以短链季铵盐/脂肪酸盐为模板合成超微孔二氧化硅

超微孔材料具有1~2 nm的孔径,在分离、催化应用中有望展现出择形催化的能力。 寻找经济、简便的合成超微孔材料的表面活性剂体系是一项有意义的工作。 本研究以短链季铵盐(十烷基三甲基溴化铵,记为C₁₀TAB)和不同链长脂肪酸酸盐混合胶束为模板剂,硅酸钠为硅源,成功制备出高度有序超微孔SiO₂。 通过小角X射线衍射、N₂吸附-脱附、傅里叶变换红外光谱、扫描电子显微镜(SEM)和透射电子显微镜(TEM)等技术手段对产品的结构和性能进行了表征。 结果表明,合成体系中脂肪酸盐碳链长、加入量、晶化温度等对产物孔道有序性有很大影响。 当选择正辛酸钠(SO)为助表面活性剂,当n(C₁₀TAB):n(Na₂SiO₃):n(SO):n(H₂O)=1:1.5:0.3:800,晶化温度为80 ℃时,可以得到高度有序超微孔SiO₂。 煅烧后样品比表面积为1300 m²/g,孔体积0.49 cm³/g,孔径分布在1.90 nm。     

Monolayer films of PS-b-PEO diblock copolymers at the air/water- and an oil/water-interface

 Amphiphilic diblock copolymers consisting of a hydrophobic polystyrene block (PS) and a hydrophilic poly(ethylene oxide) block (PEO) with block sizes of 1000 or 3000 g/mol for both blocks were studied at the air/water and toluene/water interface. Measurements of the film pressure π of spread monolayers at the water surface reveal two limiting regimes of the π−a _m isotherms, in which the mean molecular area a _m is determined either by the size of the hydrophilic or the hydrophobic blocks of the PS-PEO molecules. The interfacial activity of the block copolymers at the toluene/water interface was studied by measuring the interfacial tension σ over a wide range of concentrations. Pronounced differences in the temperature dependence of the interfacial tension were observed, depending mostly on the block length of the hydrophilic PEO block. From the temperature dependence of σ it is inferred that for the block copolymers with the PEO block size of 3000 g/mol the phase inversion temperature (PIT) is well above 60 °C while for those with a PEO block size of 1000 g/mol the PIT is below or near 25 °C in the toluene/water system. Received: 5 February 1998 Accepted: 16 February 1998     

Mixtures of branched non-ionic oligo-oxyethylene surfactants in aqueous solutions — the effect of molecular geometry on LC phase behaviour 4

The LC phase behavior of ternary mixtures of the two corresponding branched non-ionic surfactants 1,3-bis-(methoxy-tetraoxyethylene)-2-propoxy-tetradecane (Y-surfactant) and 1,3-bis-(heptyloxy)-2-propoxyoctaoxyethylene mono-methyl ether (V-surfactant) and water were studied by polarizing microscopy. The two branched surfactants, which have different molecular geometries but nearly the same hydrophilic-lipophilic volume ratio, exhibit extremely different phase behavior in binary surfactant/water systems. For the ternary mixtures of Y- and V-surfactant and water we found-according to established packing models-a continuous stabilization of the cubic and hexagonal phases and a destabilization of the lamellar phase with increasing amount of Y-surfactant. On the other hand, we observed a thermal stabilization of the lamellar phase. The maximal transition temperatures of the lamellar phase pass a maximum with increasing amount of Y-surfactant.     

Mixed Cationic‐nonionic Surfactants and pH Adjustment Route to Synthesize High‐quality MCM‐48

Using the mixture of cetyltrimethylammonium bromide (CTAB) and p‐Octyl polyethylene glycol phenyl ether (OP‐10) as templates, siliceous MCM‐48 materials can be synthesized with low molar ratio of CTAB to silica (0.139:1) and low concentration of mixed surfactants (ca.5%) and within a wide range of OP‐10/CTAB ratio (0.08?0.25). The materials were characterized by X‐ray powder diffraction, N₂ adsorption/desorption isotherm, TEM, TG‐DSC and ²⁹Si MAS NMR. Measurements indicated that the use of mixed surfactants allowed better condensation and higher ordering of the cubic mesostructure; at the same time, some properties of these materials were sensitive to the OP‐10/CTAB ratio. It was also found that the reduced pH of the gel which had been crystallized for a certain time gave a highly reproducible synthesis with a high silica yield (about 95%). Furthermore, the reaction mechanism of the synthesis is discussed in detail.     

