固定pH滴定法测定弱酸弱碱性药物

报道一种水溶液吕测定弱酸弱碱性药物的新型滴定分析方法－固定ｐＨ滴定法，其理论基础是弱酸弱碱在水溶液中各种存在形式的分布系数在ｐＨ值固定时为常数，对甲硝唑，盐酸美西律等离散常数在１０＾－８至１０＾－１１范围内的７种弱酸弱碱性药物进行测定。结果与药典法吻合，回收率在９９．４％～１００．６％，方法简便，快速，准确，制剂中的赋形剂及色物不影响测定。     

All Solid‐State pH Electrode Based on Titanium Nitride Sensitive Film

Titanium nitride was used as pH‐sensitive material to fabricate all solid‐state pH electrode. The fabrication and the response performance of the pH electrode were described in the paper. The TiN film electrode showed a linear response in the pH range of 2–12 with a near‐Nenstian response (?55 mV/pH). The response time was within 1 min, and the electrode had good reproducibility, stability and low sensitivities for different species. Compared with the glass pH electrode, the electrode exhibited some advantages, for example, without activation, rapid response and high mechanical strength. In addition, the electrode performed excellently in a corrosion medium containing F^?(1 M). Electrochemical behaviors of TiN electrode in Britton‐Robinson buffers were studied with Electrochemical Impedance Spectroscopy (EIS).     

Performance of the diffusive gradients in thin films technique for measuring Ca and Mg in freshwater

Measurements of the major cations Ca and Mg by the technique of diffusive gradients in thin films (DGTs) were systematically evaluated. The concentration in solution was calculated using Fick’s first law of diffusion from the directly measured flux to the DGT device. A selective cation exchange resin (Bio-Rad Chelex^®100), which has been used extensively with DGT for trace metals, such as Cd²⁺, Cu²⁺ and Ni²⁺, was used for this work.

Elution of Ca and Mg from the resin with 1 M HNO₃ was very reproducible. Measurements of Ca and Mg concentrations in synthetic solutions agreed well with the theoretical predictions. The negative response on uptake caused by lowered pH was investigated. Uptake was found to decline below pH 5. The capacity of the DGT device for Ca and Mg was also investigated to establish maximum deployment times for given concentrations.

Experiments with filtered and modified lake water show that DGT can be used to measure Ca and Mg when trace metals are present in the solution. An in situ deployment of DGT combined with an ultrafiltration study suggest that the Mg concentration measured by DGT is similar to the concentration found in the fraction <1 kDa.     

聚对甲苯胺修饰电极的研制及其PH特性的研究

本文叙述了聚对甲苯胺修饰电极的制备及其电化学响应特性。在ＰＨ２－１３范围内电极电位与ＰＨ有良好的线性关系，电极响应应快，导电性能良好，抗干扰性能强，不受氧化还原物物质影响。用于测定饮料、湖水的ＰＨ值，结果与玻璃电极测定值基本相符。     

Potentiometric pH response of membranes prepared with various aminated-poly (vinyl chloride) products

The preparation and potentiometric pH response properties of membranes formulated with various aminated-poly(vinyl chloride) (PVC-NH₂) products are described. Products containing secondary and/or primary amino functional groups are obtained by modifying PVC with mono- and/or diamines, respectively. Blank membranes prepared with either type of aminated-polymer exhibit nearly Nernstian potentiometric pH responses over different pH ranges. In general, membranes based on diamino products exhibit pH response over a wider range (5–10.5) than membranes formulated with monoamino products (<8.0). These potentiometric results are used to estimate the basicity of the various primary and secondary amino sites in the membrane phases.Dedicated to Professer W. Simon on the occasion of his 60th birthday     

Binding Reaction of Hemin with Chloroquine, Quinine and Quinidine in Water-propylene Glycol Mixture

the interaction of hemin with chloroquine,quinine and quinidine was investigated in 50% water-propylene glycol mixture at pH=9,8.1,7.4 and 6.8using a spectrophotometric method.The data could be well fitted into a model consistent with the formation of a 1:1 complex between the reacting partners.In addition,the results indicated that hemin complexed more strongly with quinidine than with chloroquine and quinine,and the binding constants were pH-dependent.Moreover,it was proved that the water-propylene glycol mixture is well suitable to the study of the systems containing hemin and quinolinebased drugs.     

