Uniformity in radon exhalation from construction materials using can technique

The uniformity in radon exhalation rates for 46 tiles of granite, marble and ceramic used as construction materials were determined using “Can Technique” employing CR-39 nuclear track detectors (NTDs). On each tile, two sealed cans, each enclosing one NTD fixed at the center of the tile surface area covered by the can, were mounted at two different locations of each individual tiles. The track production rates on the NTDs representing radon exhalation rates were measured. The radon exhalation rates from the surface of individual tiles showed uniform exhalations within the calculated uncertainties of the measured values. This makes Can Technique an alternative simple method to measure radon exhalation rates. Calibration required to convert track production rates into radon exhalation rates for the used can and NTD was done using an active technique. The correlation between the measurements by the two techniques shows a good linear correlation coefficient (0.83).     

单光子探测器量子效率的绝对自身标定方法

提出一种单光子探测器量子效率的绝对自身标定方案，利用光参量下转换过程中产生的光子对在时间上的相关性，先将参量光束分为两路，然后引入相对延时，使同时产生的孪生光子先后进入单光子探测器，然后将探测器之后的电路分为三路，其中一路直接进入计数器得到探测器所探测到的光子的总计数率，另两路用电路方法引入和光路相当的相对延时，经符合电路后进入计数器，得到前后到达探测器的光子对之间的符合计数率.这样，从符合计数率与总光子计数率之比即可在不需要任何其他探测器或者参照标准的情况下获得探测器的量子效率.文中给出两种方案，分别适     

Memory effects in gas chromatographic detection with a microwave-induced plasma

Capillary gas chromatography coupled to microwave-inducedplasma detection furnishes sensitivity adequate for trace analysis when the signal is monitored at a carbon emission line. Work performed with one of these systems at high electronic gain for the carbon signal has revealed solvent band widths in excess of four minutes; these impeded quantification of peaks eluting after the solvent. This report discusses two phenomena which could be related to the unexpected intensity of this solvent response: photomultiplier tube saturation and carbon deposits in the quartz plasma discharge tube.     

惯性约束中子测温的误差研究

综合分析了ＩＣＦ（惯性约束）中子测温系统的误差与其参数的关系，这些参数包括靶核温度，探测的中子数、靶到探测器的距离、探测器的响应函数以及闪烁体厚度等，考虑到中子与探测器的相互作用，探测器的响应与靶的烧蚀过程，在此基础上提出了新的统计误差计算方法，该方法对于改善中子测温的相对误差并应用于闪烁体的设计具有重要意义。     

CdZnTe核探测器的蒙特卡罗模拟的初步研究

以CdZnTe核探测器的工作原理为依据,探测器内反应的随机性和反应产生的电子空穴对数目的统计规律为物理模型,应用Visual C + + 自行编制了蒙特卡罗模拟软件.模拟了γ射线在CdZnTe探测器中的响应能谱,并将模拟结果与实际器件的测试结果进行了比较讨论.模拟能谱与实际测得的能谱的主峰符合较好.此外,通过分析⁵⁷Co源辐照下探测效率与器件厚度的关系,可以推测探测效率达到最大时所对应CdZnTe探测器的理想厚度     

Letter: Interpolating Between the Bose-Einstein and the Fermi-Dirac Distributions in Odd Dimensions

We consider the response of a uniformly accelerated monopole detector that is coupled to a superposition of an odd and an even power of a quantized, massless scalar field in flat spacetime in arbitrary dimensions. We show that, when the field is assumed to be in the Minkowski vacuum, the response of the detector is characterized by a Bose-Einstein factor in even spacetime dimensions, whereas a Bose-Einstein as well as a Fermi-Dirac factor appear in the detector response when the dimension of spacetime is odd. Moreover, we find that, it is possible to interpolate between the Bose-Einstein and the Fermi-Dirac distributions in odd spacetime dimensions by suitably adjusting the relative strengths of the detector's coupling to the odd and the even powers of the scalar field. We point out that the response of the detector is always thermal and we, finally, close by stressing the apparent nature of the appearance of the Fermi-Dirac factor in the detector response.     

描述光伏效应的新解析模型

 对陆启生等人提出的描述光伏效应的解析模型涉及的边界条件进行了讨论，提出了一个适用性更宽的解析模型。通过对新模型、陆的模型以及另一个解析模型的比较，对前两个模型能够描述光伏型光电探测器在强光辐照时的信号饱和效应的原因进行了解释。     

气垫导轨上运动物体加速度测量方法的改进

利用计数计时测速仪测量气垫导轨上滑块运动的加速度,其测量精度直接依赖于2个光电门之间距离的测量,而在实验中该距离的测量往往不易达到很高的精度,致使加速度的测量精度不高.对计数计时测速仪的电路和单片机程序稍加修改,使之能测出滑块从一个光电门运动到另一个光电门所需时间,就无需测量2个光电门之间的距离,因而提高了加速度的测量精度,节约单片机的资源并缩短运行时间.     

Determination of the boiling point distribution of sulfur compounds in light cycle oil using GC with a flame photometric detector and pyrolyzer

A method has been developed to determine the boiling point distribution of sulfur compounds in light cycle oils (LCO'S). The method chosen for this analysis was GC with a flame photometric detector (FPD) and pyrolyzer. Tests were carried out to evaluate the recovery efficiency, repeatability, and accuracy of the method. Repeatabilities within 2% were obtained. The recovery of benzothiophenes and dibenzothiophenes was close to 100%; this was important because these are the major sulfur components in LCO's. No hydrocarbon or solvent interferences were observed with the use of the pyrolyzer, even for a 95% solvent level. Comparison with results from other techniques showed that the method accurately determined the levels of sulfur compounds in the LCO boiling point range.     

Nitro musks in cosmetic products—determination by headspace solid-phase microextraction and gas chromatography with atomic-emission detection

Summary The combination of headspace solid-phase microextraction with atomic-emission detection enables highly selective and sensitive determination of itro musk compounds in cosmetic products. Sample preparation is considerably simplified; there is no solvent extraction step. Enrichment is influenced by the type and amount of cosmetic product investigated. The lowest amount giving well detectable peaks is 1 mg musk compound per kg sample. Calibration curves obtained from spiked solutions of selected reference cosmetics in water show very good linearity. Relative standard deviations of peak areas from repeated measurements are usually <10%. Presented at the 21^st ISC held in Stuttgart, Germany, 15^th–20^th September, 1996