互通多孔碳/二氧化锰纳米复合材料的原位水热合成及电化学性能

以互通多孔碳（IPC）为载体，水热条件下在碳表面原位反应生成纳米结构的二氧化锰（MnO₂），制备互通多孔碳/二氧化锰纳米（IPC/MnO₂）复合电极材料. 采用扫描电镜（SEM），透射电镜（TEM），X射线衍射（XRD），热重分析（TGA）对其结构进行表征；采用循环伏安法、恒流充放电和交流阻抗对其电化学性能进行研究. 结果表明：生成的MnO₂均匀地负载在碳的表面，形成多层次结构，并且随着温度的升高IPC表面负载的MnO₂由纳米颗粒变为纳米片状结构；MnO₂纳米片具有典型的K-Birnessite 型晶体结构；复合物中MnO₂的含量约为34%（w）. 在100 ℃制备的IPC/MnO₂复合材料在三电极系统中最高比电容达到了411 F·g^-1；随着反应温度的升高,比容量先增长后基本保持不变. 以IPC/MnO₂为正极，活性炭（AC）为负极，1 mol·L^-1 Na₂SO₄溶液为电解液组装成IPC/MnO₂//AC 混合超级电容器，发现IPC/MnO₂电极的电容器其电位窗口从1 V扩展到1.8 V，容量可达86F·g^-1，且表现出良好的电容特性和大电流放电性能.     

Rigid aromatic fractal polyamides

The preparation of rigid aromatic, highly branched polyamides is described. Owing to the method of preparation and the chosen ratio of difunctional to trifunctional monomers, these entities are highly porous and not dendrimeric in nature. They better conform with the fractal model and are therefore called fractal polyamides (FPs). The effects of variations in the polymerization procedure, in total monomer concentration, in the ratio of amine to carboxyl groups and in the duration of the polycondensation reaction are investigated. Some characterization was performed and the results are presented and briefly discussed.     

pH sensitivity of Si--C linked organic monolayers on crystalline silicon surfaces.

The electrochemical behavior of Si--C linked organic monolayers is studied in electrolyte-insulator-Si devices, under conditions normally encountered in potentiometric biosensors, to gain fundamental knowledge on the behavior of such Si electrodes under practical conditions. This is done via titration experiments, Mott-Schottky data analysis, and data fitting using a site-binding model. The results are compared with those of native SiO(2) layers and native SiO(2) layers modified with hexamethyldisilazane. All samples display pH sensitivity. The number of Si--OH groups on the alkylated samples is calculated to be less than 0.7 % of that of a pure SiO(2) insulator, which still causes a pH sensitivity of approximately 25 mV per pH unit in the pH range: 4-7. The alkylated samples hardly suffer from response changes during up- and down-going titrations, which indicates that very little oxide is additionally formed during the measurements. The pK(a) values of all samples with monolayers (4.0-4.4) are lower than that of native SiO(2) (6.0). The long-term drift (of approximately 1 mV h(-1)) is moderate. The results indicate that biosensors composed of alkylated Si substrates are feasible if a cross-sensitivity towards pH in the sensor signal is taken into account.     

互通多孔碳/二氧化锰纳米复合材料的原位水热合成及电化学性能

以互通多孔碳（IPC）为载体，水热条件下在碳表面原位反应生成纳米结构的二氧化锰（MnO₂），制备互通多孔碳/二氧化锰纳米（IPC/MnO₂）复合电极材料. 采用扫描电镜（SEM），透射电镜（TEM），X射线衍射（XRD），热重分析（TGA）对其结构进行表征；采用循环伏安法、恒流充放电和交流阻抗对其电化学性能进行研究. 结果表明：生成的MnO₂均匀地负载在碳的表面，形成多层次结构，并且随着温度的升高IPC表面负载的MnO₂由纳米颗粒变为纳米片状结构；MnO₂纳米片具有典型的K-Birnessite 型晶体结构；复合物中MnO₂的含量约为34%（w）. 在100 ℃制备的IPC/MnO₂复合材料在三电极系统中最高比电容达到了411 F·g^-1；随着反应温度的升高,比容量先增长后基本保持不变. 以IPC/MnO₂为正极，活性炭（AC）为负极，1 mol·L^-1 Na₂SO₄溶液为电解液组装成IPC/MnO₂//AC 混合超级电容器，发现IPC/MnO₂电极的电容器其电位窗口从1 V扩展到1.8 V，容量可达86F·g^-1，且表现出良好的电容特性和大电流放电性能.     

