Preparation of ZnO Nanoparticles: Structural Study of the Molecular Precursor

The structure of zinc acetate derived precursor currently used in the sol-gel synthesis of ZnO nanoparticles is described. The reaction products obtained before and after reflux of ethanolic zinc acetate solution have been studied by UV-Vis, photoluminescence, FTIR and EXAFS at the Zn K edge. EXAFS results evidence for both precursor solutions a change from the octahedral coordination sphere of oxygen atoms characteristic of the solid zinc acetate dihydrate compound into a four-fold environment. The EXAFS spectra of precursor solutions can be satisfactorily reproduced using the molecular structure reported for Zn₄O(Ac)₆ (Ac = COOCH₃). UV-Vis and FTIR measurements are also in agreement with the formation of this oligomeric precursor. The structural modification is more pronounced after reflux at 80°C, because the increase of the Zn₄O(Ac)₆ amount and the formation of nearly 3.0 nm sized ZnO nanoparticle.     

Polymer-protected palladium nanoparticles. Morphologies and catalytic selectivities

Colloidal palladium nanocatalysts prepared by in situ reductions of palladium chloride were immobilized and protected by either of two water-soluble polymers. The particle sizes and size distributions of the palladium colloids were determined by transmission electron microscopy. Their selectivities as catalysts were determined by comparing the extents of hydrogenation of carefully chosen pairs of small-molecule olefins. There was found to be high hydrogenation selectivity with regard to cyclic vs. noncyclic olefins. Selectivity was relatively low, however, among olefins that differed only in size (such as hexene vs. octene), or olefins differing only with regard to the positions of the double bonds (such as 1-octene vs. 3-octene). Selectivity could be improved by careful choice of the immobilizing polymer, and by its use at relatively high concentrations.     

铅笔芯修饰聚苯胺制作微型复合pH电极的性能

在0.3mm直径的铅笔芯上电修饰聚苯胺,封入玻璃毛细管中,并与Ag/AgCl电极组合成复合微型pH电极.经实验测试,该电极的pH响应特性良好,在pH1～11的线性范围内,能斯特斜率为(-56.4±0.5)mV/pH,线性相关系数不小于0.996.作为参比的Ag/AgCl电极性能稳定.由于电极是复合微型化的,所以可用于活体微区测定.     

Silver nanoparticles dispersed within amphiphilic star-block copolymers as templates for plasmon band materials

Formation of silver nanoparticles has been developed based on a template technique. Amphiphilic star-block copolymers employed as single molecule template, utilizing the coordination of Ag⁺ ions with carboxyl groups in the core of the star-block copolymer. Silver nanoparticles have been prepared by the addition of chemical reductant, e.g., NaBH₄. The solution of the resultant nanosphere composites showed yellow due to the surface plasmon resonance. These composites were soluble in organic solvents, because hydrophobic corona of the star-block copolymer protected the fabricated silver nanoparticles from aggregation.     

溶剂热法制备纳米氧化镍及其表征

以乙酰丙酮镍、油酸、油胺为原料，十八烯为溶剂，聚乙烯吡咯烷酮为表面活性剂，采用溶剂热法，在不同反应条件制备了纳米级氧化镍材料.通过X射线衍射（X-ray diffraction，XRD）、透射电子显微镜（Transmission electron microscope，TEM）、紫外-可见光吸收光谱（Ultraviolet-visible spectroscopy，UV-Vis）光谱分析以及塔菲尔（Tafel）测试考察了反应物比例、保温时间、表面活性剂（PVP）、油胺的量对产物微结构、粒径、形貌、光学以及电化学活性性能的影响.实验结果表明：在反应物n[Ni（acac）₂]∶n（OA）=1∶2、添加剂PVP质量分数为1.66%、油胺物质的量为30 mmol、200℃下保温8 h时，可获得粒径约为30～40 nm纯相氧化镍，具有最佳电化学活性，交换电流密度为J₀=1.23×10^-2 mA·cm^-2.     

高比表面积窄孔分布氧化铝的制备研究 Ⅰ.沉淀条件的影响

 以硫酸铝液为原料，以氨水、氢氧化钠和铝酸钠为碱沉淀剂，采用pH摆动法制备了高比表面积、大孔径、窄孔分布、大孔体积氧化铝，考察了沉淀剂、沉淀温度及沉淀时酸侧pH值对氧化铝物性的影响，并对pH摆动法与等pH沉淀法的结果进行了比较．结果表明，通过改变制备参数可以获得高比表面积、大孔体积的氧化铝，当沉淀温度为70℃，pH摆动3或4次时，氧化铝的孔体积可高达1．0ml／g，比表面积仍大于300m2／g．用pH摆动法制得的样品比用等pH沉淀法制得的样品容易酸溶，对挤压成型有利．不同样品在酸溶液中的分散性表明，用氨水沉淀剂可获得相对较小的沉淀粒子．改变沉淀时酸侧的pH值，可导致沉淀粒子的结构发生变化．     

Electrochemical Oxidation of Quercetin

The mechanism of electrochemical oxidation of quercetin on a glassy carbon electrode has been studied using cyclic, differential pulse and square‐wave voltammetry at different pH. It proceeds in a cascade mechanism, related with the two catechol hydroxyl groups and the other three hydroxyl groups which all present electroactivity, and the oxidation is pH dependent. Quercetin also adsorbs strongly on the electrode surface; and the final oxidation product is not electroactive and blocks the electrode surface. The oxidation of the catechol 3′,4′‐dihydroxyl electron‐donating groups, occurs first, at very low positive potentials, and is a two electron two proton reversible reaction. The hydroxyl group oxidized next was shown to undergo an irreversible oxidation reaction, and this hydroxyl group can form a intermolecular hydrogen bond with the neighboring oxygen. The other two hydroxyl groups also have an electron donating effect and their oxidation is reversible.     

Estimation of uncertainty in routine pH measurement

A procedure for estimation of measurement uncertainty of routine pH measurement (pH meter with two-point calibration, with or without automatic temperature compensation, combination glass electrode) based on the ISO method is presented. It is based on a mathematical model of pH measurement that involves nine input parameters. Altogether 14 components of uncertainty are identified and quantified. No single uncertainty estimate can be ascribed to a pH measurement procedure: the uncertainty of pH strongly depends on changes in experimental details and on the pH value itself. The uncertainty is the lowest near the isopotential point and in the center of the calibration line and can increase by a factor of 2 (depending on the details of the measurement procedure) when moving from around pH 7 to around pH 2 or 11. Therefore it is necessary to estimate the uncertainty separately for each measurement. For routine pH measurement the uncertainty cannot be significantly reduced by using more accurate standard solutions than ±0.02 pH units – the uncertainty improvement is small. A major problem in estimating the uncertainty of pH is the residual junction potential, which is almost impossible to take rigorously into account in the framework of a routine pH measurement.¹ Received: 11 August 2001 Accepted: 22 February 2002     

含金属纳米粒子的层层自组装及单壁碳纳米管的催化生长

利用层间的静电吸附作用，重氮树脂和不同种类的含金属纳米粒子被依次吸附到硅片表面形成层层自组装膜。通过改变自组装膜的层数可以控制纳米粒子在表面吸附的量，同时利用重氮树脂的光敏特性可以实现纳米粒子在表面的图案化排布。以这些纳米粒子为催化剂，研究了单壁碳纳米管在硅片表面的化学气相沉积生长。