An Efficient Method for the Synthesis of 3-Cyano-6-hydroxy-2(1H)-pyridinones under Microwave Irradiation and Solvent-free Conditions

Summary. Three component condensation of alkylacetoacetates, primary amines, and alkyl cyanoacetates catalyzed by solid supports under microwave irradiation gave N-alkyl 3-cyano-6-hydroxy-2(1H)-pyridinones with high yields. Upon carrying out the reaction under the same condition on acidic alumina, zeolite HY, silica gel, and montmorillonite K-10, the best yields were achieved by silica gel. Corresponding author. E-mail: balalaie@yahoo.com Received August 28, 2002; accepted September 3, 2002     

微波吸收法研究Mn,Cu掺杂对ZnS:Mn,Cu光生载流子复合过程的影响

采用微波吸收法，测量了ZnS:Mn,Cu粉末材料受到超短脉冲激光激发后，其光生电子和浅束缚态电子的衰减过程.发现Mn,Cu的浓度对导带电子的寿命有明显的影响，提高掺杂浓度会使光生电子的寿命大大缩短，还研究了掺杂浓度对光致发光强度的影响. 关键词： 发光材料 硫化锌 光电子 微波吸收技术     

Uniformity in radon exhalation from construction materials using can technique

The uniformity in radon exhalation rates for 46 tiles of granite, marble and ceramic used as construction materials were determined using “Can Technique” employing CR-39 nuclear track detectors (NTDs). On each tile, two sealed cans, each enclosing one NTD fixed at the center of the tile surface area covered by the can, were mounted at two different locations of each individual tiles. The track production rates on the NTDs representing radon exhalation rates were measured. The radon exhalation rates from the surface of individual tiles showed uniform exhalations within the calculated uncertainties of the measured values. This makes Can Technique an alternative simple method to measure radon exhalation rates. Calibration required to convert track production rates into radon exhalation rates for the used can and NTD was done using an active technique. The correlation between the measurements by the two techniques shows a good linear correlation coefficient (0.83).     

Organic synthesis based on cathodic deprotonation of acids

The results of studies on electrosynthesis involving carb- and heteroanions generated by cathodic deprotonation of acids (CDA), carried out in the laboratory headed by the author, are surveyed. These studies resulted in the elaboration of efficient electrochemical versions of the known Michaelis-Becker, Wittig-Horner, and Perkin reactions; electrochemical analogs of homolytic aromatic substitution, alkylation, heterocyclization,etc. were developed. Based on CDA, convenient and promising methods for preparing variousN-, O-, P-, S-, andC-alkylated and arylated substances have been developed.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 8, pp. 1411–1422, August, 1995.The author is grateful to Professor V. A. Dorokhov, Professor V. P. Litvinov, and researchers from the laboratories of N. D. Zelinsky Institute of Organic Chemistry headed by them, who participated in joint studies.The work was carried out with financial support from the International Science Foundation (Grant No. MHYOO).     

Photo-induced evolution of copper sheets from cluster molecules and its application to photolithographic copper patterning

UV photoexcitation of (t-butylethynyl copper)₂₄ cluster films induces segregation of the crystals into metallic and organic phases and leads to evolve the metallic sheets sandwiched by organic polymers. The growth of the metallic crystals in the plane of the photo-electromagnetic field is attributed due to plasmon-plasmon interaction among nanoparticles embedded in dielectric polymer matrices. The surface enhanced photochemical reaction of residual cluster molecules on the photon incident direction is expected to take an important role for joining the metal particles to produce a metallic sheet. We can apply this phenomenon for photolithographic copper pattern generation on a flexible base plate.     

Synthesis and characterization of polyaniline doped with organic acids

Spectroscopic [UV–visible and Fourier transform IR (FTIR)] and thermal properties of chemically synthesized polyanilines are found to be affected by varying the protonation media (acetic, citric, oxalic, and tartaric acid). The optical spectra show the presence of a greater fraction of fully oxidized insulating pernigraniline phase in polyaniline doped with acetic acid. In contrast, the selectivity in the formation of the conducting phase is higher in oxalic acid as a protonic acid media. The FTIR spectra of these polymers reveal a higher ratio of the relative intensities of the quinoid to benzenoid ring modes in acetic acid doped polyaniline. Scanning electron micrographs revealed a sponge‐like structure derived from the aggregation of the small granules in acetic acid and oxalic acid doped polyaniline. A three‐step decomposition pattern is observed in all the polymers, regardless of the protonic acid used for the doping. The second step loss related to the loss of dopant is found to be higher in the oxalic acid doped polymer. In accordance with these results the conductivity is also found to be higher in oxalic acid doped material. The temperature dependent conductivity measurements show the thermal activated behavior in all the polymers. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 2043–2049, 2004     

