碳纳米管掺杂聚丙烯腈/铜室温环化为石墨的拉曼光谱分析及形成机制研究

石墨质碳质材料因具有良好的电学、力学、热学性能而在电子设备,复合材料,电池,传感器中得到广泛应用,但针对生产能耗高,污染大,成本高,不可控等现状是急需解决的核心问题。因此,通过使用较简单和成本低的制造技术在纳米级器件中获得石墨碳结构的方法是一个有吸引力的探索领域。表面等离激元技术因具有环境友好、能耗低等优点而受到广泛关注,利用等离激元技术诱导大分子链状聚合物石墨化就是一种具有广阔前景的制备技术,而Cu作为贱金属具有产量高,价格便宜等优势。基于表面等离激元技术,利用激光辐射粗糙Cu表面上的聚丙烯腈(PAN)+碳纳米管(CNT),而使聚丙烯腈在金属表面被石墨化。通过改变基底刻蚀时间、退火温度、退火时间、激光强度系统地研究了PAN/Cu和PAN+CNT/Cu得到最佳石墨化条件。实验结果表明：以PAN作为探针分子,在2.5 mol·L^-1硝酸刻蚀15min的铜基底上,观察到了增强因子为1.39×10⁴的表面增强拉曼散射(SERS)效应。通过使用拉曼激光作为光源,在退火温度为140℃时,可以观察到石墨化的PAN分子结构缺陷较少,碳氮三键消失,其I     

管道有源噪声控制中壁面分布次级声源的空间分布优化

为了改进管道中高阶模式声波的有源控制效果,研究了壁面分布次级声源的空间分布优化问题。首先提出管道中次级声源独立控制高阶模式声波的理论模型。然后推导次级声源在管道中各方向上空间分布对控制高阶模式声波的贡献,得到了次级声源空间分布的优化准则。通过将空间分布离散化,采用最小化管道中声能流的控制策略得到次级声源的最优驱动强度。最后通过数值仿真对比最优驱动强度时各种次级声源空间分布对控制性能的影响,验证了通过优化次级声源空间分布能显著提高控制效果。仿真结果表明,当次级声源分布于管道所有壁面且沿管道轴向分布范围较大时,高阶模式的控制效率最高。     

Strategies of tailored nanomaterials for electrochemiluminescence signal enhancements

Nanomaterials and their applications were studied extensively over the past few decades due to their properties which are associated mainly with the nanoscale sizes and unique characteristics that they have. Among many applications, these nanomaterials have been playing great, multifaceted roles in increasing the analytical performances of electrochemiluminescence (ECL). In this article, we review the main possible approaches – based on nanoparticles – to modify the photophysical properties of the excited state generated as a consequence of the electrochemical stimulus and in particular taking profit of the so-called metal-enhanced fluorescence (MEF) and resonance energy transfer (RET) processes. We believe that these strategies will lead to the design of very efficient systems that can substantially increase the possible successful applications of ECL.     

Label-free screening of bio-molecular interactions

The majority of techniques currently employed to interrogate a biomolecular interaction require some type of radio- or enzymatic- or fluorescent-labelling to report the binding event. However, there is an increasing awareness of novel techniques that do not require labelling of the ligand or the receptor, and that allow virtually any complex to be screened with minimal assay development. This review focuses on three major label-free screening platforms: surface plasmon resonance biosensors, acoustic biosensors, and calorimetric biosensors. Scientists in both academia and industry are using biosensors in areas that encompass almost all areas drug discovery, diagnostics, and the life sciences. The capabilities and advantages of each technique are compared and key applications involving small molecules, proteins, oligonucleotides, bacteriophage, viruses, bacteria, and cells are reviewed. The role of the interface between the biosensor surface (in the case of SPR and acoustic biosensors) and the chemical or biological systems to be studied is also covered with attention to the covalent and non-covalent coupling chemistries commonly employed.     

Comparative surface plasmon resonance and enzyme-linked immunosorbent assay characterisation of a monoclonal antibody with N-acyl homoserine lactones

This study shows the detection of (N-acyl) homoserine lactones (AHLs or HSL) with monoclonal antibodies via a surface plasmon resonance (SPR)-based immunosensor in comparison to conventional microtiter plate-based enzyme-linked immunosorbent assay (ELISA). An HSL derivative, named HSL2 (Table 1), was attached to bovine serum albumin (BSA) and the conjugate (HSL2-BSA-r2) was either covalently immobilised on the SPR sensor chip surface via free amino groups or via adsorption on the ELISA polystyrene plate surface. With a newly developed rat monoclonal antibody (mAb HSL1/2 2C10), AHLs were detected sensitively in a competitive format with SPR and ELISA. Well comparable experiments between SPR and ELISA could be obtained in buffers. Moreover, the SPR sensor surface with the immobilised conjugate HSL2-BSA-r2 could be regenerated at least 340 times (regeneration cycles) without loss of activity. The measurement time per cycle was approximately 15 min. The competitive detection format for SPR and ELISA allowed the detection in the μg L⁻¹ range.     

