Analysis by liquid chromatography‐tandem mass spectrometry of biophenolic compounds in virgin olive oil,Part II

In this study the qualitative and quantitative content of the biophenolics in virgin olive oils is evaluated by liquid chromatography‐tandem mass spectrometry. The extraction and purification method for these compounds from virgin oils was optimised. After liquid‐liquid and solid‐phase extraction the separation of 35 of these compounds was achieved on reversed phase in gradient mode. The detection was preliminarily by UV and fluorescence, but then the final choice was ion‐spray tandem mass spectrometry in multiple reaction monitoring mode in negative ionization, acquiring two diagnostic product ions from the chosen precursor [M—H]^–. Using this last approach we obtained the best sensitivity, selectivity, and specificity. The recovery of the method ranged from 70–90% and detection limits were less than 1 ng for all the analyzed compounds.     

LiCl对Fe_2O_3/SiO_2甲烷氧化偶联反应的助催化作用

使用穆斯堡尔谱，ESR和XRD等技术表征了未添加助剂和添加LiCl的Fe2O3／SiO2催化剂．XRD结果指出，添加LiCl的Fe2O／SiO2催化剂出现铁酸盐和α-方石英的衍射峰，这种结果的出现与该催化剂有较高的C2烃选择性密切相关。穆斯堡尔谱结果表明：添加LiCl的Fe2O3／SiO2催化剂有更高的结构对称性．这种结构对分子氧的活化起着重要的作用．氯的存在大大降低了氧的离解吸附的速率，减少了原子氧的吸附位的数目，并可除去吸附的原子氧，该氧种对COx的生成有利．     

Effects of Oxygen and Water Vapor on Volatile Organic Compounds Decomposition Using Gliding Arc Gas Discharge

The combined effects of oxygen and water vapor on three typical volatile organic compounds, i.e. tetrachloromethane, n-butane and toluene, decomposition efficiency under gliding arc gas discharge conditions are studied. The electron density and the density of the reactive radicals such as O and OH are modified by addition of oxygen and water vapor. Consequently, the decomposition process can be enhanced or suppressed, depending on the involved chemical structures and reaction channels. The addition of oxygen and water vapor suppresses the tetrachloromethane decomposition which indicates that this process is mainly controlled by the electron dissociation reactions. By contrast, the n-butane and toluene decompositions are enhanced, which shows that they can be mainly ascribed to the radical induced reactions. Especially, in a moist atmosphere the OH radicals are supposed to play the most important role in the n-butane decomposition process.     

PHOTOCATALYTIC HYDROGEN EVOLUTION FROM WATER SPLITTING UNDER VISIBLE LIGHT IRRADIATION ON NOVEL PHOTOCATALYST FULLENES-PVP-ZN0.999NI0.001S

Fullerenes (C60/C70) linked up to Ni-doped ZnS through the medium of an amphalic polymer polyvinyl pyrrolidone (PVP) to form a new kind of photocatalyst for hydrogen evolution from aqueous Na2S/Na2SO3 solution under visible light irradiation, the photocatalytic activities of this novel photocatalyst C60/C70-PVP-Zn0.999Ni0.001S are 3-5 fold higher compared with that of precurse catalyst Zn0.999Ni0.001S. This result could be attributed to Schottky barrier layer built between C60/C70 and Zn0.999Ni0.001S due to the electro-negativity of C60 and characteristic of being used as a multiple electron acceptor. C60 or C60/C70, its moiety, with its low energy first excited singlet state, is a good energy acceptor and in addition readily accepts multiple electrons, making it a potential electron accumulate as we know, which could protect the separation between electrons and holes against combination. This is an important reason for the marked increase of amount of H2 evolution during the photocatalytic process for the composite system C60/C70-PVP-Zn0.999Ni0.001S.     

