.43% of the total oil. Samples from May, June, and July were characterized by a high share of fatty acids (56, 69, and 34% respectively) with palmitic acid being the dominant one, while in the August sample, a high content of alcohols (mainly phytol and oleyl alcohol) was found. Changes in the other minor components, which could be important for the overall aroma and biological activities of the algal samples, have also been noted during the vegetation periods. The results of this paper contribute to studies of algal EOs and present the first report on C. compressa EOs.     

开区注氮采空区自燃温度场的数值模拟研究

为了研究开区注氮采空区遗煤自燃和被抑制的力学过程,用非均质多孔介质中的渗流连续性方程、气体弥散方程和综合传热方程的联立,建立了采空区注氮非定常数值模型．结合实例,用迎风格式有限元方法求解．给出了采空区的漏风流态、氮气流态,描绘了采空区自燃过程中氧、CO浓度和温度分布的变化过程．计算考虑了瓦斯涌出和工作面推进的影响．得到注氮条件下采空区高温区形状变窄;随着注氮量的提高,使自然发火期逐渐变长,直至不自燃．理论计算与实际情况吻合．     

Lamellar thickening of polyethylene under high pressure

Single crystal mat (SCM) samples of polyethylene (PE) were prepared from dilute solution of p-xylen, then they were annealed at pressures of 200 and 500 MPa. Lamellar thickness of the original and annealed SCM samples was measured by small-angle X-ray scattering method. Orientation of the molecular chain in those SCM samples was investigated by wide-angle X-ray diffraction pattern. From these X-ray measurements, annealing temperature dependence of the lamellar thickness, i.e., lamellar thickening, under high pressure was obtained. Melting process of the SCM samples was also investigated at 200 and 500 MPa by high pressure differential thermal analysis. Then correspondence between the lamellar thickening and the melting process was studied. The lamellar thickness increases markedly with approaching to the melting temperature of the orthorhombic crystal even in the high pressure region where the high pressure phase (hexagonal phase) appears. The annealing temperature dependence curve of the lamellar thickness at 200 MPa can be superimposed on the curve at 500 MPa by shifting the curve along the temperature scale by 47 K. Large scale lamellar thickening occurs in the orthorhombic crystal phase in the high pressure region. The formation process of extended-chain crystal is discussed. © 1997 John Wiley & Sons, Inc. J Polym Sci B: Polym Phys, 35: 535–543, 1997     

FTIR spectroscopic study on crystallization process of poly(ethylene-2,6-naphthalate)

In situ Fourier transform infrared (FTIR) measurements were carried out to elucidate conformation changes occurring during the isothermal melt crystallization of poly(ethylene-2,6-naphthalate) (PEN). Based on the band assignments for the components of the amorphous, α-crystal form, and β-crystal form of PEN in film samples, the in situ data was analyzed in terms of the amorphous- and crystal-trans conformations. It was observed at a higher isothermal crystallization temperature that the formation of amorphous-trans conformations precedes the growth of crystals. © 1997 John Wiley & Sons, Inc. J Polym Sci B: Polym Phys 35: 2741–2747, 1997     

Trace 1300气相色谱仪故障排查与期间核查

使用赛默飞Trace 1300气相色谱仪进行环境样品分析过程中,出现了FID信号变弱、点火困难的现象,严重影响检测数据的准确性,干扰正常分析工作。从样品性质、仪器方法的设置、气路系统以及检测系统进行故障排查,确定故障原因为FID喷嘴堵塞,点火线圈锈蚀严重。对维修好后的气相色谱仪进行期间核查,核查结果:基线噪声为0.066 pA,基线漂移(30 min)为0.321 pA,FID检测限为0.094 1 ng/s,定性重复性为0.062%,定量重复性为1.41%,均满足技术指标要求。     

Stepwise annealing of poly(butylene terephthalate)

Annealing of poly(butylene terephthalate) (PBT) was studied by differential scanning calorimetry (DSC) and small angle X‐ray scattering (SAXS) measurement. A PBT sample was annealed at a recrystallization temperature where recrystallization occurs with a maximum rate in the heating process of the sample. In the subsequent annealing steps, the annealed sample was annealed repeatedly at the recrystallization temperatures, and the stepwise annealing sample was obtained. Peak melting temperature (T_m) and sharpness of DSC peak of the stepwise annealing sample increased with the annealing step. A high melting‐temperature sample was obtained in a short time, and T_m increased up to 238.5°C which is higher than all the T_m values that appear in the literature. The long period calculated from SAXS curves of the stepwise annealing sample increased with the annealing step. The increase of crystallite size and perfection of the crystal in the stepwise annealing process is suggested. Annealing experiment indicated that T^°_m should be higher than about 235°C. T_m increased linearly with the annealing temperature of the final step in the stepwise annealing (T_a). The equilibrium melting temperature (T^°_m) for PBT was estimated to be 247°C by the application of a Hoffman–Weeks plot to the relation between T_m vs. T_a. © 1999 John Wiley & Sons, Inc. J Polym Sci B: Polym Phys 37: 2420–2429, 1999     

Effects of Prenatal Exposure to Aflatoxin B1: A Review

Aflatoxins are mycotoxins produced as secondary fungal metabolites. Among them, aflatoxin B1 (AFB1) stands out due to its genotoxic and mutagenic potential, being a potent initiator of carcinogenesis. In this review, the outcomes from the published literature in the past 10 years on the effects of AFB1 pathophysiological mechanisms on embryological and fetal development are discussed. In several animal species, including humans, AFB1 has a teratogenic effect_, resulting in bone malformations, visceral anomalies, lesions in several organs, and behavioral and reproductive changes, in addition to low birth weight. The mutagenic capacity of AFB1 in prenatal life is greater than in adults, indicating that when exposure occurs in the womb, the risk of the development of neoplasms is higher. Studies conducted in humans indicate that the exposure to this mycotoxin during pregnancy is associated with low birth weight, decreased head circumference, and DNA hypermethylation. However, as the actual impacts on humans are still unclear, the importance of this issue cannot be overemphasized and studies on the matter are essential.     

CO_2激光写入的长周期光纤光栅加速度传感器实验研究

基于高频CO_2激光在普通单模光纤上制作的长周期光纤光栅的应变和弯曲特性,本文设计制作了一种新型的加速度传感器.基于等强度梁理论分析了梁振动与长周期光纤光栅输出光强之间的关系,最后推导出了系统的加速度理论模型.文中搭建了长周期光纤光栅加速度计的实验测量系统.实验结果表明系统的加速度灵敏度约为2.82 v/g,准确度约为8.96×10~(-4) g,加速度测量误差约为0.82%.基于这种长周期光纤光栅的加速度计具有成本低、灵敏度较高等优点,因此在振动测量、惯性导航等方面将具有较好的潜在应用价值.     

Optimization of photonic bandgap fiber long period grating refractive-index sensors

Long period gratings in low-index contrast solid-core photonic bandgap fibers are a promising platform for fiber-based fluid refractive index sensing with very low detection limits. We provide a comprehensive investigation of the possibilities for refractive index sensing using that principle in a commercial photonic crystal fiber filled with a fluid: using an acoustic grating, we map out the cladding bands, and use this data to optimize a long period grating’s sensitivity. We then implement the optimized long period grating, again using an acoustic grating, and directly measure its sensitivity to refractive index. We demonstrate a sensitivity of 17,900 nm/RIU (6.94 nm/°C) which corresponds to a smallest detectable index change of the fluid of 8.4 × 10⁻⁶.