Charge transport properties in carbon black/polymer composites

The charge transport properties of polymer matrix–carbon black composites are investigated in this study. Direct current conductivity is examined with varying parameters: the temperature and the conductive filler content. Conductivity data are analyzed by means of percolation theory, and both percolation threshold and critical exponent are determined at each of the examined temperatures. The temperature dependence of conductivity and the agreement of experimental results with the variable range hopping model reveal hopping conduction as the predominant transport mechanism, below and in the vicinity of the critical concentration of carbon black particles. At higher concentrations, the contribution of hopping transport to the overall conductivity is reduced and a balance between hopping and conduction via geometrical contact occurs. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 2535–2545, 2007     

LES of turbulent heat transfer: proper convection numerical schemes for temperature transport

Large eddy simulations of two basic configurations (decay of isotropic turbulence, and the academic plane channel flow) with heat transfer have been performed comparing several convection numerical schemes, in order to discuss their ability to evaluate temperature fluctuations properly. Results are compared with the available incompressible heat transfer direct numerical simulation data. It is shown that the use of regularizing schemes (such as high order upwind type schemes) for the temperature transport equation in combination with centered schemes for momentum transport equation gives better results than the use of centred schemes for both equations. Copyright © 2004 John Wiley & Sons, Ltd.     

Novel fixed‐site–carrier polyvinylamine membrane for carbon dioxide capture

Fixed‐site–carrier membranes were prepared for the facilitated transport of CO₂ by casting polyvinylamine (PVAm) on various supports, such as poly(ether sulfone) (PES), polyacrylonitrile (PAN), cellulose acetate (CA), and polysulfone (PSO). The cast PVAm on the support was crosslinked by various methods with glutaraldehyde, hydrochloric acid, sulfuric acid, and ammonium fluoride. Among the membranes tested, the PVAm cast on polysulfone and crosslinked by ammonium fluoride showed the highest selectivity of CO₂ over CH₄ (>1000). The permeance of CO₂ was then measured to be 0.014 m³ (STP)/(m² bar h) for a 20 μm thick membrane. The effect of the molecular weight of PVAm and feed pressure on the permeance was also investigated. The selectivity increased remarkably with increasing molecular weight and decreased slightly with increased pressure in the range of 1 to 4 bar. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 4326–4336, 2004     

电激励O2（1△g）发生器的理论模拟研究

 建立了基于分子反应动力学的氧等离子体化学反应模型，该模型包括了电子与氧分子，以及氧原子与氧分子的碰撞反应过程。利用反应动力学理论计算并讨论了电激励O₂(¹△)发生器的放电参数，发现电子能量应小于2.5eV。电子浓度对O₂(¹△)产率的影响不大，当放电压力与气体线流速一定时，存在最佳的电子平均能量。     

静电加速管中强流空间电荷效应的研究

 对一种工业用大功率电子加速器(450kW)的加速管中的空间电荷效应作了5点假设，建立了物理模型。对模型的束内外径向电位分布、空间电荷对轴上电位的影响，以及空间电荷力对束流传输的影响等进行了理论分析，得到了束内径向电位分布。结果表明：束流内部径向电位沿径向均呈抛物线变化，并在轴上达到最小值；而空间电荷产生的束内电场与半径呈线性变化；空间电荷不仅会引起轴上电位的跌落，而且对束流有发散作用，特别是在电子速度较低时更为明显。在考虑了空间电荷效应后，强流静电加速管的电场设计关键在加速管的前端，与弱流加速管相比，强流加速管的电场变化要大得多。     

横向射流式单重态氧发生器的性能实验研究

 对氧碘化学激光器的单重态氧发生器（SOG）进行了改进，采用横向射流方式，并对该横向射流式单重态氧发生器的性能进行了检测。实验中过氧化氢碱溶液温度控制在－16℃左右,氯气流量为530mmol/s，He与氯气的流量比为3;采用PS法测量单重态氧分子的产率,吸收法测量氯气的利用率和相对水含量。得出如下结论:在不使用冷阱和分离器的情况下，最高单重态氧分子产率达到58%, 氯气利用率在80%以上,相对水含量小于等于0.5;气体达到最大流量时,发生器仍然能稳定地工作。     

Modelling of an underground waste disposal site by upscaling

In this paper, we study the global behaviour of an underground waste disposal in order to have an accurate upscaled model suitable for the computations involved in safety assessment processes. We start from a detailed model describing the transport of pollutant leaking from a high number of units. Using the method of homogenization, going to the limit, we obtain first a macroscopic model where the sources are now appearing globally. Then we compute a first‐order matched asymptotic expansion and we give the error estimates for this approximation. Copyright © 2004 John Wiley & Sons, Ltd.     

Anisotropic transport of charge and complexified duality

Charge transport in two dimensions provides an ideal laboratory for investigating parameter space geometries. The Onsager relations for anisotropic transport in a parity-violating external field endow these spaces with a highly nontrivial complex (and Kähler) structure, which can be given a simple geometrical interpretation. A large class of Coulomb gases exhibiting this structure have a generalized Kramers-Wannier symmetry (complexfield duality) which is contained in the modular group. Knowledge of this symmetry and the degrees of freedom encoded in the Coulomb gas appear to be sufficient to determine the global phase diagram and the renormalization group fixed-point structure, including the critical exponents. This accounts for all the scaling behavior observed so far in the quantum Hall system.     

射流式单重态氧发生器研究

单重态氧O2 (a1Δg)是迄今唯一能用纯化学反应高效产生的具有长寿命的亚稳激发态分子 .为了考察提出的用两个O2 (1Δ)能量汇集反应生成氧第二单重激发态O2 (b1Σ+ g)以实现近可见短波长化学激光方案的现实性 ,设计和实验了一个氯流量为 3～ 10mmol/s的射流式单重态氧发生器 (JSOG) .考察了三种具有不同孔径和孔数目的喷头、氯气流量和脱水冷阱温度等对JSOG出口的O2 (1Δ)浓度、O2 (1Δ)分压、氯利用率及水蒸气含量的影响 .发现用聚氯乙烯管作冷阱时 ,最佳冷阱介质温度为 - 140～ - 15 0℃ ,对此提出了O2 (1Δ)表面脱活与脱水互相竞争的解释 .在最佳条件下 ,可将O2 (1Δ)气中水分压降低至 4Pa ,这一结果是首次报导     

事后分层方法及其在交通运输抽样调查中的应用

本文介绍事后分层技术，说明了它不仅可用于简单随机抽样，而且可以用于放回ＰＰＳ抽样。给出了事后分层估计量的形式，证明了它的无编性，并给出了它在交通运输抽样调查中的应用。