Comparison of purge and trap GC/MS and spectrophotometry for monitoring petroleum hydrocarbon degradation in oilfield produced waters

Results of using a field spectrophotometer and its appropriate protocols as a surrogate method for an oilfield produced water treatment process is presented. Methylene chloride extractions of the produced water before and after treatment maintained a yellow color pigment that was directly proportional to the hydrocarbon concentration. From this, an absorption spectrum and standard curve were developed. A resultant linear plot of the standard curve indicated that there is an excellent correlation (r²=0.9847) between the varying concentrations and the associated absorbance values at a wavelength of 400 nm. Total n-alkane concentration comparisons between the laboratory GC/MS analysis and the spectrophotometry analysis generated data of similar accuracy and precision at concentrations ranging from 1 to 137 mg/l (alpha=0.05). Linear comparisons between GC/MS and spectrophotometric coefficients were near unity, with the constant being near zero, with a correlation coefficient (r²) of 0.99. Based on this study, spectrophotometry is a complimentary method to GC/MS for determining total n-alkane concentrations in oilfield produced water samples.     

高温固相法合成LiNi1/3Mn1/3Co1/3O2及其性能研究

采用高温固相法合成出层状锂离子电池正极材料LiNi_1/3Mn_1/3Co_1/3O₂。通过XRD、ICP、SEM和电化学测试手段对产物的结构、组成、形貌及电化学性能进行了研究。XRD结果表明此方法合成的LiNi_1/3Mn_1/3Co_1/3O₂具有标准的α-NaFeO₂型层状结构，SEM照片显示颗粒粒径大约在500 nm左右，粒径分布较窄。以20 mA·g^-1电流密度放电，充放电电压在2.8～4.4 V之间，其首次放电比容量为170 mAh·g^-1，40次循环容量保持率为85.3%。进一步加入石墨导电剂后，同样条件下首次放电比容量变为179 mAh·g^-1，50次循环容量保持率为89.6%。容量衰减主要发生在前10次循环。XRD和SEM测试表明循环初期容量衰减的原因是由材料本体结构变化和界面反应共同作用的结果。     

Thermal degradation behavior of multi-walled carbon nanotubes/polyamide 6 composites

This paper focuses on the thermal degradation behavior of multi-walled carbon nanotubes (MWNTs)/polyamide 6 (PA6) composites under air and nitrogen atmosphere using thermogravimetric analysis (TGA). The results show that the dispersion of amino-functionalized MWNTs (f-MWNTs) in PA6 is more homogeneous than purified MWNTs (p-MWNTs). The presence of MWNTs improves the thermal stability of PA6 under air obviously, but has little effect on the thermal degradation behavior of PA6 under nitrogen atmosphere. The activation energies for degradation under air, E_a, estimated by Kissinger method, are 153, 165 and 169 kJ/mol for neat PA6, p-MWNTs/PA6 and f-MWNTs/PA6 composites, respectively. The p-MWNTs/PA6 composites show two-step degradation not only under air but also under nitrogen atmosphere, however, neat PA6 and the f-MWNTs/PA6 composites exhibit two-step degradation only under air.     

Naphthalene Complexation by β-Cyclodextrin: Influence of Added Short Chain Branched and Linear Alcohols

Naphthalene forms 1 : 1 complexes with -cyclodextrin (-CD)in water. The binding constant is 377 ± 35 M^-1. Addition of linear or branched alcohols causes a reduction in the apparent strength of naphthalene binding (K_app) compared to the value in the absence of additives. For example, 1% 1-pentanol reduces K_app to 184 ± 31 M^-1. Branching does not alter K_app much for a given number of carbon atoms, e.g., it is 113 ± 9 M^-1for 2-pentanol and 116 ± 8 M^-1for 3-pentanol. The exception to this is tert-butanol for which K_app is 577 ± 40 M^-1. The variation in K_app as a function of [1-pentanol] yields values for the individual equilibrium constants contributing to K_app. This reveals that a ternary complex forms involving naphthalene, the CD and 1-pentanol. The constant for formation of the ternary complex is 99 ± 29 M^-2. NaI quenching of naphthalene fluorescence indicates that the CD cavity partially protects the naphthalene excited state fromthis water phase quencher. Interestingly, the Stern–Volmer constant is lower in the presence of 1-pentanol than in its absence, although there should be more unbound (and therefore more NaI accessible) naphthalene in the former system than in the latter. These apparently contradictory results are discussed in terms of ternary complex formation.     

