Aqueous Titanate Sols from Ti Alkoxide-α-Hydroxycarboxylic Acid System and Preparation of Titania Films from the Sols

Aqueous titanate sols were prepared by reactions of titanium tetraisopropoxide (TIP) with -hydroxycarboxylic acids in water. IR and Raman spectra, and elemental analyses of the precipitates obtained from the sols revealed that the carboxylates were chelated to titanium but the Ti species were polymerized to form a cluster that had a colloidal nature. Spin-coating of titania (TiO₂) thin films from these sols was also examined. Interestingly, it was found that (004) preferentially oriented anatase films with refractive index of 2.54 were obtained from TIP-lactic acid-NH₃ (1:1:1, molar ratio) aqueous sol. This crystallographic orientation was characteristic of the TIP-lactic acid-NH₃ (1:1:1) system, and was not affected by the kinds of substrates used and the heating rate of the film. TEM observation indicated that small anatase grains had already formed at 200°C. Therefore, the crystallographic orientation might depend strongly on the structure of the chemical species of the precursor solutions.     

Synthesis, characterisation and evaluation of polydithiocarbamate resin supported on macroreticular styrene-divinylbenzene copolymer for the removal of trace and heavy metal ions

A new chelating resin was synthesised by the modification of styrene-divinylbenzene (2%) copolymer and incorporation of dithiocarbamate groups. The polydithiocarbamate resin was characterised by elemental analysis, thermal studies and IR studies. The analytical characteristics of the sorbent were established and optimum sorption conditions for Cu, Ni, Pb, Fe, As and Mn determined. The total sorption capacity of the resin was 37 mg g⁻¹ for Ni(II), 35 mg g⁻¹ for Cu(II), 29 mg g⁻¹ for Fe(III) and 23 mg g⁻¹ for Pb(II). The optimum pH for the removal of metal ions was 3-5 for Ni(II), 5 for Cu(II), 4 for Fe(III) and 4-5 for Pb(II). High sorption capacity was observed when compared with other conventional chelating polymers. The sorption kinetics was fairly rapid, as apparent from the loading half time t_1/2 values, indicating a better accessibility of the chelating sites.     

Palladium-catalyzed regio- and diastereo-selective allylic alkylation using 2-(diphenylphosphino)benzoic acid: construction of vicinal quaternary and tertiary carbon centers

The palladium-catalyzed regio- and diastereo-selective allylic alkylation of allyl acetates with carbon nucleophiles occurred. The stereochemistry was highly controlled by the palladium catalyst with 2-(diphenylphosphino)benzoic acid as the ligand, and vicinal quaternary and tertiary carbon centers were constructed.     

MS/MS in structural analysis of an oviposition-deterring pheromone

A recently characterized oviposition-deterring pheromone (ODP, structure 1) of the European cherry fruit fly was used as a test case for probing the potential of tandem mass spectrometry (MS/MS) in structure elucidation as a stand-alone technique. The glycolipid-taurinate 1 was subjected to MS/MS analyses under a variety of conditions with and without preceding chemical degradation. Acidic methanolysis of 1 and subsequent in-batch derivatization (trideuterioacetylation) yielded methyl 2,3,4,6-tetrakis-O-trideuterioacetyl-glucopyranoside (2), methyl 8,15-bis-trideuterioacetoxy-palmitate (3), and taurine (4) as suitable target compounds for direct mixture analysis.Low energy collision induced dissociation (CID) on selected precursor ions (MS/MS on [M + H – CH₃OH]⁺ and [M + H]⁺ produced by fast atom bombardment (FAB)) allowed direct identification of 2 and 4, respectively, by comparison with appropriate reference ions. In the case of 3, low energy CID (desorption chemical ionization (DCI) instead of FAB, MS/MS on [M + H]⁺) permitted deduction of gross molecular structure, but failed to provide positional detail. In sharp contrast,high energy CID of trideuterioacetylated intact 1 (FAB-MS/MS on [M – H]^– ions of la) clearly revealed a linear 8,15-hydroxylated palmitic acid backbone. Less certain was assignment of 15-O-glucosylation by this approach.     