表面等离子体共振生物传感器连续检测莱克多巴胺

利用表面等离子体共振生物传感器对莱克多巴胺抗体与固定在芯片表面的莱克多巴胺衍生物的相互作用进行了分析,解离常数为2.56×10-6s-1。根据一定范围内相对响应值和时间近似呈线性关系的动力学特性,建立了连续检测的方法,从而简化了实验步骤,有利于提高芯片的使用寿命。检测莱克多巴胺采用抑制法,将莱克多巴胺衍生物固定在芯片的表面,莱克多巴胺抗体与样品混合后流过芯片的表面,所得相对响应值与样品中莱克多巴胺的浓度成反比。单个样品的检测时间设定为15min,对应的检出限小于4μg/L。     

A “sodium trap” based on benzo-15-crown-5 with an exocyclic N-(thiophosphoryl)thiourea moiety

For N-(thio)phosphorylthioureas of the common formula RC(S)NHP(X)(OiPr)₂HL^I (R = N-(4′-aminobenzo-15-crown-5), X = S), HL^II (R = N-(4′-aminobenzo-15-crown-5), X = O), HL^III (R = PhNH, X = S), HL^IV (R = PhNH, X = O), and (N,N′-bis-[C(S)NHP(S)(OiPr)₂]₂-1,10-diaza-18-crown-6) H₂L^V, salts LiL^I,III,IV, NaL^I–IV, KL^I–IVM₂L^V (M = Li⁺, Na⁺, K⁺), Ba(L^I,III,IV)₂, and BaL^V have been synthesized and investigated. Compounds NaL^I,II quantitatively drop out as a deposit in ethanol medium, allowing the separation of Na⁺ and K⁺ cations. This effect is not displayed for the other compounds. The crystal structures of HL^III and the solvate of the composition [K(Me₂CO)L^III] have been investigated by X-ray crystallography.     

Ag/Ag3PO4/g-C3N4三元复合光催化剂的制备及其可见光驱动下的光催化活性增强

报道了一种新型Ag/Ag₃PO₄/g-C₃N₄三元复合光催化剂的制备及其半导体界面处的快速载流子分离所引起的光催化活性的显著增强效应。通过X射线衍射,扫描电子显微镜,紫外-可见吸收光谱以及光致发光光谱等就其晶体结构、形貌、组分、光学吸收以及载流子的快速分离行为进行了表征与分析。以罗丹明B作为模型化合物分子,研究发现,所制备的Ag/Ag₃PO₄/g-C₃N₄三元复合光催化剂在可见光照射下表现出比Ag₃PO₄以及Ag₃PO₄/g-C₃N₄二元催化剂更为优异的光催化活性。研究认为,Ag₃PO₄表面尺寸约为40 nm的Ag纳米粒子在可见光下受激所产生的等离子表面共振效应以及Ag₃PO₄与g-C₃N₄界面处所形成的类似异质结结构对所制备的Ag/Ag₃PO₄/g-C₃N₄三元复合光催化剂光催化活性的显著增强起到重要作用。     

A Conformationally Flexible Dinuclear PtII Complex with Differential Behavior of its Two States toward Quadruplex DNA

The reaction of tetrakis(pyridine‐2‐yl)pyrazine (tppz) with 2 equiv of (2,2′‐bpy)Pt^II in water yields two isomeric dinuclear cations, [{Pt(2,2′‐bpy)}₂(tppz)]⁴⁺, in which Pt coordination exclusively takes place through the two pairs of pyridine‐2‐yl nitrogen atoms. The two conformational isomers differ in their overall shape, with the formation of “Z” and “U” shapes, which are formed at 40 °C (Z isomer, 1 ) and under reflux conditions (U isomer, 2 ), respectively. X‐ray crystal‐structure analyses of the Z isomer, [{Pt(2,2′‐bpy)}₂(tppz)](PF₆)₄ ? 3 CHCl₃ ? 4 H₂O ( 1 a ), and of the U isomer, [{Pt(2,2′‐bpy)}₂](PF₆)₄ ? 2 CH₃CN ? 1.5 H₂O ( 2 a ), were carried out. Co‐crystallization of compound 2 with PtCl₂(2,2′‐bpy) yielded [{Pt(2,2′‐bpy)}₂(tppz)](BF₄)₄?[PtCl₂(2,2′‐bpy)] ? 4.5 H₂O ( 3 ), in which the PtCl₂(2,2′‐bpy) entity was sandwiched between the two 2,2′‐bpy faces of the U‐shaped cation ( 2 ). Quantum chemical calculations revealed that the U isomer was more stable than the Z isomer, both in the gas phase and in an aqueous environment. These two isomers display different affinities toward duplex DNA and human telomeric quadruplex DNA (Htelo), as concluded from CD spectroscopy and FID assays. Thus, the U isomer binds significantly more strongly to quadruplex DNA (DC₅₀=0.38 μM ) than the Z isomer (DC₅₀=8.50 μM ).     

制菌霉素与固体支撑磷脂膜的相互作用

为了更好地了解制菌霉素的作用机理, 本文利用表面等离子体共振(SPR)和交流阻抗两种技术, 考察了制菌霉素与不含固醇的固体支撑纯磷脂膜的相互作用, 结果发现, 制菌霉素可与纯磷脂膜相互作用, 并可能在膜上形成微孔.