中药血清药理学研究金银花的抑菌活性

采用最低抑菌浓度(MIC)测定方法和抑菌活性试验,考察不同产地的金银花以及含药血清的抑菌效果。试验结果为:含药血清对大肠杆菌和金黄色葡萄球菌的MIC分别为0.5μg绿原酸/mL和0.25μg绿原酸/mL;含药血清抑菌活性为高敏。     

Determination of pefloxacin in serum and pharmaceutical forms by derivative spectrophotometry

A method for the direct determination of pefloxacin in serum and pharmaceutical forms (tablets and ampoules) has been developed, based on the use of second-order derivative ultraviolet spectra. Spectrophotometric assay of pefloxacin in tablets and ampoules was carried out in 0.1 mol/L NaOH, while in serum it was performed in 0.1 mol/L NaOH with the addition of sodium dodecylsulfate, in 337–347 nm wavelength range. Linear calibration curves were obtained in the concentration ranges 2–30g/mL pefloxacin for tablets and ampoules and 0.12–5 g/ mL for serum samples. Relative error of determination, as criterion for accuracy, was less than 1%, while the precision was better than 4 ng/ml. The minimum detectable concentration of pefloxacin in serum was 15 ng/mL.     

A simple and regioselective α-bromination of alkyl aromatic compounds by two-phase electrolysis

Electrochemical bromination of toluene and substituted toluenes by two-phase electrolysis yields the corresponding α-brominated products. The reaction has been carried out in a single compartment cell with platinum electrodes at 0 °C in chloroform using an aqueous sodium bromide solution (60%) containing a catalytic amount of HBr. Two-phase electrolysis results in high yields (60-95%) of monobromo compounds with very high regioselectivity (>95%).     

Stereoselective Synthesis of Enantiomerically Pure Natural Products—Estrone as Example

Natural products have been synthesized for billions of years in animals, plants, and microorganisms. As a rule they occur enantiomerically pure. Their chiral character corroborates their use in metabolism or as biologically active agents. Natural products may be insufficient in quality or quantity. They have recently begun to become accessible, either unchanged or modified, by biological synthesis; here, too, they are obtained enantiomerically pure. In the last twenty years chemical synthesis has become a major concern of organic chemists. Their target compounds are primarily enantiomerically pure natural products or biologically active variants thereof.     

Configurational analysis of the natural product passifloricin A by quantum mechanical C NMR GIAO chemical shift calculations

Quantum chemical calculations at mPW1PW91 level, with full geometry optimization, using the 6-31g(d) basis set, and GIAO (gauge including atomic orbitals) ¹³C NMR chemical shifts using the 6-31g(d,p) basis set, are here utilized as a support to define the configurational features of the natural product passifloricin A, whose previously proposed relative configuration has been recently shown, by synthetic studies, to be incorrect. This study suggests that the relative stereostructure for passifloricin A corresponds to the δ-lactone of the (5R,7R,9S,11R)-tetrahydroxyhexacos-2-enoic acid.     

Towards the synthesis of [15]-membered stevastelins through the 2,3-epoxy analogues

A synthetic approach to the [15]-membered stevastelins, a novel class of immunosuppressant agents, is reported based on a macrolactamization route to the 2,3-epoxy derivative 6. The synthesis of this compound was achieved via a stereoselective epoxidation of the allylic alcohol 13, followed by a coupling reaction with a variety of peptide derivatives to give the epoxy peptides 7-10. After an extensive study of cyclizations with these precursors, the best result was achieved with the macrolactamization of 8 in the presence of DEPC, to obtain the epoxy cyclic depsipeptide 6 in 42% yield. From this product, an epoxy analogue of stevastelin B, compound 27, was prepared. Finally, the synthesis of the natural product was attempted through the opening of the oxirane ring contained in 6 and 26, with a variety of methyl cuprate reagents, but without success.     

