N,C10-Überbrückte Morphinalkaloide, 5H-10,13-Iminoethano-phenanthro[4,5-bcd]furan, 2. Mitt.

Summary Following our concept of rather new structural variations in the nitrogen region of morphine alkaloids we describe the first synthesis of N/C-10-bridged tertiary bases.

     

Increase of Calcium Levels at Interphase in NIH 3T3 Cells

The fluorescent calcium ion indicator dye Fluo-3 and DNA-binding dye Hoechst 33342 were employed to determine, in a quantitative microspectrofluorometric study, the intracellular calcium ion concentration ([Ca~(2+)]_i) and the DNA content of individual living NIH3T3 cells. The well-separated excitation and emission properties of these dyes allowed us to establish for each cell both the phase of the cell cycle using DNA content and [Ca~(2+)]_i. We found that the transition from G_1, through S, to the G_2 phase is accompanied by a two-fold increase in [Ca~(2+)]_i. The [Ca~(2+)]_i was inhomologous in each phase of the interphase (G_1, S and G_2) although [Ca~(2+)]_i in the S and G_2 phases was never lower than certain threshold values in the G_1 and S phases respectively. [Ca~(2+)]_i in G_0 cells was lower than that in G_2 cells. These changes in [Ca~(2+)]_i suggest that [Ca~(2+)]_i may be an import regulator of cell cycle progression.     

固体CD光谱研究及其应用于手性席夫碱M(II)配合物

结合课题组近期的相关研究,对固体CD光谱在手性配合物研究中的应用,特别是手性样品固体CD光谱的测试方法进行了概述,通过对四对手性席夫碱M(II)(M=Ni、Cu)配合物的固体和溶液CD光谱进行比较研究,发现配合物的手性构型在固液相中保持一致,但其固液CD光谱之间存在不同程度的差异,可能是由于相应配合物在固体和溶液相中的四面体扭曲或构象的微妙不同所致.     

脲基苯乙炔4-′(对甲基苯基)-6-苯基-2,2′-二联吡啶铂(II)络合物的合成

本文通过异氰酸酰化反应合成了含有脲基的苯乙炔新型配体及以它作为辅助配体的4′-(对甲基苯基)-6-苯基-2,2′-二联吡啶铂(II)络合物,初步研究了铂(II)络合物的光物理性质,发现由于脲基的存在,当浓度大于3.32×10-5mol/L时铂(II)络合物能够发生分子间簇集.     

不同方法掺杂Au对纳米α-Fe2O3气敏性能的影响

分别采用共沉淀法、浸渍法、紫外辐照法制备了掺杂不同Au含量的α-Fe2O3纳米粉体,并制作了旁热式厚膜型气敏元件.用XRD、TG-DTA和TEM技术对纳米晶的晶型、晶粒大小及形貌进行了表征.考察了掺杂方法、Au含量及焙烧温度对α-Fe2O3气敏性能的影响.结果表明,采用三种方法掺杂适量Au后,都使α-Fe2O3的气敏性有了显著提高,其中采用共沉淀法,在400℃焙烧的Au质量分数为1.5%的α-Fe2O3的气敏性最佳.     

阿托伐他汀钙与β-环糊精相互作用的研究及应用

采用线性扫描伏安法和循环伏安法并结合紫外分光光度法研究了新型抗血脂紊乱药物阿托伐他汀钙(AC)与β-环糊精(-βCD)的相互作用.探讨了-βCD对AC的峰电流及AC对-βCD吸附峰电流的影响,测得在0.06mol/LKH2PO4-Na2HPO4(pH=7.17)缓冲溶液中,AC与-βCD包结比为1:1,用电流法测得包结物的形成常数为9.09×104L/mol.根据碱性介质条件下β-CD分子与AC形成包结物而使β-CD吸附峰电流减小的特性,建立了一种利用β-CD间接测定AC的伏安方法.     

新型1,2,4-三唑并[3,2-d][1,5]苯并氧氮杂-2-酮的合成

取代苯并二氢吡喃 4 酮 ( 1)的芳腙在冰醋酸中与KNCO发生 [3 2 ]环加成反应 ,加成产物经KMnO4氧化开环得偕偶氮异氰酸酯 ( 3 ) .3在HBF4的催化下发生环化 -重排反应 ,合成得到一系列新型 6 7 5三环系 1,2 ,4 三唑并 [3 ,2 d] [1,5 ]苯并氧氮杂 2 酮 ( 5a～ 5g) .由X单晶衍射测定了化合物 5a的晶体结构     

La2Zr2O7催化剂结构相变对甲烷氧化偶联反应性能的影响

采用共沉淀法并通过改变焙烧温度制备了一系列具有不同晶相结构的La₂Zr₂O₇催化剂，在微型固定床反应器上评价其甲烷氧化偶联反应性能，并利用XRD、Raman、CO₂-TPD、XPS等表征手段，探究催化剂的物相结构、表面碱性以及表面氧物种的变化规律。结果表明，随着焙烧温度从700℃逐渐升高到1200℃，La₂Zr₂O₇催化剂结晶度不断提高，晶相发生明显变化，从无定形结构逐渐向缺陷萤石结构过渡，最终转变成烧绿石结构。焙烧温度提高促使La₂Zr₂O₇晶相转变过程中，催化剂表面的碱性强度减弱，中等碱性位数量以及具有催化活性的表面氧物种O₂^2-和O₂^-的相对含量不断减少，致使催化剂的CH₄转化率和C₂₊选择性不断降低。其中，无定形LZO-CP-700催化剂表现出最佳的甲烷氧化偶联反应性能。     

壳聚糖-聚羟基丁酸酯共混膜的制备与性质

以乙酸为共溶剂,制备了壳聚糖-聚羟基丁酸酯(CTS-PHB)共混膜,利用红外光谱(FT-IR)、广角X粉末衍射(WAXD)、扫描电镜(SEM)及差热分析(DTA)表征了共混膜的化学组成、晶形、形貌和热稳定性能。研究表明:CTS和PHB可在体积百分数为62.5%的乙酸溶液中共混,形成表面光滑、不透明的膜,干态共混膜具备一定的力学强度。各比例的CTS-PHB共混膜有相同的热分解温度,共混膜的形貌特征随两组分质量配比变化,其中mPHB/mCTS=1/1的共混膜显示出良好的有序结构。     

Chemical analysis of acidic silicon etch solutions: I. Titrimetric determination of HNO3, HF, and H2SiF6

The chemical etching of silicon using HF-HNO₃ mixtures is a widely used process in the processing of silicon wafers for microelectronic or photovoltaic applications. The control of the etch bath composition is the necessary condition for an effective bath utilization, for the replenishment of the consumed acids, and to maintain a certain etch rate. The present paper describes two methods for the total analysis of the individual etch bath constituents HF, HNO₃, and H₂SiF₆. Both methods start with an aqueous acid-base titration determining the total acid concentration and the concentration of H₂SiF₆. The first method is an acid-base titration using a 0.1 mol L⁻¹ methanolic solution of cyclohexylamine (CHA) as non-aqueous titrant to determine the content of nitric acid. Then, the amount of hydrofluoric acid is calculated from the difference between the total acid and nitric acid content. The second method is based on the determination of the total fluoride concentration using a fluoride ion-selective electrode (F-ISE). The content of hydrofluoric acid is obtained from the difference between the total fluoride content and the amount of fluoride bound as H₂SiF₆. The amount of nitric acid results finally calculated as difference to the total acid content.