Dielectric Studies of Glycine–Ethylene Glycol–Water Solutions Using Time Domain Reflectometry

Time domain reflectometry (TDR) has been used for dielectric relaxation measurements on the glycine–ethylene glycol–water ternary system (TDR) at 25, 30, 35, and 40°C in the frequency range from 10 MHz to 10 GHz. Glycine–ethylene glycol–water solutions are prepared with different concentrations of ethylene glycol (0, 5, 10, 15, 20, and 30%) and also for different glycine molar concentrations (0, 0.2, 0.4, 0.6, 0.8, and 1 M). The dielectric relaxation parameters are measured for aqueous glycine solutions also to compare the results with those for the glycine–ethylene glycol–water ternary system. For all the solutions considered, only one relaxation peak was observed in this frequency range. The complex permittivity spectra for the aqueous glycine solutions can be well described by the Cole–Davidson expression, whereas that for the ternary system can be well described by the Havriliak–Negami expression. The logarithm of the relaxation time log() shows a nonlinear relation with the glycine molar concentration that implies a change in the relaxation mechanism with glycine concentration. The dielectric strength increases with an increase in glycine molar concentration, whereas it decreases with an increase in ethylene glycol concentration.     

聚合物硼氢阴离子还原剂的制备及其对酯的还原研究

氯型季我安盐型强碱性阴离子交换树脂７１１＾＃与硼氢化钾反应制得聚合物硼氢阴离子还原剂，树脂容量３．２ｍｍｏｌ ＢＨ４／ｇ。用于不同酯化合物的还原，操作简便，树脂可再生重复使用。     

Zirconium(IV)-porphyrins as novel ionophores for fluoride-selective polymeric membrane electrodes

The feasibility of using Zr(IV)-porphyrins as novel ionophores for preparing anion-selective polymeric membrane electrodes is examined. Electrodes constructed using o-nitrophenyl octyl ether plasticized poly(vinyl chloride) membranes containing Zr(IV)-octaethylporphyrin (OEP) dichloride (Zr(IV)[OEP]Cl₂) or Zr(IV)-tetraphenylporphyrin (TPP) dichloride (Zr(IV)[TPP]Cl₂) were found to exhibit enhanced potentiometric selectivity toward fluoride compared to electrodes based on a typical anion-exchanger (e.g. tridodecylmethylammonium chloride). At pH 5.5, the electrodes displayed the following selectivity sequences: ClO₄⁻ > SCN⁻ > I⁻ > F⁻ > NO₃⁻ > Br⁻ > NO₂⁻ > Cl⁻ and F⁻ > ClO₄⁻ > SCN⁻ > I⁻ > NO₂⁻ > NO₃⁻ > Br⁻ > Cl⁻ for membranes doped with Zr(IV)[OEP]Cl₂) and Zr(IV)[TPP]Cl₂, respectively. Both ionophores are shown to operate via a charged carrier mechanism, with 10 mol% of lipophilic tetraphenylborate derivative in the membrane phase required to achieve optimal selectivity. Electrodes prepared with both metalloporphyrin species display super-Nernstian response toward fluoride with slopes typically greater than −100 mV per decade. It is shown, via UV-VIS spectroscopy of the membrane phase, that this behavior occurs due to spontaneous formation of hydroxide ion bridged porphyrin dimers in the membrane in the presence of the lipophilic anionic additive. The dimers are easily converted to monomeric species upon increasing the concentration of fluoride in the sample solution. Decreasing the pH of sample buffer background solution (from pH 5.5 to pH 3) decreases the lower detection limit (DL) of the electrode response toward fluoride (by two-order of magnitude) and improves the electrodes’ selectivity.     

Electroosmosis through a Cation-Exchange Membrane: Effect of an ac Perturbation on the Electroosmotic Flow

Electroosmosis experiments through a cation-exchange membrane have been performed using NaCl solutions in different experimental situations. The influence of an alternating (ac) sinusoidal perturbation, of known angular frequency and small amplitude, superimposed to the usual applied continuous (dc) signal on the electroosmotic flow has been studied. The experimental results show that the presence of the ac perturbation affects the electroosmotic flow value, depending on the frequency of the ac signal and on the solution stirring conditions. In the frequency range studied, two regions have been observed where the electroosmotic flow reaches a maximum value: one at low frequencies (Hz); and another at frequencies of the order of kHz. These regions could be related to membrane relaxation phenomena.     

