水溶性聚酯的结构和性能

由对苯二甲酸二甲酯、间苯二甲酸、间苯二甲酸二甲酯５－磺酸钠与乙二醇等共缩聚合成的ＰＥＴ型水溶性聚酯（ＷＳＰ）是一种新型的水溶性聚合物，在化纤、纺织、涂料、粘合剂、电子、油墨等领域有着广泛的应用前景．化纤领域超细纤维新材料的研究、开发和生产，迫切需要一...     

Detection of processed genetically modified food using CIM monolithic columns for DNA isolation

The availability of sufficient quantities of DNA of adequate quality is crucial in polymerase chain reaction (PCR)-based methods for genetically modified food detection. In this work, the suitability of anion-exchange CIM (Convective Interaction Media; BIA Separations, Ljubljana, Slovenia) monolithic columns for isolation of DNA from food was studied. Maize and its derivates corn meal and thermally pretreated corn meal were chosen as model food. Two commercially available CIM disk columns were tested: DEAE (diethylaminoethyl) and QA (quaternary amine). Preliminary separations were performed with standard solution of salmon DNA at different pH values and different NaCl concentrations in mobile phase. DEAE groups and pH 8 were chosen for further isolations of DNA from a complex matrix-food extract. The quality and quantity of isolated DNA were tested on agarose gel electrophoresis, with UV-scanning spectrophotometry, and by amplification with real-time PCR. DNA isolated in this way was of suitable quality for further PCR analyses. The described method is also applicable for DNA isolation from processed foods with decreased DNA content. Furthermore, it is more effective and less time-consuming in comparison with the existing proposed methods for isolation of DNA from plant-derived foods.     

炭黑填充聚乙烯材料电阻—温度特性研究

研究了炭黑／聚乙烯导电复合材料的ＰＴＣ特性及在不同条件下的电阻变化。发现ＰＴＣ特性与体积膨胀及聚乙烯晶相的熔融有许多一致性。认为材料的体积膨胀及聚乙烯晶相熔融时炭黑颗粒均匀化扩散导致了电阻随温度上升。在较高温度下，炭黑颗粒在分子链段热运动的推动下会发生相对聚集使电阻不断减小，这是材料出现ＮＴＣ现象的原因。材料总的电阻温度特性是体积膨胀、炭黑向聚乙烯熔融区扩散及相互聚集三个因素共同作用的结果。     

非线性光学材料──水草酸铵

一水草酸铵（简称ＡＯＭ）是一种优良的电光晶体￣［１］。文献￣［１，２］报道了该晶体的晶体结构，化学式为（ＮＨ＿４）＿２Ｃ＿２Ｏ＿２·Ｈ＿２Ｏ，属正交晶系，Ｐ２２２空间群，晶胞参数ａ＝０．８０３５ｎｍ，ｂ＝１。０３１ｎｍ，ｃ＝０．３８０１ｎｍ，ｚ＝２。本文拟报道ＡＯＭ单晶生长，热化学分析，透过波段以及非线性光学性质的初步研究。     

立方介孔相含钇氧化硅的合成与表征

以低浓度的十六烷基三甲基溴化铵为结构导向剂,在碱性条件下通过水热法合成了具有立方结构的含钇Y MCM 48介孔分子筛材料。XRD测试表明当Y/Si<0.05时可以获得典型的长程有序介孔立方结构相,随Y/Si比的增加,晶胞参数的增大和红外吸收光谱(FTIR)的变化为Y进入介孔分子筛骨架中提供了有力证据。N2吸附-脱附实验给出这种立方介孔材料的BET表面积为1180m2·g-1,BJH平均孔径为3.4nm。紫外 可见漫反射光谱(UV vis)证明钇以一种六配位的形式存在。X射线光电子能谱(XPS)进一步证明钇以三价形式存在于立方介孔分子筛骨架中。     

8-羟基喹啉对甲基苯酚合锌配合物的合成及光致发光和电致发光性能

有机电致发光 ( EL )技术作为一种有着广阔应用前景的显示技术 ,自 1 987年 [1] 以来已获得了空前迅速的发展 .部分发光器件的亮度、效率和寿命已经达到或接近实用化的程度 .许多有机化合物 [2～ 5] ,包括小分子和聚合物 ,已被用于制备有机 LEDs.应用于有机 EL的化合物很多 ,这为优化和筛选优秀的 EL材料提供了基础 .以 8-羟基喹啉铝为代表的有机金属配合物是一类重要的有机 EL材料 ,这类材料荧光效率高、易于提纯且性质比较稳定 .目前应用于有机 EL金属配合物的发光材料大多配位数均为偶数 ,四配位的 8-羟基喹啉锌配合物 ( Znq2 ) [6…     

Mass spectrometric analysis of low molecular mass polyesters by laser desorption/ionization on porous silicon

A low molecular mass polyester was analyzed by desorption/ionization on porous silicon (DIOS) mass spectrometry. The results were compared with those of matrix-assisted laser desorption ionization (MALDI) mass spectrometry using matrixes of alpha-cyano-4-hydroxycinnamic acid (CHCA) and 10,15,20-tetrakis(pentafluorophenyl)porphyrin (F20TPP). The CHCA matrix was not suitable for characterization of low molecular mass components of the polyester because the matrix-related ions interfered with the component ions. On the other hand, the F20TPP matrix showed no interference because no matrix-related ions appeared below m/z 822. However, the solvent selection for determining optimal conditions of sample preparation was limited, because F20TPP does not dissolve readily in any of the available organic solvents. In the DIOS spectra, the polymer ions were observed at high sensitivity without a contaminating ion. No matrix is needed for DIOS spectra of low molecular mass polyesters, facilitating sample preparation and selectivity of a precursor ion in post-source decay measurements.     

熔融浸渍法制备锂离子电池正极材料LiMn2O4的研究

采用LiNO3和MnO2为原料,在650℃下制备了尖晶石型的LiMn2O4.通过X射线衍射、扫描电子显微镜、热重分析和电化学性能测试,发现该化合物具有很高的放电比容量和较好的循环性能,首次放电比容量可达到122 mA·h/g.并对循环性能衰减的各种因素进行了讨论.     

电化学超级电容器电极材料的研究进展

回顾了电化学超级电容器电极材料的研究进展，并对不同电极材料的储能原理和性能特点进行了简要的阐述。参考文献29篇。     

泡沫铅对VRLA电池负极活性物质结构及性能影响

0引言随着36V/42V汽车电源系统的提出,新一轮汽车用电池的竞争不断加剧。从目前情况看,铅酸电池由于具有成本低廉,使用可靠,原材料来源丰富,铅回收率可高达98%等优点,因此成为电动车电源最实际的选择之一[1]。但作为电动车用电池,需要克服其比能量低、充电接受能力差和负极硫酸盐化等缺点。为此各国科学家开展了大量的研究工作。最近报道用铸造多孔体作为敞口铅酸电池的集流体,它的比表面积为14cm2·cm-3,正极活性物质利用率上升到50%,远高于传统的铸造板栅[2]。在铅酸电池集流体研究领域里另一个重大进步,就是以R V C(R etic-ulated V i…