类氖氩离子能级及碰撞强度的计算

利用扭曲波波恩近似方法及AUTOSTRUCTURE (AS)程序，快速精确地计算了类氖Ar8+离子2s22p6、2s22p53s、2s22p53p、2s22p53d、2s2p63s、2s2p63p和2s2p63d组态的能级以及当电子碰撞能量为75.0、125.0、175.0、250.0 (Ry)时，从j能态到i能态的碰撞强度.并且与已有的研究成果进行了对比.结果表明，采用扭曲波波恩近似并结合AUTOSTRUCTURE (AS)程序的研究方法，可以成为研究原子或离子碰撞强度的有效途径。     

Ocimum basilicum seed mucilage reinforced with montmorillonite for preparation of bionanocomposite film for food packaging applications

Use of nanocomposites is a well-established approach in enhancing the mechanical and barrier properties of bionanocomposite film for food packaging applications. The seed mucilage of Ocimum basilicum was employed for the preparation of bionanocomposite films with montmorillonite (MMT) as nanofiller. The films were prepared by solvent-casting method at varied solution pH (1, 3, 5 and 9) and MMT loading (1%, 3%, 5%, 10%, 15% and 20%). The films were characterized for physical, mechanical and barrier properties in addition to microstructure and X-ray diffraction pattern. XRD analysis revealed the exfoliated dispersion of MMT at pH 9, confirming its effective interaction with the bionanocomposite film. Maximum film tensile strength was achieved at a lower MMT load of 5%. Water vapour permeability reduced with increase in MMT loading up to 5%, followed by an increase at higher MMT loadings. Film formed at pH 9 showed tensile strength of 17.3 ± 0.33 MPa and reduced water vapour permeability (WVP) of 0.21 g mm.m⁻².hr⁻¹.kPa⁻¹.     

Effect of magnetic field on electron spectrum and probabilities of intraband quantum transitions in spherical quantum-dot-quantum-well

The effect of magnetic field on electron energy spectrum, wave functions and probabilities of intraband quantum transitions in multilayered spherical quantum-dot-quantum-well (QDQW) CdSe/ZnS/CdSe/ZnS is studied. Computations are performed in the framework of the effective mass approximation and rectangular potential barriers model. The wave functions are expanded over the complete basis of functions obtained as exact solutions of the Schrodinger equation for the electron in QDQW without the magnetic field.It is shown that magnetic field takes off the spectrum degeneration with respect to the magnetic quantum number and changes the localization of electron in the nanostructure. The field stronger effects on the spherically-symmetric states, especially in the case of electron location in the outer potential well. The magnetic field changes more the radial distribution of probability of electron location in QDQW than the angular one. The oscillator strengths of intraband quantum transitions are calculated as functions of the magnetic field induction and their selection rules are established.     

MASS SPECTROMETRIC FRAGMENTATION OF UNSYMMETRICALLY SUBSTITUTED METHYLPHOSPHONATE DIESTERS

Abstract

A series of structurally related unsymmetrically substituted methylphosphonate diesters have been synthesised and subjected to electron impact (El) mass spectral studies. These studies though aimed at total identification of the compounds, resulted in certain interesting observations and hence are being reported. In order to confirm the observations under electron impact and to support the mechanism of fragmentation we have also performed MSNS experiments in both daughter ion and parent ion modes.     

Relation between interfacial shear strength and compressive strength of carbon fiber/epoxy resin composite strands

The mechanism with which the fiber-matrix interfacial strength exerts its influence on the compressive strength of fiber reinforced composites has been studied by measuring the axial compressive strength of carbon fiber/epoxy resin unidirectional composite strands having different levels of interfacial shear strength. The composite strands are used for experiments in order to investigate the compressive strength which is not affected by the delamination taking place at a weak interlayer of the laminated composites. The interfacial strength is varied by applying various degrees of liquid-phase surface treatment to the fibers. The efficiency of the compressive strength of the fibers utilized in the strength of the composite strands is estimated by measuring the compressive strength of the single carbon filaments with a micro-compression test. The compressive strength of the composite strands does not increase monotonically with increasing interfacial shear strength but showes lower values at higher interfacial shear strengths. With increasing interfacial shear strength, the suppression of the interfacial failure in the misaligned fiber region increases the compressive strength, while at higher interfacial shear strengths, the enhancement of the crack sensitivity decreases the compressive strength.     