Polarization Dependence of a Hydrophobized Electrode for Electrosynthesis of a Soluble Product

An equation for a polarization curve of a hydrophobized electrode is proposed for electrosynthesis of a soluble electroactive product in an inner-kinetic mode. The equation contains the concentration of the target product (TP) in an explicit form. The shape of the curve depends on the biquadratic root of the TP concentration and the square root of the ratio between exchange currents of the side and target reactions.     

An expedient preparation of Stryker's reagent

A convenient and efficient preparation of Stryker's reagent, [Ph₃PCuH]₆, under homogeneous conditions using silanes as the reducing agent is detailed. The reaction time can be reduced to 1-2 h, and high yields of Stryker's reagent can be routinely achieved. The same method has been extended to the synthesis of [Ph₃PCuD]₆ using Ph₂SiD₂.     

Transport of monooleoylglycerol mediated by bile salt micelles across porous membranes

In order to study how the bile salts and lipids behave in the vicinity of microvillus, the transport properties of a sodium salt of deoxycholic acid (NaDC) and its mixture with monooleoylglycerol (MO) through artificial membranes were investigated in 0.15 M NaCl saline solution at 37°C.The hydrodynamic radius of MO-solubilized micelles was estimated to be approximately 17–20 Å from the transport study. The thermodynamically stable MO-NaDC mixed micelles formed above critical micelle concentration in the higher region of mole fraction of NaDC in the mixture (X _NaDC>ca. 0.6), can behave as a single species in transport process and freely pass through the porous membranes of both pore sizes, 0.01 m and 0.1 m.The permeabilities of MO-NaDC mixed micelles are large compared with those of pure NaDC micelles. MO molecules solubilized may probably enhance the interaction between MO and NaDC molecules by better contacting with the respective hydrophobic groups in a mixed micelle (the flexible structure of MO molecule enables it), and in this situation, the smaller micelles compared with those of pure NaDC must be more favorable.     

Surface oxides on porous carbon

Wet oxidation of BPL porous carbon by H₂O₂ and HNO₃ changes the pore structure and also increases the concentration of surface oxides. KOH uptake is increased by oxidation and is seen to be dependent on KOH concentration and to a lesser extent on inert electrolyte concentration. Enthalpy of immersion measurements have allowed the estimation of the enthalpy of hydration of the surface oxides and the enthalpy of neutralization of the easily accessible acid oxides.     

Correction procedure for the electron microprobe analysis of porous materials

A correction method is proposed for the quantitative determination of stoichiometric ratios in porous materials by electron microprobe analysis. Analysis of this kind of material is complicated by an imperfect surface that can only be improved to some extent. The correction is based on a linear dependence (different for each element) of the analyses on a sum of weight concentrations of oxides. With this correction it is possible to use analyses affected by the imperfection of the surface with much better confidence compared to common normalisation. An example is presented for a series of ceramic superconductors Bi_2.1(SrCa)_2.9Cu₂O₈₊.     

ANISOTROPIC STRAIN EFFECT ON MORPHOLOGY AND ATOMIC STRUCTURE OF VICINAL Si(001) SURFACE

On vicinal Si(001) surfaces, dependence of growth morphology on the applied strain direction and formation of vacancy lines from Ag-induced missing dimer vacancies are studied. Both phenomena are intimately related to the anisotropic nature of the strain field which originates from the surface dimerization. Strain relief mechanism, reflecting on the surface morphology, is shown to be different in two orthogonal directions. Normal to the steps, step-pair bunching and waving lead to formation of hillocks and pits. Along the step direction, bending of step pairs forms a cusp which later develops into a deep groove. Toward the atomic scale, the formation of the vacancy lines is driven by the short-range attractive interaction between the vacancies in adjacent dimer rows and the long-range repulsive interaction between them in the same dimer row. A full form and magnitudes of the interactions are derived from the thermally-excited wandering of the vacancy lines formed by a nominal amount of Ag depositing onto the surface.