3—Mercaptopropionic Acid Capped Gold Nanoclusters：Quantized Capacitance in Aquesous Media

3-Mercaptopropionic acid monolayer protected gold nanoclusters (MPA-MPCs) were synthesized and characterized by transmission electorn microscopy,UV-Vis spectroscopy,X-ray photoelectron spectroscopy and Fourler transform infrared spectroscopy.The exact value of quantized double-layer capacitance of MPCs in aqueous media was obtained by differential pulse voltammograms.     

应用扫描电化学显微镜研究电子在室温离子液体与1,2-二氯乙烷混合溶液/水相界面上的转移反应

应用扫描电化学显微镜研究了室温离子液体(Omim·Tf2N)与1,2-二氯乙烷(DCE)混合溶液/水界面上的电子转移反应. 在保持共同离子(Tf2N-)的浓度比恒定及异相电子转移反应由界面电势差所决定的条件下, 研究了离子液体和DCE混合溶液中二茂铁(Fc)与水相中亚铁氰化钾[K4Fe(CN)6]之间异相电子转移反应. 探讨了混合溶液中离子液体的体积分数(xRTIL)的变化对混合溶液/水界面上电子转移反应的影响. 结果表明, 随着xRTIL的减小(从1减小到0.1), Fc在混合溶液中的扩散系数单调递增(从2.730×10-7 cm2·s-1增加到9.131×10-6 cm2·s-1); 而异相电子转移反应速率常数(k)则先逐渐减小(从8.0 mol-1·cm·s-1减小到0.32 mol-1·cm·s-1), 之后又略有增大(从0.32 mol-1·cm·s-1增大到0.48 mol-1·cm·s-1). 对这种现象可能的原因进行了较详细探讨.     

The electronic structure of molecules by a many-body approach

The vertical valence ionization potentials of cyclopropane, ethylene oxide and ethylene imine are calculated by a many-body Green's function method. For C₃H₆ the ordering of the ionization potentials is 2e(), 1e(), 2a₁(), 1a₂(), 1e(). The assignment of the 2a₁ and the 1a₂ ionization potentials which has been controversial is thus clarified. The ordering is in agreement with the result obtained via Koopmans' theorem. For ethylene oxide and ethylene imine Koopmans' theorem fails in predicting the correct order of ionic states. For C₂H₄O the ordering of the ionization potentials is 2b ₁(), 4a ₁, 1a ₂(), 2b ₂,3a ₁, 1b ₁(), 1b ₂, 2a ₁ and for C₂H₅N 6a, 5a, 3a, 2a, 4a, 3a, 1a, 2a. The agreement of the computed ionization potentials with the experimental values is very satisfactory.     

烯烃歧化催化剂Bu~4N[Mo(CO)~5Cl]-RAlCl~2活性衰减原因的探讨

考察了影响Bu_4N[Mo(CO)_5Cl]-RAlCl_2烯烃歧化催化剂活性的一些因素和反应过程中的动力学行为,并着重讨论催化剂活性衰减的原因。催化剂失活主要是由于形成的金属卡宾活性物种分解所引起。最后分析了烯烃加入顺序对催化剂活性的影响。     

Voltammetric behavior and determination of bismuth on sodium humate modified carbon paste electrode

The preconcentration and voltammetric behavior of Bi^III on a sodium humate modified carbon paste electrode was studied by means of cyclic voltammetry (CV) and differential pulse stripping voltammetry (DPSV). The proposed measurement involves an initial nonelectrolytic preconcentration step in which Bi^III is complexed by the surface modifier in a solution of 0.05 M KNO₃-0.0106 M HNO₃ (pH 2.0) and a subsequent electrochemical scan step in which the preconcentrated Bi^III was reduced and then oxidized promptly in supporting electrolyte of 0.5 M HNO₃. The resulting DPSV anodic current was proportional to the concentration of Bi^III ion over the range of 4.78 × 10⁻⁸–1.44 × 10⁻⁵ M. The detection limit was 4.78 × 10⁻⁸ M. The proposed method was used to determine bismuth in various samples. Various factors affecting the electrode behavior were also investigated at the same time.