Ultrasonic-assisted leaching of trace metals from sediments as a function of pH

The effects of ultrasonication on the leaching of trace metals form sediments as a function of pH have been investigated using atomic absorption spectrometry. Cu, Pb, Ni, Zn and Mn were leached from sediments by ultrasonic effect using phthalate buffers at pH values of 2.2-6.0. Parameters influencing leaching, such as leaching time, solution matrix, wet or dry sample and final pH were evaluated. Results from ultrasonic leaching experiments were comparable to those of conventional procedure. In addition, this ultrasonic-assisted leaching method reduces the time required for conventional method approximately from 12 h to 25 min. Depending on the metal and sample type, metal removal increased linearly or exponentially with decreasing pH. The accuracy of the method was tested by comparing obtained results with this of conventional method. The average relative standard deviation (R.S.D.) of ultrasonic-assisted leaching method (ULM) varied between 1.71 and 3.00% for N = 36, depending on the analyte. This technique shows promise for studying chemical and biological availability and uptake/release processes for metals in sediment and soil as a function of pH.     

影响白砂糖色值测量结果的原因探讨

研究了水质、滤膜、溶液浓度、糖液ｐＨ值、混浊度的变化与白砂糖色值的关系。研究结果表明，溶液的ｐＨ变化影响最严重。不调整糖液ｐＨ与用ＨＣｌ或ＮａＯＨ调整糖液ｐＨ对比所得白砂糖色值的结果是满意的。标准偏差１１２～１８６，相对标准偏差１１６％～２２５％，调ｐＨ使结果偏高，导致产生系统误差。因此：测定白砂糖色值不宜调整糖液的ｐＨ。     

Preparation and characterisation of thermoresponsive poly[(N-isopropylacrylamide-co-acrylamide-co-(hydroxyethyl acrylate)] microspheres as a matrix for the pulsed release of drugs

Despite the large number of publications and patents concerning pH/thermoresponsive polymers, few data are available concerning the preparation of thermoresponsive cross-linked microspheres from preformed polymers. Therefore, N-isopropylacrylamide-co-acrylamide-co-(2-hydroxyethyl acrylate) copolymers were obtained as a new thermoresponsive material with a lower critical solution temperature (LCST) around 36 degrees C, in phosphate buffer at pH 7.4, and with a cross-linkable OH group in their structure. The LCST value was determined both by UV spectroscopy and microcalorimetric analysis. These copolymers were solubilised in acidified aqueous solution below their LCST, dispersed in mineral oil, and transformed into stable microspheres by cross-linking with glutaraldehyde. The thermoresponsive microspheres were characterised by optical and scanning electron microscopy, degree of swelling, and water retention. The pore dimensions of the microspheres and the retention volumes of some drugs and typical compounds were evaluated at different temperatures by liquid chromatography. Indomethacin, as a model drug, was included in the microspheres by the solvent evaporation method. Finally, the influence of temperature and of temperature cycling on drug release was investigated.     

静电和疏水效应对TGEV主蛋白酶二聚体稳定性的影响

从TGEV 3CL蛋白酶二聚体结构出发,研究了TGEV 3CL蛋白酶二聚体单体之间的静电和疏水相互作用.蛋白质的静电相互作用通过有限差分方法求解Poisson-Boltzmann方程得到,疏水相互作用通过分析溶剂可及性表面模型得到.考察了不同pH值对TGEV 3CL蛋白酶二聚体静电和疏水相互作用的影响,在pH值为5.5～8.5时,二聚体静电相互作用能、静电去溶剂化能和疏水自由能都较小,表明在该条件下静电和疏水相互作用有利于二聚体的稳定存在,这符合实验结晶所需条件.pH值对静电去溶剂化能的影响大于疏水自由能,表明静电作用是造成强酸或强碱条件下二聚体不能稳定存在的主要原因.