CePO_4/Ce-ZrO_2可加工陶瓷性能与断裂机制研究

以Ce ZrO2为基体,通过复合不同加入量的第二相CePO4颗粒,研究了陶瓷材料力学性能的变化,并借助加载能谱仪(EDS)的扫描电子显微镜(SEM)对材料弯曲断口及压痕裂纹扩展方式进行分析。当CePO4加入量为25%时,虽然材料力学性能有一定下降,但已经能用WC刀具进行加工。材料的弯曲断口显示,CePO4在两相体系中的断裂呈层片状形式;加入CePO4后,由于两相之间弱结合界面的存在,压痕裂纹扩展形式发生明显变化,由连续扩展机制过渡为不连续扩展。由这两种机制形成的材料断裂过程是阶段性的,在实际中可以用作材料最终破坏前的预报。     

还原对Ag/SiO2催化剂高效合成吲哚的影响

以Ag／SiO2作为苯胺和乙二醇一步合成吲哚的催化剂，首次研究了还原对催化剂活性和选择性的影响．结果表明，催化剂前体在150℃以下用氢气含量不超过50%(mol)的氢-氮混合气原位还原其活性和选择性较高．     

制备方法对MoO_3／ZrO_2结构的影响及MoO_3／ZrO_2固体超强酸的结构特征 Ⅰ．ZrO_2的形态与样品比表面的研究

ＸＲＤ，ＤＴＡ，比表面测定等结果表明，制备方法对ＭｏＯ３／ＺｒＯ２结构有决定性影响．仲钼酸铵浸渍仅经干燥的Ｚｒ（ＯＨ）４再经高温焙烧所得团体超强酸ＭｏＯ３／ＺｒＯ２（Ⅰ）与浸渍晶态ＺｒＯ２所得部分氧化催化剂ＭｏＯ３／ＺｒＯ２（Ⅱ）的载体形态有明显不同．（１）ＭｏＯ３／ＺｒＯ２（Ⅰ）的比表面数倍于ＭｏＯ３／ＺｒＯ２（Ⅱ）；（２）ＭｏＯ３含量增加时，ＭｏＯ３／ＺｒＯ２（Ⅰ）的比表面逐步增大至一极大值再缓缓下降，而ＭｏＯ３／ＺｒＯ２（Ⅱ）的比表面随ＭｏＯ３含量增加而单调下降；（３）在ＭｏＯ３／ＺｒＯ２（Ⅰ）中，ＺｒＯ２以介稳四方相存在，而在ＭｏＯ３／ＺｒＯ２（Ⅱ）中则是稳定的单斜相．在此基础上研究了事先引入的活性组分在载体织构形成过程中的作用，包括延迟ＺｒＯ２晶化，阻碍晶粒长大及与之相关的相变等，并讨论了ＭｏＯ３／ＺｒＯ２（Ⅰ）中ＭｏＯ３最佳含量的科学含义．     

酞菁氧钛的合成及晶型转化

酞菁氧钛以联环己烷为溶剂，以邻苯二脂及四氯化钛直接反应生成。其优点是便于分离及纯化。同时对各晶型的获得及晶型间的相互转化进行了研究，并以Ｘ－射线粉末衍射及ＦＴ－ＩＲ进行了表征，并记录了不同晶型的酞菁氧钛在室温硫化硅橡胶中的吸收光谱。     

Synthesis of poly(styrene-co-3-trimethoxysilyl propyl methacrylate) microspheres coated with polysiloxane layer

A procedure has been developed to coat micron-sized poly(styrene-co-3-trimethoxysilyl propyl methacrylate) microspheres with a smooth layer of polysiloxane by the hydrolysis and condensation of methyl trimethoxylsilane (MTMS). Firstly, polystyrene microspheres containing silanol groups were prepared by conventional dispersion polymerization using 3-(trimethoxysilyl) propyl methacrylate (MPS) as a functional comonomer in an ethanol/water medium. Secondly, the synthesis of the polysiloxane shell was carried out using a sol–gel process of MTMS. The thickness of the shells can be easily varied with different copolymer seeds and MTMS feed ratio. When we used copolymer particles with 2.00 μm diameter as seeds, the thickness of the polysiloxane shells can be varied from 0.10 to 0.18 μm. The core/shell structure of the composite microspheres was characterized by transmission electron microscope (TEM).     

Towards accreditation of clinical biochemistry in the public sector on the island of Mauritius

Medical laboratories of the public sector as well as of the private sector on the island of Mauritius are preparing for accreditation. The clinical laboratory of the Central Health laboratory of the Ministry of Health and Quality of Life has undergone a pre-assessment by experts of the International Atomic Energy Agency (IAEA) through the aegis of a project targeted to members of the Africa Region. Several shortcomings were identified and respective corrective actions were recommended for implementation within a given time frame. In addition to ensuring the competence of the laboratory, accreditation has various positive aspects such as an increased awareness of the staff to quality and better training opportunities. The pre-assessment exercise has provided a gap analysis, which is an important aspect in the preparation towards accreditation.