Determination of Chlorophenols in Sewage Sludge and Soil by High-Performance Liquid Chromatography–Tandem Mass Spectrometry with Ultrasonic-Assisted and Solid-Phase Extraction

Chlorophenols are a category of toxic pollutants that are ubiquitously present in the environment. This paper presents a reliable and feasible method for the determination of five chlorophenols in sewage sludge and soil using liquid chromatography–tandem mass spectrometry (LC-MS/MS). The pretreatment involved ultrasonic-assisted extraction and solid-phase extraction purification with hydrophilic–lipophilic balance cartridges. LC-MS/MS equipped with an electrospray ionization source operated in negative mode was used for detection, and multitude reaction monitoring mode was applied for data acquisition. The pretreatment and working conditions of LC-MS/MS were optimized to achieve satisfactory results. The intra-batch accuracies were 100.5–113.4% with relative standard deviations?≤?15.6% for the chlorophenols in sewage sludge and 71.3–102.7% with relative standard deviations?≤?14.0% for those in soil. The inter-batch accuracies were 86.1–100.5% (relative standard deviations?≤?33.6%) for sewage sludge samples and 70.5–112.5% (relative standard deviations?≤?28.2%) for soil samples, respectively. This method has been applied to the determination of chlorophenols in sewage sludge of wastewater treatment plants and soil collected from Guangzhou, China. Parachlorophenol, 2,4,6-trichlorophenol, 2,3,4,6-tetrachlorophenol, and pentachlorophenol were detected in some sewage sludge samples, with concentrations from 0.51 to 13.20?ng/g. In addition, parachlorophenol, 2,3,4,6-tetrachlorophenol, and pentachlorophenol were found in all the soil samples with concentrations from 0.33 to 5.21?ng/g. The chromatographic behavior, on-filter adsorption behavior, and the relationship between optimal collision energies and degree of chlorination of the chlorophenols was investigated. This method will be conducive to environmental research focusing on pollution investigation of chlorophenols in the environment.     

Pressurised hot water extraction followed by simultaneous derivatization and headspace solid-phase microextraction and gas chromatography-tandem mass spectrometry for the determination of aliphatic primary amines in sewage sludge

In this paper we describe an environmentally friendly and sensitive method for the determination of ten primary amines in sewage sludge. The method is based on pressurised hot water extraction (PHWE) followed by simultaneous derivatization with pentafluorobenzaldehyde (PFBAY) and headspace solid-phase microextraction (HS-SPME) and subsequent gas-chromatography ion-trap tandem mass spectrometry (GC-IT-MS-MS) analysis. The influence of the main factors on the PHWE of sludge was optimized by a central composite design. For all species the optimal conditions were water at pH 4 as the extracting solvent, an extraction temperature of 100 °C and an extraction time of 15 min. The separation and detection of the ten amines by GC-IT-MS-MS took just 10 min and the entire process took approximately 1 h. Repeatability and reproducibility between days, expressed as RSD (%) (n = 5), were less than 19 and 24%, respectively. The average limit of detection (LOD) was of 65 μg kg⁻¹ s (range found 9-135) and the average limit of quantification (LOQ) was of 230 μg kg⁻¹ (range found 50-450) of dry weight (d.w.). Under optimized conditions we used this method to determine the compounds in industrial and municipal sewage sludge samples and in sludge from a potable water treatment plant. Methylamine and isobutylamine showed the highest levels in one of the industrial sewage sludge samples (404 and 543 mg kg⁻¹ (d.w.), respectively). To our knowledge, this paper presents for the first time the determination of ten primary amines in sewage sludge samples using PHWE.     

A new sample preparation method for determination of acidic drugs in sewage sludge applying microwave assisted solvent extraction followed by gas chromatography-mass spectrometry

This paper presents a new sample preparation procedure for determination of selected acidic pharmaceuticals (ibuprofen, naproxen, ketoprofen, and diclofenac) in sewage sludge using microwave assisted solvent extraction, dispersive matrix extraction (DME) followed by the conventionally applied solid phase extraction (SPE), derivatization, and gas chromatography-mass spectrometry. The recoveries calculated from analytical data of spiked sludge samples changed in the range of 80-105% ± 15% for the four pharmaceuticals in mixed and activated sludge depending on the efficiency of the clean-up procedure. The measured concentration values of ibuprofen and naproxen were identical in the mixed and the activated sludge samples. However, ketoprofen and diclofenac showed about twice as high concentration in activated sludge than in the mixed one independently of the applied extraction method. The typical concentration ranges of ibuprofen, naproxen, ketoprofen and diclofenac in sewage sludge were 10-30 ng/g, 30-50 ng/g, 50-130 ng/g, and 50-140 ng/g respectively.     

