Fluorescent humic substances–arsenic complex in well water in areas where blackfoot disease is endemic in Taiwan

The relationship between the four components, (1) fluorescence intensity, (2) arsenic concentration, (3) pH and (4) total dissolved solids, (TDS) measured in well waters from areas in Taiwan where blackfoot disease (BFD) is endemic was studied, as well as the relationships between the four degrees of BFD and each of the above four symptomatic components, in order to evaluate the etiological factors of BFD more progressively. The following 95% confidence intervals were obtained in well water samples (n = 1189): fluorescence intensity, 26.837–32.570; arsenic concentration, 0.103–0.127 mg dm^?3; pH, 7.466–7.519; and TDS 733.063–801.647 mg dm^?3. Fluorescence intensities of the four degrees of BFD were not all the same (F = 64.54, P < 0.001), and nor were arsenic concentrations (F = 72.03, P < 0.001), pH values (F = 7.30, P < 0.001), nor TDS values (F = 10.76, P < 0.001). In addition, multiple comparisons indicate that the higher the epidemical degree, the higher the fluorescence intensities, arsenic concentrations and pH values become; however, such a relationship is not found for TDS values. Moreover, the fluorescence intensities have positive linear correlations with arsenic concentrations (r = 0.49, P < 0.001), pH (r = 0.25, P < 0.001), and TDS (r = 0.18, P < 0.001), as do the arsenic concentrations with pH (r = 0.22, P < 0.001). Of the four epidemical degree groups, pairs are not significantly different from one another in correlation coefficients between fluorescence intensity and arsenic concentration, which implies a steady relationship between fluorescent compounds and arsenic. We conclude that fluorescent compounds in well water, as possible etiological factors of BFD, are closely related to arsenic along with pH and TDS values in the areas where BFD is endemic. In addition, we infer that a complex is formed by fluorescent compounds, arsenic and other metals.     

利用计算机辅助装调检测矩形大口径离轴非球面的方法研究

通过非球面的零位补偿法,完成了对矩形大口径离轴非球面镜的检测。先用光学设计软件Zemax从理论上分析了在检测中会出现的现象,并结合计算机辅助装调技术,确定在检测过程中相对敏感的自由度,然后控制这些量,使补偿器和非球面的相对关系与理论设计相吻合,在Zygo相位干涉仪上测得最终结果。在λ=632.8nm时,中心圆口径与两个边缘圆口径面形误差RMS分别为0.022λ,0.037λ,0.032λ。检测结果,达到预期目的。     

Determination of Hydrogen Single Ion Activity Coefficients in Aqueous HCl Solutions at 25°C

The single ion activity coefficients of hydrogen and chloride ions in aqueous HCl solutions have been estimated at 25°C at concentrations up to 1 mol-kg^–1, using potentiometric measurements with ion-selective electrodes and appropriate calibration procedures. Two methods are described for an internal calibration of the electrodes in the extended Debye–Hückel concentration range. The results are compared to the conventional pH calibration with external buffer solutions. Since the latter calibration method does not account for the liquid junction potential E _J which arises at the reference electrode, the resulting activity coefficients are quite different in HCl solutions of higher concentration. These differences between internal and external calibration decrease significantly, when a correction for E _J is introduced into the conventional pH calibration. Hence, in solutions of higher ionic strength the accuracy of the conventional pH electrode calibration using buffer solutions is very limited, when exact H⁺ activities are required. The consistency of the results indicates that the liquid junction potentials in the examined systems calculated by the Henderson/Bates approximation are of reasonable precision.     

Second Dissociation Constant of Bis-[(2-hydroxyethyl)amino]acetic Acid (BICINE) and pH of Its Buffer Solutions from 5 to 55 °C

The values of the second dissociation constant, K ₂, and related thermodynamic quantities of the ampholyte bis[(2-hydroxyethyl)amino]acetic acid (BICINE) have been determined at temperatures from 5 to 55 ^∘C. The pH values of six equimolal buffer solutions, and four buffer solutions having ionic strengths (I = 0.16 mol⋅kg⁻¹) similar to those in blood plasma, have been evaluated at 12 temperatures from 5 to 55 ^∘C using the Bates–Guggenheim convention. The liquid junction potentials (E _j ) between the buffer solutions of BICINE and saturated KCl solution of the calomel electrode at 25 and 37 ^∘C have been estimated by measurement with a flowing junction cell. These values of E _j have been used to ascertain the operational pH values at 25 and 37 ^∘C. The pK ₂ values at 25 and 37 ^∘C are 8.333 and 8.156, respectively. The thermodynamic quantities associated with the second acid dissociation have been calculated from the values of pK ₂ as a function of temperature. The zwitterionic buffer BICINE was shown to be useful as a pH standard in the region close to that of blood serum.     