Improvement of the Pd/Al2O3 Catalyst by the Control of the Sol-Gel Preparative Parameters

In this work, the metal dispersion of the Pd/Al₂O₃ catalyst prepared by sol-gel method is improved by an adequate optimisation of the preparative variables. First, the gelation temperature and the ageing time are selected, in order to avoid the reduction of the metal precursor (palladium acetylacetonate, Pd(acac)₂) by the solvent (sec-butanol, sB). The metal sintering effect on the catalysts treated in oxygen at 500°C is then minimized when the alumina pore size is controlled by the variation of the alumium alkoxide (AsB) concentration and the acetic acid amount ([AcA]/[AsB]). The appearance of new palladium particles on the alumina surface and the matching between the particle diameters and the pore sizes were also effective for the metallic surface area improvement on the samples treated in oxygen at 800°C. Compared to the reference catalysts, the higher metal dispersion obtained on the sol-gel ones was the determinant factor for their higher catalytic activity in methane combustion.     

One-step synthesis of the chelate oxides of bis(trialkylantimony) by an oxidative method

The chelate oxides of bis(trimethylantimony) (Me₃SbL¹)₂O (i = 1 or 2, L¹-acetylacetonate, L² - trifluoroacetylacetonate) and bis(triethylantimony) (Et₃SbL¹)₂O have been obtained in 79–85% yields by a one-step oxidation of trialkylantimony withtertbutylhydroperoxide in the presence of -diketones in benzene at 20 °C.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 1, pp. 154–155, January, 1995.This work was carried out with financial support from the Russian Foundation for Basic Research (Project No. 94-03-08846).     

Cyphostemmins A-B, two new antifungal oligostilbenes from Cyphostemma crotalarioides (Vitaceae)

Two new antifungal resveratrol dimers, cyphostemmins A-B (1–2), have isolated from the roots of Cyphostemma crotalarioides planch (Vitaceae) together with resveratrol 3 and previously known reseveratrol dimers (4–7). Structures of these new compounds have been established on the basis of their MS and ¹H and ¹³C NMR spectroscopic data.     

高水相W／O型乳化膏体油膜稳定性的研究

高水相Ｗ／Ｏ型乳液是指水相体积占７４％以上，属于高度不稳定的分散体系［１，２］．乳化炸药的问世，使这种高水相Ｗ／Ｏ型乳液有了新的实际应用．这种炸药是９０％～９５％重的硝酸铵盐（占水相８０％～９０％重）水溶液高度分散在５％～１０％的油相中构成Ｗ／Ｏ型乳...     

Supercritical carbon dioxide extraction of Mentha pulegium L. essential oil

The dependence of Mentha pulegium L. (pennyroyal) essential oil composition, obtained by supercritical carbon dioxide (SC-CO₂), with the following parameters: pressure, temperature, extraction time (dynamic), and modifier (methanol) was studied. The results were also compared with those obtained by conventional hydrodistillation method in laboratory conditions. Regarding the percentages of menthone (30.3%) and pulegone (52.0%), the optimum SFE results were obtained at the following experimental conditions: pressure=100 atm, T=35 °C, dynamic time=10 min, and V_modifier=0 μl. The results of hydrodistillation showed that the major components of M. pulegium L. were pulegone (37.8%), menthone (20.3%), and piperitenone (6.8%). The evaluation of the composition of each extract was performed by gas chromatography-mass spectrometry.     

含金属纳米粒子的层层自组装及单壁碳纳米管的催化生长

利用层间的静电吸附作用，重氮树脂和不同种类的含金属纳米粒子被依次吸附到硅片表面形成层层自组装膜。通过改变自组装膜的层数可以控制纳米粒子在表面吸附的量，同时利用重氮树脂的光敏特性可以实现纳米粒子在表面的图案化排布。以这些纳米粒子为催化剂，研究了单壁碳纳米管在硅片表面的化学气相沉积生长。