Determination of non-steroidal anti-inflammatory drugs in sewage sludge by direct hollow fiber supported liquid membrane extraction and liquid chromatography–mass spectrometry

In this study, a three-phase hollow fiber liquid-phase microextraction (HF-LPME) method combined with liquid chromatography–mass spectrometry was developed for direct determination of four non-steroidal anti-inflammatory drugs (ketoprofen, naproxen, diclofenac and ibuprofen) in sewage sludge. The drugs were extracted from non-spiked and spiked slurry samples with different amounts of sludge into an organic phase and then back-extracted into an aqueous phase held in the lumen of the hollow fiber. High enrichment factors ranging from 2761 to 3254 in pure water were achieved. In sludge samples, repeatability and inter-day precision were tested with relative standard deviation values between 10–18% and 7–15%, respectively. Average concentrations of 29 ± 9, 138 ± 2, 39 ± 5 and 122 ± 7 ng/g were determined in dried sludge from Källby sewage treatment plant (Sweden) for ketoprofen, naproxen, diclofenac and ibuprofen, respectively.     

Bioremediation of Aged Petroleum Oil Contaminated Soil: From Laboratory Scale to Full Scale Application

Large quantity of aged petroleum oil contamination such as dehydrated oil sludge, generated in the disposal process of oil-containing sewage in Indonesia. This study aims to investigate the OSCS removal by mean of bioremediation technique. Results found that petrofilic consortia and biosurfactants addition increased the removal efficiency up to 46% and 85%, respectively. At full scale application, this technique succeed in removing of 46 g TPH per kg soil from 4 883 m³ of OSCS during 16 mo of treatment. These results suggest that petrofilic consortia and biosurfactants addition stimulate the biodegradation and overcome the limitation of OSCS degradation process.     

Pyrolysis GC/MS analysis of a bacterial population in a saline activated sludge system—Identification of the origin of the pyrolysis product 2-methylpyrimidine

During the investigation of problems with the physical handling of sludge from a saline activated sludge wastewater system, pyrolysis/GC/MS was used in an attempt to determine whether changes in the bacterial population in the sludge were occurring. The pyrolysis GC/MS analysis revealed an unknown peak among other typical bacterial pyrolysis products. This unknown was identified as 2-methylpyrimidine. This pyrolysis product was only found in appreciable amounts in samples from other saline systems but not in freshwater systems analyzed as points of comparison for the system of concern. Further investigation confirmed the source of 2-methylpyrimidine to be ectoine, a compound produced by halophilic bacteria as a compatible solute for osmoadaptation. Pyrolysis GC/MS was shown to be a useful tool to indicate the presence of ectoine in halophilic bacteria.     

一种煤与两种城市污水污泥混合热解的热重分析

采用热重分析法对一种煤和两种城市污水污泥（S1和S2）及其混合物进行了热解实验研究,揭示了煤和污泥在氮气中的热解特性及污泥对煤热解特性的影响。煤和污泥的热解特性参数不同,主要表现在总失重率、失重速率及挥发分析出温度区间等。煤与污泥S1混合有助于增加样品的热解总失重率,提高失重速率;污泥S1与煤的挥发分析出区间部分重合,污泥灰中含的无机物对煤的热解起到催化效果;煤和S2污泥混合后热解反应过程中无明显相互作用;煤与城市污水污泥混合物的相互作用与样品特性和混合比例有关。     

Focused ultrasound solid-liquid extraction and selective pressurised liquid extraction to determine bisphenol A and alkylphenols in sewage sludge by gas chromatography-mass spectrometry