Stimuli‐responsive polymers. VIII. Polyesters and poly(ester amides) containing azobenzene and chiral binaphthylene segments: Highly adaptive materials endowed with light‐, heat‐, and solvent‐regulated optical rotatory power

Azobenzene‐modified polyesters and poly(ester amide)s fitted with chiral, atropisomeric binaphthylene segments were prepared by a series of low‐temperature polycondensation reactions carried out in polar solvent media. When compared with their polyaramide counterparts studied earlier, these materials had significantly improved solubility behaviors and were readily dissolved by a wide range of organic solvents. In solution, each of these constructs underwent photoinduced oscillations in optical rotatory power when subjected to multiple UV‐light/visible‐light illumination cycles that drove trans?cis isomerization reactions along their polymer chains. Light‐regulated chiroptical perturbations were dependent on polymer backbone structures and were further modulated by well‐coordinated temperature fluctuations and by the nature of the solvent medium employed. © 2005 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 207–218, 2006     

Copolymerization of N‐vinylcaprolactam and glycidyl methacrylate: Reactivity ratio and composition control

Free‐radical copolymerizations of N‐vinylcaprolactam (VCL) and glycidyl methacrylate (GMA) were investigated to synthesize temperature‐responsive reactive copolymers with minimized compositional heterogeneity. The average copolymer composition was determined by Fourier transform infrared and nuclear magnetic resonance techniques. The reactivity ratios for VCL and GMA were found to be 0.0365 ± 0.0009 and 6.44 ± 0.36 by the Fineman–Ross method and 0.039 ± 0.006 and 6.75 ± 0.29 by the Kelen–Tudos method, respectively. When prepared by batch polymerization, VCL–GMA copolymers had a highly heterogeneous composition and fractions of different solubilities in water. The use of a gradual feeding technique, which included the sequential addition of more reactive GMA monomer into the reaction, yielded copolymers with much more homogeneous composition. The produced copolymers with 0.9 and 0.11 fractional GMA contents preserved their temperature‐responsive properties and precipitated from aqueous solutions when the temperature exceeded 31 °C. The GMA units in the VCL–GMA copolymers were capable of reacting with amino end‐functionalized poly(ethylene oxide) at room temperature to produce poly(N‐vinylcaprolactam)–poly(ethylene oxide) graft copolymers. © 2005 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 183–191, 2006     

Double‐hydrophilic block copolymer for encapsulation and two‐way pH change‐induced release of metalloporphyrins

A double hydrophilic block copolymer composed of poly(acrylic acid) (PAA) and poly(4‐vinyl pyridine) (P4VP) was obtained through hydrolysis of diblock copolymer of poly(tert‐butyl acrylate) (PtBA) and P4VP synthesized using atom transfer radical polymerization. Water‐soluble micelles with PAA core and P4VP corona were observed at low (acidic) pH, while micelles with P4VP core and PAA corona were formed at high (basic) pH. Two metalloporphyrins, zinc tetraphenylporphyrin (ZnTPP) and cobalt tetraphenylporphyrin (CoTPP), were used as model compounds to investigate the encapsulation of hydrophobic molecules by both types of micelles. UV–vis spectroscopic measurements indicate that micelles with P4VP core are able to entrap more ZnTPP and CoTPP as a result of the axial coordination between the transition metals and the pyridine groups. The study found that metalloporphyrins encapsulated by the micelles with PAA core could be released on pH increase, while those entrapped by the micelles with P4VP core could be released on pH decrease. This behavior originates from the two‐way pH change‐induced disruption of PAA‐b‐P4VP micelles. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 1734–1744, 2006     

Meshless simulation of equilibrium swelling/deswelling of pH‐sensitive hydrogels

Hydrogels have been widely used in microelectromechanical systems (MEMS) and Bio‐MEMS devices. In this article, the equilibrium swelling/deswelling of the pH‐stimulus cylindrical hydrogel in the microchannel is studied and simulated by the meshless method. The multi‐field coupling model, called multi‐effect‐coupling pH‐stimulus (MECpH) model, is presented and used to describe the chemical field, electric field, and the mechanical field involved in the problem. The partial differential equations (PDEs) describing these three fields are either nonlinear or coupled together. This multi‐field coupling and high nonlinear characteristics produce difficulties for the conventional numerical methods (e.g., the finite element method or the finite difference method), so an alternative—meshless method is developed to discretize the PDEs, and the efficient iteration technique is adopted to solve the nonlinear problem. The computational results for the swelling/deswelling diameter of the hydrogel under the different pH values are firstly compared with experimental results, and they have a good agreement. The influences of other parameters on the mechanical properties of the hydrogel are also investigated in detail. It is shown that the multi‐field coupling model and the developed meshless method are efficient, stable, and accurate for simulation of the properties of the stimuli‐sensitive hydrogel. © 2005 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 326–337, 2006