表面改性对CeO2纳米粉体特性的影响

研究了表面改性对CeO2纳米粉体特性的影响，采用表面活性剂．十二烷基硫酸钠对CeO2粉末颗粒表面进行了改性。未改性和改性的纳米氧化铈用粉体综合性能测试仪、激光粒度仪、比表面积测试仪、X射线仪、扫描电子显微镜进行了表征。结果表明，用十二烷基硫酸钠表面改性能提高纳米氧化铈的流动性和分散性，减小比表面积和团聚，同时也对CeO2粉体颗粒表面改性的机制进行了探讨。     

弛豫理论对离子交换毛细管电色谱中峰压缩现象的研究

 在毛细管电色谱中,由于溶质在输运过程中所具有的电性质,常会产生一些特殊的现象。这些现象,如离子交换毛细管电色谱中产生超高柱效峰的现象,已经不能用一般的色谱理论加以解释。基于弛豫理论所建立的基本模型,在考虑溶质在两相中皆有可能发生正、反向迁移的情况下,得到了流出曲线一阶原点矩和二阶中心矩的理论表达式,并通过对溶质在两相中电扩散速率与电泳速率、电渗流速率关系的分析结果证实:溶质在固定相表面的电扩散行为可以使其保留变弱,出峰加快;而这种电扩散导致的超常柱效峰的出现具有不稳定性,只有在多方面因素综合影响匹配的情况下才可能出现。     

Modulated differential scanning calorimetry in the glass transition region

Temperature-modulated calorimetry (TMC) allows the experimental evaluation of the kinetic parameters of the glass transition from quasi-isothermal experiments. In this paper, model calculations based on experimental data are presented for the total and reversing apparent heat capacities on heating and cooling through the glass transition region as a function of heating rate and modulation frequency for the modulated differential scanning calorimeter (MDSC). Amorphous poly(ethylene terephthalate) (PET) is used as the example polymer and a simple first-order kinetics is fitted to the data. The total heat flow carries the hysteresis information (enthalpy relaxation, thermal history) and indications of changes in modulation frequency due to the glass transition. The reversing heat flow permits the assessment of the first and higher harmonics of the apparent heat capacities. The computations are carried out by numerical integrations with up to 5000 steps. Comparisons of the calculations with experiments are possible. As one moves further from equilibrium, i.e. the liquid state, cooperative kinetics must be used to match model and experiment.On leave from Toray Industries, Inc., Otsu, Shiga 520, Japan.This work was supported by the Division of Materials Research, National Science Foundation, Polymers Program, Grant # DMR 90-00520 and the Division of Materials Sciences, Office of Basic Energy Sciences, U. S. Department of Energy at Oak Ridge National Laboratory, managed by Lockheed Martin Energy Research Corp. for the U. S. Department of Energy, under contract number DE-AC05-96OR22464. Support for instrumentation came from TA Instruments, Inc. Research support was also given by ICI Paints, and Toray Industries, Inc.     

Basis Set Orbital Relaxation in Atomic and Molecular Hydrogen Systems

Orbital relaxation (OR) amounts to variation of the orbital exponents in hydrogen molecules and ions relative to the exponents of the isolated atom; it is represented as the sum of the one- and two-center contributions depending on the effective atomic charge and on the presence of other atoms in the molecule. The procedure for isolating the contributions of the exponent includes treatment of the OR of hydrogen in a special set of neutral and charged atoms and molecules with certain multiplicities of their electronic states. Within the framework of the spin-unrestricted Hartree-Fock method, we found and discussed the optimal values of the exponents of the basis orbitals of hydrogen atoms and molecules using the minimal split valence-shell basis set, the basis set that includes the polarization function, and the expanded set of grouped natural orbitals. A simple energy model is suggested for OR. Expressions are derived for evaluating the exponents of the relaxed orbitals in hydrogen-containing systems.Original Russian Text Copyright © 2004 by A. I. Ermakov, A. E. Merkulov, A. A. Svechnikova, and V. V. Belousov__________Translated from Zhurnal Strukturnoi Khimii, Vol. 45, No. 6, pp. 973–978, November–December, 2004.     

Flow‐Injection Amperometric Detection with Solvent Polymeric Membrane Ion Sensors

An amperometric detector for hydrophobic ions based on a plasticized poly(vinyl) chloride (PVC) membrane incorporated in a flow‐injection system was developed. A four‐electrode potentiostat with ohmic drop compensation was used, while a flow‐through cell incorporated the four electrodes and the membrane, which contained tetrabutylammonium tetraphenylborate. When the influence of the applied potential and of the flow‐injection variables on the determination of tetrabutylammonium was studied, a linear relationship was observed between current peak height and ion concentration over a range of 5×10^?6–6×10^?5 M tetrabutylammonium. Good repeatability and between‐day reproducibility and high sample frequency were obtained. The effect of other ions was studied. Two different amperometric methods, indirect and direct, were also developed for the determination of dodecylsulfate in the concentration range 3×10^?5–9×10^?4 M.