Unknown residual solvents identification in drug products by headspace solid phase microextraction gas chromatography-mass spectrometry

Summary A sensitive headspace SPME method for the extraction of residual solvents from pharmaceutical products has been developed and optimized. It was found that minimizing sample and headspace volume has a beneficial effect on extraction efficiency. At the same time the method reproducibility was seriously affected by reducing sample and headspace volume. The added air volume was not found to have any significant influence on method sensitivity. The method showed reproducibilities of less than 10% and detection limits as low as 1 ppb for benzene and dichloromethane. The headspace SPME method is around 1000 times more sensitive than static headspace. The optimized parameters were headspace volume 1.5 mL, sample volume 10 μL, and extraction time 30 min. The method was successfully applied to the identification of unknown residual solvents in three different proprietary active drug substances and was successfully applied to the confirmation of the presence of benzene in a proprietary drug substance. Presented at Balaton Symposium '01 on High-Performance Separation Methods, Siófok, Hungary, September 2–4, 2001     

Analysis of free and esterified sterols in vegetable oil methyl esters by capillary GC

The introduction of quality standards for vegetable oil methyl esters is gaining in importance due to their increased use as diesel fuel substitutes and as technical products. Free and esterified sterols, the main constituents of the unsaponifiable matter in vegetable oils, are recovered in vegetable oil methyl esters and may influence the technical properties of vegetable oil methyl ester products. A rapid gas chromatographic method for the qualitative and quantitative determination of free and esterified sterols in vegetable oil methyl esters has therefore been developed. The concentration of the free sterols as well as their qualitative and quantitative composition and the concentration of the sterol esters have been determined in rape seed oil methyl ester samples by GC–FID. Prior to analysis, the free sterols were silylated with N,O-bis(trimethylsilyl)trifluoroacetamide with 1% of trimethylchlorosilane; betulinol was used as an internal standard. Calibration was performed by analysis of standard solutions containing β-sitosterol, cholesteryl stearate, and betulinol. The reproducibility of the quantitative results has been evaluated by repeated injections of the same test solution and by repeated complete analysis of the same sample.     

Physico-chemical aspects of polyethylene processing in an open mixer. Part 20: Additional product yields on bimolecular hydroperoxide decomposition with an alcohol group

Most products formed on polyethylene oxidation result from hydroperoxide decomposition. The product yields can be calculated for various mechanisms of hydroperoxide decomposition. This work concerns the reaction of a hydroperoxide with an alcohol group thought to be dominant in the advanced stages of polyethylene processing in the high temperature range (170-200 °C). Besides hydrogen abstraction by caged alkoxy radicals already envisaged previously, the possibility of β-scission is taken into account. This additional reaction introduces significant complexity into the reaction schemes. This is especially so because additional caged radical pairs must be included into the schemes and the calculations. It becomes possible to calculate the yields of aldehyde and vinyl groups that do not result from hydroperoxide decomposition in the absence of β-scission. The yields of the main oxidation products such as alcohols and ketones are not much affected by taking into account β-scission. The yield of aldehydes is important in the whole temperature range and increases considerably if the temperature is raised from 170 to 200 °C. It becomes more important than the ketone yield. The vinyl groups are formed in amounts corresponding roughly to 10-15% of the trans-vinylene groups in the temperature range of 170-200 °C.     

Protein-reactive natural products

Researchers in the post-genome era are confronted with the daunting task of assigning structure and function to tens of thousands of encoded proteins. To realize this goal, new technologies are emerging for the analysis of protein function on a global scale, such as activity-based protein profiling (ABPP), which aims to develop active site-directed chemical probes for enzyme analysis in whole proteomes. For the pursuit of such chemical proteomic technologies, it is helpful to derive inspiration from protein-reactive natural products. Natural products use a remarkably diverse set of mechanisms to covalently modify enzymes from distinct mechanistic classes, thus providing a wellspring of chemical concepts that can be exploited for the design of active-site-directed proteomic probes. Herein, we highlight several examples of protein-reactive natural products and illustrate how their mechanisms of action have influenced and continue to shape the progression of chemical proteomic technologies like ABPP.