Selective Oxidation of Isobutene over CsFeCoBiMnMoOx Mixed Oxide Catalyst

Mixed oxide catalyst Cs0.1Fe2Co6BiMnMo12Ox was prepared by the coprecipitation method.Selective oxidation of isobutene was carried out in a fixed-bed reactor over Cs0.1Fe2Co6BiMnMo12Ox.The results showed that the catalyst had high catalytic activity. Under the optimum reaction conditions(n(i-C4):n(O2)=1:2-1:4, space velocity=180 h^-1, T=360℃), the yields of methacrolein and methacrylic acid can reach 80% and 8%, respectively. The total yield of liquid products (methacrolein, methacrylic acid and acetic acid) can reach about 90%.     

Multifunctional Calix[4]arenes Containing Pendant Amide and Phosphoryl Groups: Their Use as Extracting Agents and Carriers for Alkali Cations

The complexing, extracting and mobile carrier properties of the tetra(phosphine oxide)-calix[4]arene 1 and the hybrid diamide-di(phosphine oxide)-calix[4]arene 2 were studied. Both ligands give 1 : 1 complexes with alkali cations in THF as shown by the picrate method. 1H NMR experiments were run to follow encapsulation of sodium and potassium cations. The corresponding spectra indicate C2-symmetrical structure. The observed extraction orders of the alkali picrates were as follows K+>Rb+>Li+>Cs+>Na+ for 1 and Li+>Na+>K+>Rb++ for 2. Transport kinetics was analysed by means of a model which assumes pure diffusion and which allows the evaluation of mass transfer coefficients in all systems. These coefficients and their influences on the transport rate are discussed in terms of size of the transporting species in the liquid membrane.     

单斜层状LiMnO2的球磨-离子交换法合成及其电化学性能研究

通过球磨促进固相反应法合成出了具有单斜层状结构的前驱物NaMnO₂，随后通过离子交换得到了单斜层状LiMnO₂。XRD测试结果显示产物为单相。扫描电镜(SEM)和透射电镜(TEM)观测结果显示LiMnO₂的粒子尺寸为300～500 nm，HRTEM分析显示干扰条纹的间距为0.485 nm，基本对应于m-LiMnO₂的(001)晶面间距。红外吸收光谱(IR)和X射线光电子能谱(XPS)被用来测量m-LiMnO₂中Mn-O键的伸缩和弯曲振动吸收和Mn元素的价态。合成的m-LiMnO₂在电化学充放电循环初期表现了较好的电化学性能，但其循环寿命仍需要进一步改善。     

负载型无铬超细铁基变换催化剂的制备和催化性能

 以镁铝尖晶石为载体，以过渡金属氧化物为助剂，用吸附γ－Fe2O3胶体法制备了负载型无铬铁基变换催化剂．TEM，XRD，BET和活性测试结果表明，采用胶体负载法制备的变换催化剂，其活性组分Fe3O4以分立的超细微颗粒分布在镁铝尖晶石载体表面上，颗粒之间存在一定的间隔．过渡金属氧化物NiO或V2O5能够进入Fe3O4晶格形成固溶体，起到代替氧化铬的作用，提高催化活性．负载型催化剂FeNi／MgAl2O4（m（NiO）／m（Fe2O3）＝3％）在汽／气比为1和空速为2000h－1的反应条件下，CO转化率在400和350℃时分别为95％和80％；在高空速和低汽／气比条件下也具有很好的催化性能．稳定性实验结果表明，该催化剂 具有良好的热稳定性和一定的抗硫能力．与非负载型催化剂相比，负载型催化剂具有更为优越的催化性能．     

The benzene ring as a dipolarophile: Reactions of monosubstituted benzenes with tetracyanoethylene oxide

Summary The reaction of tetracyanoethylene oxide on one hand and toluene, chlorobenzene, fluorobenzene, anisole, and nitrobenzene, on the other, has been studied. Toluene and the halogenobenzenes yield mixtures of monoadducts, anisole yieldp-methoxyphenylmalononitrile and its dimer and nitrobenzene does not react. These results are discussed with the help of a qualitative orbital model.¹H-NMR analysis of some monoadducts has been carried out.

---

Der Benzolring als Dipolarophil: Reaktionen monosubstituierter Benzole mit Tetracyanoethylenoxid

Zusammenfassung Es wurden die Reaktionen von Tetracyanoethylenoxid mit Toluol, Chlorbenzol, Fluorbenzol, Anisol und Nitrobenzol untersucht. Toluol und die Halogenbenzole ergaben Mischungen von Monoaddukten, Anisol ergabp-Methoxyphenylmalononitril und sein Dimer, Nitrobenzol zeigte keine Reaktion. Diese Resultate werden mit Hilfe eines qualitativen Orbitalmodells diskutiert. Die Analyse einiger Monoaddukte erfolgte mittels¹H-NMR-Analyse.

     

氧化钇粒度控制与测定

用氨水或碳酸氢铵与氯化钇溶液反应生成沉淀，煅烧沉淀制备了D50为0．45μmt 2-10μm的各种粒径的氧化钇粉末。分别采用Coulter MultisizerⅡ和90Plus粒度仪测定微米和亚微米级氧化钇粉体粒度，研究了分散剂，待测样品量，分散时间等因素对亚微米级氧化钇粉体粒度测量精度的影响。     

导电氧化物电极上丁酸丁酯电化学合成的研究

本文研究了某些氧化物电极在不同条件下对丁醇电解直接合成丁酸丁酯的影响，并测定了这些氧化物电极上的丁醇氧化极化曲线，结果表明Ｔｉ／ＰｂＯ２电极在加入ＳｎＯ２，Ｓｂ２Ｏ３，ＰｄＯｘ中间层后，不仅电极的ＰｂＯ２层不易脱落，而且使电极的电催化性能有较大的提高。     

CuO/ZnO/Al2O3合成甲醇催化剂制备方法

ＣｕＯ／ＺｎＯ／Ａｌ２Ｏ３合成甲醇催化剂的制备方法吴晓晖刘金尧刘崇微朱起明（清华大学化学系一碳化工国家重点实验室，北京１０００８４）何菲（天津大学化工系一碳化工国家重点实验室，天津３０００７２）关键词氧化铜，氧化锌，氧化铝，超细粒子，草酸盐胶体...     

多乙苯脱氢制多乙烯苯氧化铁催化剂的研究助剂钾,铈对催化性能的影响

研制了适合多乙苯脱氢制多乙烯苯的Ｆｅ－Ｋ－Ｃｅ复合型脱氢催化剂．助剂钾以钾霞石（ＫＡｌＳｉＯ４）方式引入，既克服了钾的大量流失，又保留了钾碱的抗积炭性能，使催化剂活性稳定．另一助剂ＣｅＯ２的加入对催化剂中的各组分起到了一定的分散作用，使催化剂晶粒度变小，并且提高了活性组分Ｆｅ２Ｏ３的还原温度，因而可增强催化剂的抗还原能力．     

Effect of lithium oxide dopants on electrophysical and sorption properties of zinc oxide

The effects of lithium oxide dopants (0.5–0.8 at. % Li) on the electrophysical and sorption properties of ZnO were studied in the temperature range from 150 °C to 410 °C. The introduction of lithium increases the activation energy of the conductivity of ZnO, decreases its conductivity, and increases the amount of S0₂ sorbed. Two forms of chemisorbed SO₂ (donor and acceptor) are observed on the surface.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 5, pp. 1096–1100, May, 1996.