Electropreparation of Poly(benzophenone‐4) Film Modified Electrode and Its Electrocatalytic Behavior Towards Dopamine,Ascorbic Acid and Nitrite

The oxidation of benzophenone‐4 (2‐hydroxy‐4‐methoxybenzophenone‐5‐sulfonic acid) at glassy carbon electrode gives rise to stable redox active electropolymerized film during repetitive potential cycling between 0 to 1.3 V (Ag/AgCl). Cyclic voltammogram of poly(benzophenone‐4) film shows a redox couple with well‐defined peaks. The redox response of the modified electrode was found to be depending on the pH of the contacting solution. The peak potentials were shifted to a less positive region with increasing pH and the dependence of the peak potential was found to be 51 mV/pH. The electrocatalytic behavior of poly(benzophenone‐4) film modified electrode towards oxidation of dopamine, ascorbic acid and reduction of nitrite was investigated. The oxidation of dopamine and ascorbic acid occurred at less positive potential on poly(benzophenone‐4) film compared to bare glassy carbon electrode. For dopamine, the overpotential was reduced about 180 mV. Feasibility of utilizing poly(benzophenone‐4) film coated electrode in analytical estimation of dopamine, ascorbic acid and nitrite was also demonstrated.     

Effect of group II metal cations on catecholate oxidation.

The unexpected effects of Ca(2+) on the free-radical chain reactions of dopamine, norepinephrine, isoproterenol, and pyrocatechol oxidation are studied using oxygen consumption measurements, EPR-spectroscopy, UV/VIS spectrophotometry, and by potentiometric titration. It is found that the formation of Ca(2+)-catecholate complexes is accompanied by an increase in the dissociation constants (K(ai) ) of their phenolic hydroxyls. At pH>pK(ai) and in the presence of alkaline-earth metal cations, the rate of catecholate oxidation increases (Ca(2+), Mg(2+)> Sr(2+), Ba(2+)), whereas on addition of Zn ions the rate decreases. The effects of Group II metal cations on catecholate autoxidation are concomitant with a transient increase of the EPR signal for metal-semiquinonate complexes. Therefore, the effects of Ca(2+) and other alkaline-earth metal cations on catecholate autoxidation can be defined as 1) additional deprotonation of catechol OH-groups involved in the formation of M(2+)-catecholate complexes, the latter exceeding catechols in the susceptibility to dioxygen-induced oxidation and 2) formation of relatively stable free-radical intermediates responsible for chain propagation.     

苯并异硒唑酮氨基酸衍生物的合成及抗脂质过氧化作用

在已知具有氧化作用的2-苯基-1,2-苯并异硒唑-3(2H)-酮(Ebselen)的基础上, 将其2-位苯环更换成氨基酸乙酯, 设计并合成了9个苯并异硒酮的氨基酸衍生物3～11. 这类化合物的抗氧化作用药理研究表明,它们对Fe^2^+/半胱氨酸及维生素C诱发的大鼠肝微粒体脂质过氧化有抑制活性, 部分化合物活性比母体化合物Ebselen更优.     

Identification of radicals spin-trapped in autoxidized linoleic acids: A high performance liquid chromatography and electron spin resonance study

Radicals generated in linoleic acid and deuterated linoleic acid have been trapped by the spin trap 2-methyl-2-nitroso-propane (MNP) and identified by electron spin resonance (ESR) and ENDOR spectroscopy. The formation of two distinct secondary alkyl radical adducts (one conjugated, the other non-conjugated, as shown by their UV absorption spectra) was demonstrated by 11, 11-dideuterio-9-cis-12-cis-linoleic acid using HPLC and ESR spectroscopy.     

Hydrogen bonded layer-by-layer assembly of poly(2-vinylpyridine) and poly(acrylic acid): Influence of molecular weight on the formation of microporous film by post-base treatment

This article describes the buildup of hydrogen bonded multilayer film of poly(2-vinylpyridine) (P2VP) and poly(acrylic acid) (PAA), and the influence of polymer molecular weight on the formation of microporous film by post-base treatment. The formation of a microporous film involved a two-step mechanism: the release of PAA from P2VP/PAA multilayer, and the reorganization of the remaining P2VP on the substrate. Fourier transform infrared spectroscopy (FT-IR) indicated that the release of PAA from hydrogen bonded multilayer was a rapid process, which was almost independent of the molecular weight of PAA. Furthermore, the molecular weight of P2VP had a great effect on micropore formation by immersing the P2VP/PAA multilayer in basic solution. The rate of micropore formation increased with increasing molecular weight. We anticipate that a comparative study on P2VP/PAA films containing high or low molecular weight polymer provides a way to control the surface morphology, and will be helpful and constructive for the forthcoming discussion about the formation of the microporous film.     

