3D X-ray Micro-CT Analysis of Rebar Corrosion in Reinforced Concrete Subjected to a Chloride-Induced Environment

The paper presents experimental investigations of the concrete covers’ protective ability to counteract rebar corrosion in reinforced concrete cubes. The concrete sample was subjected to a chloride-induced environment to get corroded and combined with an un-corroded sample. The chloride-accelerated technique can induce a high degree of corrosion within a controlled time. Moreover, detailed and thorough experimental measurements and analyses of reinforcement loss due to corrosion and its influence on concrete microstructure, were studied through 3D X-ray micro-computed tomography. The rebar outside the concrete was heavily corroded due to the chloride-accelerated test, whereas, only local surface corrosion products appeared inside the concrete. It turned out that the concrete cover showed protective ability to counteract the reinforcing-steel corrosion mechanism despite the accelerated corrosion environment. Moreover, the bond strength between the reinforcement rebar and concrete was not visibly affected since the failure force in the pull-out test and failure mechanisms, observed by 3D X-ray micro-CT, were similar for corroded and un-corroded samples. The failure occurred due to radial cracks with a maximum width equal to approximately 0.25 mm.     

具有高机械强度的掺Er3+∶TeO2-Nb2O5玻璃的光谱性质研究

熔制了掺铒碲铌玻璃样品(100-XTeO2-XNb2O5(X=5,10,15,20 mol%),测试了其密度、折射率、转变温度、析晶温度、维氏机械强度、吸收光谱、荧光光谱、荧光寿命等参量。利用Judd-Ofelt和McCumber理论分别计算了铒离子强度参量Ωt (t=2, 4, 6)和受激发射截面σemi的大小,研究了掺铒碲铌玻璃样品光谱参量对Nb2O5成分的依赖性,并与典型的碲锌钠玻璃（75TeO2-20ZnO-5Na2O）在热学、机械强度、光谱性质和放大品行四个方面进行了比较.     

Studies on the syntheses of polymetalloxanes and their properties as a precursor for amorphous oxide. IV. Properties of SiO2–TiO2 oxide fibers from polytitanosiloxane

From polytitanosiloxanes (PTS), SiO₂–TiO₂ oxide fibers with fairly good tensile strength were prepared, and their mechanical and thermal properties were investigated. The precursor fibers PTS-0.5 and PTS-1.0 were obtained by dry spinning of a highly viscous PTS solution which were formed as the reaction mixture of silicic acid (SA) with bis(2,4-pentanedionato)titanium diisopropoxide (PTP) in the molar ratios (SA/PTP) of 0.5 and 1.0. The precursor fibers PTS-0.5 were too brittle to measure their tensile strength, whereas PTS-1.0 and the heat-treated fibers were found to have tensile strength of 130 (precursor), 540 (500°C), and 450 (900°C) MPa, respectively. Heat-treatment of the fibers PTS-1.0 at above 1000°C forms anatase and rutile of titanium dioxide. The crystallization is resulted from the unreacted PTP which is not incorporated into the polymer network.     

Novel Foaming-Agent Free Insulating Geopolymer Based on Industrial Fly Ash and Rice Husk

This study highlights the synthesis of a new thermal insulating geopolymer based on the alkaline activation of fly ashes. A porous geopolymer material can be prepared without the addition of a foaming agent, using high ratio solution/ashes (activating solutions used are water, sodium or potassium hydroxide). In order to increase the porosity of the material and to make it more ecological, rice husks are incorporated into the formulation. The geopolymer materials were prepared at room temperature and dried at moderate temperature (105 °C) by a simple procedure. The microstructural characteristics of these new porous geopolymers were assessed by optical microscopy, X-ray diffraction (XRD), thermogravimetric analysis (TGA) and X-ray fluorescence (XRF). Infrared spectroscopy (FTIR) was used to confirm the geopolymerisation. The effect of the ratio solution/ashes and the percentage of the rice husk addition on thermal and mechanical analysis was evaluated. An insulating material for a solution/ashes ratio of 0.9 and a rice husk content of 15% having a λ value of 0.087 W/(m·K), a porosity of 61.4% and an Rc value of 0.1 MPa was successfully prepared.     