Thermal conductance for single wall carbon nanotubes

We report a theoretical analysis of the phonon thermal conductance, κ(T), for single wall carbon nanotubes (SWCN). In a range of low temperatues up to 100 K, κ(T) of perfect SWCN is found to increase with temperature, approximately, in a parabolic fashion. This is qualitatively consistent with recent experimental measurements where the tube-tube interactions are negligibly weak. When the carbon-carbon bond length is slightly varied, κ(T) is found to be qualitatively unaltered which implies that the anharmonic effect does not change the qualitative behavior of κ(T). Received 12 June 2001     

Synthesis and characterization of white‐light‐emitting polyfluorenes containing orange phosphorescent moieties in the side chain

Two orange phosphorescent iridium complex monomers, 9‐hexyl‐9‐(iridium (III)bis(2‐(4′‐fluorophenyl)‐4‐phenylquinoline‐N,C^2′)(tetradecanedionate‐11,13))‐2,7‐dibromofluorene (Br‐PIr) and 9‐hexyl‐9‐(iridium(III)bis(2‐(4′‐fluorophenyl)‐4‐methylquinoline‐N,C^2′)(tetradecanedionate‐11,13))‐2,7‐dibromofluorene (Br‐MIr), were successfully synthesized. The Suzuki polycondensation of 2,7‐bis(trimethylene boronate)‐9,9‐dioctylfluorene with 2,7‐dibromo‐9,9‐dioctylfluorene and Br‐PIr or Br‐MIr afforded two series of copolymers, PIrPFs and MIrPFs, in good yields, in which the concentrations of the phosphorescent moieties were kept small (0.5–3 mol % feed ratio) to realize incomplete energy transfer. The photoluminescence (PL) of the copolymers showed blue‐ and orange‐emission peaks. A white‐light‐emitting diode with a configuration of indium tin oxide/poly(3,4‐ethylenedioxythiophene):poly(styrenesulfonate)/PIr05PF (0.5 mol % feed ratio of Br‐PIr)/Ca/Al exhibited a luminous efficiency of 4.49 cd/A and a power efficiency of 2.35 lm/W at 6.0 V with Commission Internationale de L'Eclairage (CIE) coordinates of (0.46, 0.33). The CIE coordinates were improved to (0.34, 0.33) when copolymer MIr10PF (1.0 mol % feed ratio of Br‐MIr) was employed as the white‐emissive layer. The strong orange emission in the electroluminescence spectra in comparison with PL for these kinds of polymers was attributed to the additional contribution of charge trapping in the phosphorescent dopants. © 2007 Wiley Periodicals, Inc. JPolym Sci Part A: Polym Chem 45: 1746–1757, 2007     

有机薄膜器件负电阻特性的影响因素

研究了影响有机染料掺杂聚合物薄膜器件负电阻特性的因素，为探索有机负电阻的机理提供实验依据。实验中制备了多种有机染料掺杂聚合物薄膜器件，研究了有机小分子染料、聚合物基体、薄膜组成及厚度、ITO和聚苯胺阳极等对有机染料掺杂聚合物薄膜器件负电阻特性的影响。在室温、大气环境下，所制备的多种有机染料掺杂聚合物器件在所加电压为3～4V时，观察到明显的负电阻特性，电流峰谷比最大约为8。负电阻现象及峰谷比的大小受膜厚和器件的结构、制备工艺等影响。提出用负电阻和二极管并联组成的等效电路模型解释影响负电阻特性的因素，认为负电阻特性与载流子的不平衡注入有关。在此基础上设计、合成了主链含唔二唑电子传输基团的可溶性聚对苯撑乙烯衍生物，该聚合物兼具空穴和电子传输功能，在空气中具有较稳定的N型负电阻特性。进一步控制相关材料和工艺条件，有可能得到易于控制的负阻效应，开发出新型的有机负电阻器件。