A new method for determining endocrine disrupter compounds (EDCs) in sewage sludge is described in this paper. EDCs studied were bisphenol A (BPA) and alkylphenols (APs). In order to obtain a fast and simple method, selective pressurised liquid extraction (SPLE) and focused ultrasound solid-liquid extraction (FUSLE) were tested. Best results for SPLE were obtained using Florisil as clean-up sorbent and dichloromethane as extraction solvent, while temperature was the only significant variable. Analyte extraction by SPLE was completed in only one extraction cycle of 1 min at 130 °C. FUSLE was carried out in one step of 20 s at 75% power (0.5 cycles) and with 8 mL of ethyl acetate. Although the optimised FUSLE process was faster, simpler and cheaper, SPLE provided higher recovery values (ranging from 81 to 105%) and therefore SPLE-based method was selected and validated. The SPLE and GC-MS method showed an LOD of 10.7 ng/g for BPA and LODs between 1.2 and 41.6 ng/g for APs. Relative standard deviation values lower than 6% were obtained for all analytes. As a result, an efficient, fast and simple method based on SPLE and GC-MS for the determination of BPA and APs in sewage sludge is proposed.     

Determination of azoles in sewage sludge from Spanish wastewater treatment plants by liquid chromatography-tandem mass spectrometry

A simple and rapid analytical method for the determination of 16 azoles in sewage sludge has been developed and validated. The method was based on ultrasound-assisted extraction followed by dispersive solid-phase extraction cleanup and liquid chromatography-electrospray tandem mass spectrometric detection. The azoles were selected by their intensive usage as biocides (tebuconazole, propiconazole, cyproconazole and thiabendazole), antimycotic pharmaceuticals (ketoconazole, econazole, fluconazole and clotrimazole) or fungicides in agriculture (difenoconazole, flusilazole, hexaconazole, prochloraz, bromuconazole, epoxiconazole and triticonazole). The recoveries of these compounds through the method were between 71.9 and 115.8%, with relative standard deviations lower than 20%. Detection limits were in the range of 0.5-5.0 ng/g. The developed method was applied to the analysis of azoles in sewage sludge samples collected from 19 Spanish wastewater treatment plants. Although azoles used as biocides or agriculture fungicides were present in a few sludge samples, the pharmaceuticals ketoconazole, econazole and clotrimazole were present in all of the analyzed sludge samples, being ketoconazole the one found at the highest level, representing the 68.6% of the total azole content found in the 19 sludge samples studied.     

Hollow fiber liquid phase microextraction as a preconcentration and clean-up step after pressurized hot water extraction for the determination of non-steroidal anti-inflammatory drugs in sewage sludge

A method for the quantitative determination of non-steroidal anti-inflammatory drugs (NSAIDs) in sewage sludge was developed and validated. The target compounds were extracted using pressurized hot water extraction (PHWE) and then purified and preconcentrated by three-phase hollow fiber liquid phase microextraction (HF-LPME) followed by LC–ESI-MS analysis. The PHWE was optimized with regard to the pH of solvent as well as other operational parameters. The optimum conditions were 0.01 M NaOH as the extraction solvent, temperature of 120 °C, pressure of 100 bar, static time 5 min, 5 cycles, flush volume 90% and purge time 60 s. Spike recoveries for sludge samples spiked at 200 ng g⁻¹ were in the range of 101–109% but for the native drugs in non-spiked sludge samples, recoveries were 38.9%, 59.8%, 90.3% and 47.8% for ketoprofen, naproxen, diclofenac and ibuprofen, respectively. Donor phase pH, ionic strength and extraction time were optimized for HF-LPME after PHWE. The optimum conditions were 2 h extraction at pH 1.5 without salt addition. Enrichment factors in the range of 947–1213 times were achieved (extraction recoveries were 23.6–30.3%) for HF-LPME after PHWE. The matrix effect on the ionization of drugs in LC–ESI-MS was also investigated. The results show that there is a smaller matrix effect (−8.9% to +14.6%) in comparison with other published values obtained using solid phase extraction (SPE) for clean-up after pressurized liquid extraction (PLE). Method detection limits (MDLs) and method quantification limits (MQLs) for different drugs were in the range of 0.4–3.7 ng g⁻¹ and 1.5–12.2 ng g⁻¹ in dried sludge samples, respectively. The characteristics of the proposed method were compared with those of other published works. The considerably lower ion suppression/enhancement and minimum use of organic solvents (a few microliters of di-n-hexyl ether) in the sample preparation step are two highlighted advantages of the proposed method in comparison with previously published works. The method was applied to determine NSAIDs in sewage sludge from Källby wastewater treatment plant (Lund, Sweden) in April, June, August and October 2010. The highest concentration level was recorded for ibuprofen in the April sewage sludge sample (588 ng g⁻¹) and all of the selected NSAIDs were detected in all the samples analyzed.