PVP/CHI交联共混水凝胶的pH敏感性研究

制备戊二醛交联的PVP/CH I共混水凝胶,红外光谱佐证了凝胶网络的生成。pH敏感性实验表明,凝胶的溶胀率在pH=1.0的介质中最大,在pH=4.0的介质中次之,在中性或pH=9.0的碱性介质中最低,表明凝胶具有明显的pH敏感性。CH I含量、交联剂用量、CH I脱乙酰度均对凝胶的pH敏感性有影响,CH I含量40%、交联剂用量0.3%、CH I脱乙酰度99%的PVP/CH I凝胶pH敏感性较显著。介质pH值由1.0到7.0变化时,凝胶拉伸强度随着溶胀率的降低而增大。     

水硬性石灰合成及拉破坏特性试验研究

水硬性石灰在欧洲石质文物修复和加固中获得了很大成功。我国的石质文物主要是砂岩,水硬性石灰的修复效果不好。为满足我国石质文物修复和加固的需求,本文以石灰石和黏土为原料,在950℃煅烧不同时间,制备出水硬性石,对试样的成分、微观形貌、收缩率、抗拉强度和拉破坏过程等进行了研究。结果表明:(1)试样中含有水硬性成分2CaO·SiO2(C2S);煅烧8h时,成分与欧洲水硬性石灰NHL5接近;1.5CaO·SiO2·xH2O(C-S-H)和CaCO3的含量随龄期的增加逐渐增加。(2)龄期1~3d,收缩率较小;龄期4~6d,收缩率以线性规律增加;7d以后,收缩率趋于稳定。(3)局部变形区随拉应力的增加而变大,邻近局部变形区逐渐合并,形成面积更大的应变局部化带;载荷超过峰值后,产生微裂隙;随载荷进一步增加,微裂隙扩展,贯穿整个试件,发展成宏观裂隙,使试件破坏。(4)抗拉强度随龄期的增加而增加,水硬性石灰中C-S-H、CaCO3等相互交织,构成空间致密体,使试件力学强度提高。合成的水硬性石灰物理力学性能与欧洲水硬性石灰NHL5相近,并且成分均匀、可控,在石质文物修复和加固工程中具有良好应用前景。     

First-principles prediction of crystal structure and physical properties of ScB3

The crystal structure of ScB₃ is seeked by combining the developed particle swarm optimisation algorithm for crystal structure prediction with first-principles calculations. A new monoclinic phase with the C2/m symmetry is predicted successfully, which is energetically more superior to the early reported R-3m-, P2₁/m-, P6₃/mmc-, P-6m2-, Pnma-, and Pm-3m-type structures in the pressure range from 0 to 100?GPa. The obtained elastic constants and phonon dispersion curve reveal that the C2/m-ScB₃ is mechanically and dynamically stable. The predicted large bulk module, high shear modulus, small Poisson’s ratio as well as the considerable hardness indicate that the C2/m-ScB₃ has outstanding mechanical property. Meanwhile, the dependences of the bulk modulus and Young’s modulus of ScB₃ on the crystal orientation are investigated theoretically. Through applying the strain–stress method, the ideal tensile and shear strengths along different crystal directions are also estimated, and the obtained results confirm that the shear mode dominates the failure mode in the C2/m-ScB₃ structure and it is intrinsically a hard material. The electronic structure calculation and chemical bonding analysis illustrate that the strong covalent B-B and Sc-B bonds are responsible for its structural stability and high hardness.     

基于SVM的固化土无侧限抗压强度模型

为实现较少试验次数下固化土无侧限抗压强度(qu)的准确预测, 提出了基于支持向量机(SVM)的固化土qu的预测模型. 以固化剂各组分掺入比、龄期、初始含水量、固化剂掺量等因素为输入量, 固化土的qu作为输出量, 以径向基为核函数, 采用网格搜索法和交叉验证法进行参数优化, 建立了基于SVM的固化土qu的预测模型. 算例分析表明: 该模型适用于任意条件下固化土qu的精确预测, 且在较小试验成本下实现与响应面法相当的预测精度.     

Relationship between the radial dynamics and the chemical production of a harmonically driven spherical bubble

The sonochemical activity and the radial dynamics of a harmonically excited spherical bubble are investigated numerically. A detailed model is employed capable to calculate the chemical production inside the bubble placed in water that is saturated with oxygen. Parameter studies are performed with the control parameters of the pressure amplitude, the forcing frequency and the bubble size. Three different definitions of collapse strengths (extracted from the radius vs. time curves) are examined and compared with the chemical output of various species. A mathematical formula is established to estimate the chemical output as a function of the collapse strength; thus, the chemical activity can be predicted without taking into account the chemical kinetics into the bubble model. The calculations are carried out by an in-house code exploiting the high processing power of professional graphics cards (GPUs).The results shown that chemical activity can be approximated qualitatively from the values of relative expansion. This could be helpful in order to optimise chemical output of sonochemical reactors either from measurement data or simulations as well.     

SB粉水热种分过饱和铝酸钠溶液制备拟薄水铝石

A novel hydrothermal process for preparation of single-phase pseudoboehmite from supersaturated sodium aluminate solution with SB pseudoboehmite seed was presented. The process is characterized by precipitation for 3 h at temperature around 125 ℃ with a seed ratio of 1.0. Precipitation yield of Al₂O₃ over 20% could be reached and the specific surface area of precipitated products almost as high as SB seed could be obtained. The process suitable for preparing pseudoboehmite with any pseudoboehmite seed in principle comprises a highly variation of the current Bayer process and the latest boehmite process for the production of smelter grade alumina.