Experimental investigation of the effect of temperature on the strength of polyimide contact structures

A new photogrammetry based measurement technique for contact areas in line contact structures is developed. From the data collected by this technique, a method for measuring the contact strength of contact structures in high temperature applications is proposed. The contact strength of a line contact structure of polyimide at different temperatures is measured; the results show that the increase in temperature decreases the contact strength of the structure. The effect of temperature on the contact strength is studied by investigating the occurrence and evolution of yielding core within the structure at different temperatures. The decrease in the yield strength and elastic modulus of the polyimide material at high temperature induces core yielding at lower loads and eases the propagation of core yielding to the surface.     

Use of 2, 3-Butanedione Monoxime for Homogeneous Precipitation of Nickel (II)

Abstract

The solid monoxime of 2, 3-butanedione is a more convenient material than liquid dione for the homogenous generation of DMG. 2, 3-butanedione dioxime. Determinations of Ni in steels and in pure Ni(II) solutions have shown the optimum pH and order of adding reagents. Gravimetric and/or an EDTA titrimetric finish are possible for a method of reliability within ± 0.2 mg of Ni in 50–150 mg Ni. The solid has the same character and filterability as that from the 1960 dione method of Salesin and Gordon¹.     

UV spectral characterization of a smectic-C liquid crystal: Theoretical support to the experiment

In the present article, UV spectral characterization of a smectic-C liquid crystal 4,4′-bis(n-alkoxy)azoxybenzene (n = 14) (C₄₀H₆₆N₂O₃) has been carried out. Structure of the molecule has been optimized using the Density functional B3LYP with 6-31+G (d) basis set using crystallographic geometry as input. The absorption spectra have been estimated in the UV region by employing the DFT method, semiempirical CNDO/S and INDO/S parameterizations. The oscillator strength (f) and vertical transition energy (E_V) have been reported corresponding to absorption wavelength (λ_max). These values have been compared with the experimental value reported in the literature to offer theoretical support to the experimental value. Further, some electrochemical properties have been reported for the molecule.     

Measuring powder flowability with a modified Warren Spring cohesion tester

The measurement of powder flowability is a major concern for most industrial processes that deal with the handling of bulk solids as raw materials,intermediates,or products.The development of devices that measure the flowability of non-aerated powders has not progressed as rapidly as might have been hoped since most research activities have been based on various types of shear testers intended to aid the design of hoppers.A new flowability indicator named as weighted cohesion (WS) is established using newly...     

Nano Silicon from Nano Silica Using Natural Resource (Rha) for Solar Cell Fabrication

Abstract

High purity (～99%) nano silica with an average particle size of ～100 nm was extracted at pH 3 at 650°C from a natural resource, rice husk, using alkaline extraction followed by acid precipitation method. Using nano silica as a precursor, silicon (Si) nanoparticles have been synthesized by high-temperature magnesiothermic reduction method. The prepared sample was characterized by X-ray diffraction, particle size analyzer, Fourier transform infrared spectroscopy, transmission electron microscopy, X-ray fluorescence analyzer, and UV–Vis spectroscopy. The comprehensive characterization studies indicate the pure phase formation of Si and the variation of particle size from 70 nm to 100 nm for samples synthesized at different sintering temperatures. Moreover, the silicon nanoparticles produced at 850°C have pure phase formation, high purity, and good absorption peaks. The efficiency calculated through IV characteristics is found to be increasing in silicon and ruthenium combination (2.67%), which is better than that achieved from the conventional solar cells. The produced silicon nanoparticles could be applied as an anode material for solar cell fabrication.