Selective cleavage of acetals with ZnBr2 in dichloromethane

A selective cleavage of acetals of 1,2- and 1,3-diols has been achieved under mild conditions using ZnBr₂ in dichloromethane at room temperature. Acetal types cleavable by this procedure include benzylidene, isopropylidene and cyclohexylidene acetals. This method is compatible with several other types of hydroxyl protecting groups such as Bn, Bz, TBDPS, TIPS and TBDMS.     

Selective Determination of Quercetin Using Carbon Nanotube‐Modified Electrodes

Electrochemical detection of quercetin has been carried out on glassy carbon electrodes modified with carbon nanotubes and Nafion (GC/Nafion‐CNT). GC/Nafion‐CNT electrodes did not show passivation effect that occurs on the unmodified electrodes and displayed better stability and reproducibility. Quercetin oxidation was most favorable in acidic conditions and current gradually decreased as the solution pH increased. No oxidation was observed when two ? OH groups in a catechol moiety were fully deprotonated. These electrodes enabled selective determination of quercetin in the presence of interfering species such as ascorbic acid, uric acid, glucose, and catechol in large excess. Quantification of quercetin in a yellow onion has been made and favorably compared with reported values. Good selectivity and high sensitivity obtained by Osteryoung sSquare‐wave voltammetry can open new possibilities of direct quercetin determination in vegetables with a minimal sample treatment.     

Synthesis and characterization of Cu,Ni and Zn binding capability of some amino- and imidazole hydroxamic acids: Effects of substitution of side chain amino-N for imidazole-N or hydroxamic-N-H for -N-CH3 on metal complexation

Solution equilibrium studies on Cu(II)-, Ni(II)- and Zn(II)-N-Me-β-Alaninehydroxamic acid (N-Me-β-Alaha), -N-Me-α-alaninehydroxamic acid (N-Me-α-Alaha), -Imidazole-4-carbohydroxamic acid (Im-4-Cha), -N-Me-imidazole-4-carbohydroxamic acid (N-Me-Im-4-Cha) and -Imidazole-4-acetohydroxamic acid (Im-4-Aha) systems have been performed by pH-potentiometry, UV–Vis spectrophotometry, EPR, CD, ESI-MS and ¹H NMR methods. According to the results: (i) the amino-N atoms are more basic in N-Me-α-Alaha and N-Me-β-Alaha than the hydroxamate function, but the trend is just the opposite between the imidazole-N(3) and hydroxamate. (ii) The metal ion anchor is always the hydroxamate part in the amino acid derivatives, while it is always the imidazole-N(3) in the studied imidazolehydroxamic acids. (iii) The three studied N-Me derivatives do not form metallacrowns. Only hydroxamate type chelate is formed with N-Me-β-Alaha, but with N-Me-α-Alaha a new type of coordination mode (via amino-N and hydroxamate-O) also exists. N-Me-Im-4-Cha also forms a dinuclear complex, [M₂L₃], with Cu(II) and Ni(II) (but not with Zn(II)). In this complex, one of the three ligands might bridge the two metal ions (five-membered hydroxamate-(O,O) plus five-membered (N_im, O_carb) bridging bis-chelating mode), while each of the additional two ligands binds to one metal. (iv) The two studied N–H derivatives, having dissociable proton on the hydroxamic-N, are able to form metallacrown species. A pentanuclear complex, [M₅L₄H₋₄], is exclusively formed above pH 4 between Cu(II) and Im-4-Aha. Interestingly, this 12-metallacrown-4 type complex, although together with various mononuclear binding isomers, appears also with Ni(II) and Zn(II). Unfortunately, the complexes of Im-4-Cha are not soluble in water at physiological pH at all.     

Preparation and Characterization of Mixed‐Valent Nickel Oxide/Nickel Hexacyanoferrate Hybrid Films and Their Electrocatalytic Properties

Polynuclear mixed‐valent nickel oxide and nickel hexacyanoferrate hybrid film was prepared on glassy carbon electrode by multiple scan cyclic voltammetry. The film growth was monitored using electrochemical quartz crystal microbalance (EQCM). The cyclic voltammogram of the nickel hexacyanoferrate film is characterized by single redox couple whereas nickel oxide/nickel hexacyanoferrate hybrid film exhibits two redox couples. Cyclic voltammetric features suggest that the charge transfer process in both films resembles that of surface‐confined redox species. In stronger basic solution (pH ≥9), nickel hexacyanoferrate film was gradually converted into nickel oxide film during potentiodynamic cycling. The peak potential of nickel oxide redox couple moved into more negative side with increasing pH of contacting solution whereas the peak potential of nickel hexacyanoferrate redox couple remains the same. Electrocatalytic behavior of hybrid film coated electrodes toward ascorbic acid, hydrazine and hydroxylamine was investigated using cyclic voltammetry technique. Analytical application of nickel oxide/nickel hexacyanoferrate hybrid film electrode was tested in amperometry and flow injection analysis.