Determination of the partition coefficients of the nonionic detergent C12E7 between lipid-detergent mixed membranes and water by means of Laurdan fluorescence spectroscopy

The membrane-water partition coefficient of the detergent C₁₂E₇ between water and C₁₂E₇/POPC mixed membranes has been determined by means of steady-state fluorescence spectroscopy. The emission spectra of the fluorescent probe Laurdan were used as an indicator of membrane composition at different membrane concentrations in the sample. The partition coefficient expressed as the ratio of the mole fractions of the detergent in the membrane and water phases is about 6^*10⁵ at low molar ratios of C₁₂E₇/POPC (R _c ) and decreases rapidly with increasingR _c . The limiting detergent content of the lamellar phase (R _c ^* >0.8) is indicated by a minimum ofP(R _c ).     

Functional polythiiranes 7: Surface activity of polythiiranes with PEO side chains

 Some comb-like polythiiranes with PEO side chains were prepared from the corresponding macromonomers. These new materials are amphiphiles and act as surfactants. Their surface tension and interfacial tension are measured and studied in this paper on account of their structures. The lowering of surface tension measured in polymers bearing methyl terminal group in PEO side chains, are in the same range as these observed with polymers of identical structures but different main chains. An increase of the hydrophobic units in the main chain, obtained in copolymers with methylthiirane does not significantly modified the surface tensions. Better lowering is afforded with structures bearing large alkyl groups as terminal group of PEO side chains. On the contrary, some of these macro-molecules with an optimized EO content largely lower the water/xylene surface tension. The main interest of these new materials is their very low cmc and the stabilization of L₁-type microemulsions. Received: 20 May 1997 Accepted: 25 November 1997     

Self aggregation of binary mixtures of sodium dodecyl sulfate and polyoxyethylene alkyl ethers in aqueous solution

The mixed micelles of sodium dodecyl sulphate (SDS) with Brij35 and Brij 97 were studied separately by fluorescence measurement using pyrene as fluorescent probe. In the range of 0–1.0 mole fraction (X) of added SDS to Brij solutions, the cmc value of the mixed micelles varies from 0.085 to 8 mmol with Brij 35 and 0.04 to 8 mmol with Brij 97. The aggregation number also changes. A measure of the stability of mixed micelles is also presented. The interaction parameter ₁₂ and the chain–chain contribution parameter (B₁) are extracted from the analysis of the results. This parameter B₁ is related to the standard free energy change associated with the introduction of one ionic species into a nonionic micelle coupled with the release of one nonionic species from the micelle. The clouding behaviour of Brij 97 in the presence of SDS was investigated and the associated thermodynamic parameters of clouding were generated and discussed.     

Synthesis and Luminescence Property of 4,4＇-Bis（2,2-di（4-fluorophenyl）vinyl）biphenyl for Organic Blue-Light-Emitting Diodes

The novel fluorinated distyrylarylene, 4,4＇-bis（2,2-di（4-fluorophenyl）vinyl）biphenyl （DFPVBi）, was synthesized and fully characterized. The structure was confirmed with IR, 1↑H NMR, 13↑C NMR, 19↑F NMR and MS analyses. Its electronic and photoluminescence properties were investigated by UV-Vis absorption, cyclic voltammetry and fluorescence spectroscopy. The energy levels of the highest occupied molecular orbital （HOMO） and the lowest unoccupied molecular orbital （LUMO） are --5.77 and --2.75 eV, respectively. The electroluminescence proper- ties of the organic light-emitting diode fabricated by DFPVBi were also studied. The device exhibits a pure blue emission peaked at 454 nm, which indicates a maximum luminance of 5872 cd/m ^2 at 14.2 V and a maximum current efficiency of 2.82 cd/A at 10V, respectively.     

A 1H NMR study of 1,4-bis(N-hexadecyl-N, N-dimethylammonium)butane dibromide/sodium anthranilate system: spherical to rod-shaped transition

The effect of addition of sodium anthranilate to 5 mM micellar solutions of gemini surfactant 1,4-bis(N-hexadecyl-N,N-dimethylammonium)butane dibromide is investigated by ¹H NMR. The solubilization site of anthranilate anion near the micellar surface is inferred. In the micelles, the An⁻ ions intercalate among the surfactant headgroups producing morphological changes.     

The Interactions Between Nonionic Surfactants and Cyclodextrins Studied by Fluorescence Measurements

The complex formation between some nonionic surfactants and -, - and -cyclodextrin was studied by fluorescence measurements. The relative fluorescence intensity of a solute containing a nonionic surfactant at a constant concentration far below the critical micelle concentration (CMC) are enhanced by the addition of cyclodextrins. Non linear type equations were derived to obtain stability constants by fluorescence measurements for inclusion complexes formed between cyclodextrins and the nonionic surfactants. In most cases 1 : 1- and 2 : 1-complexes (ratio of cyclodextrin to surfactant) are formed.