修饰铂电极-示波双电位滴定法测定Zn(Ⅱ)

制备了锌修饰铂电极,建立了一种新的测定Zn(Ⅱ)的示波双电位滴定法。在六次甲基四胺溶液(1.0mol/L)中(pH=5.5),用制备的修饰铂电极作为双指示电极,以EDTA标准溶液滴定Zn(Ⅱ),利用示波器屏幕上荧光点的显著最大位移指示滴定终点。在3.0×10-4～2.0×10-3mol/L的浓度范围内,Zn(Ⅱ)的回收率为99.9%～100.2%。该修饰电极具有良好的稳定性和重现性,对Zn(Ⅱ,1.0×10-3mol/L)溶液连续11次测定,所得终点电位值均在10.1mV左右,其相对标准偏差(RSD)为0.5%。用来测定含锌的实际样品,其结果与指示剂法测定的值基本一致。     

气相滴定在臭氧计量标准溯源中的应用

利用臭氧和一氧化氮发生快速反应生成二氧化氮的原理,设计气相滴定反应系统,通过对参加反应的一氧化氮标准气体浓度变化的准确测定,计算出组分臭氧混合气体的浓度。利用设计的气相滴定系统（GPT）,对基于紫外分光原理的臭氧测量标准装置SRP41产生的空气中臭氧标准气体进行了比对及相互验证。比对结果表明：二者偏差不大于2．6％,均在分析不确定度范围内等效。这为臭氧测量计量溯源问题提供了解决方案。     

Redox-iodometry: a new potentiometric method

A new iodometric method for quantifying aqueous solutions of iodide-oxidizing and iodine-reducing substances, as well as plain iodine/iodide solutions, is presented. It is based on the redox potential of said solutions after reaction with iodide (or iodine) of known initial concentration. Calibration of the system and calculations of unknown concentrations was performed on the basis of developed algorithms and simple GWBASIC-programs. The method is distinguished by a short analysis time (2–3 min) and a simple instrumentation consisting of pH/mV meter, platinum and reference electrodes. In general the feasible concentration range encompasses 0.1 to 10^–6 mol/L, although it goes down to 10^–8 mol/L (0.001 mg Cl₂/L) for oxidants like active chlorine compounds. The calculated imprecision and inaccuracy of the method were found to be 0.4–0.9% and 0.3–0.8%, respectively, resulting in a total error of 0.5–1.2%. Based on the experiments, average imprecisions of 1.0–1.5% at c(Ox)>10^–5 M, 1.5–3% at 10^–5 to 10^–7 M, and 4–7% at <10^–7 M were found. Redox-iodometry is a simple, precise, and time-saving substitute for the more laborious and expensive iodometric titration method, which, like other well-established colorimetric procedures, is clearly outbalanced at low concentrations; this underlines the practical importance of redox-iodometry.

---

An erratum to this article is available at .     

Syntheses of dibenzo-18-crown-6 lariat isomers and their complexation with lanthanoid nitrates

Two constitutional isomers of dibenzo-18-crown-6 derivatives (6 and 7) were synthesised and their binding behaviours towards trivalent lanthanoid cations (La^3 + , Ce^3 + , Pr^3 + , Nd^3 + , Sm^3 + , Eu^3 + , Gd^3 +  and Tb^3 + ) were investigated. Both isomers expressed better binding affinities towards Sm^3 +  and Tb^3 +  than a group of other lanthanoids, as measured by the ligand-to-metal charge-transfer (LMCT) band intensity at ca. 425 nm using UV–vis spectroscopic method. Additionally, the trans isomer 7 was shown to have a higher binding ability than the cis isomer 6 towards Tb^3 + .

     

自动电位滴定法测定冷轧薄板酸洗液中总酸度

自动电位滴定法测定酸液中总酸度具有简单、快捷、不受其他元素干扰等优点。用硫代硫酸钠掩蔽铁离子,利用自动电位滴定仪测定冷轧薄板酸洗液的总酸度(以盐酸量计)。当电位突变达30mV以上时,仪器自动判定滴定终点。自动电位滴定法测定冷轧薄板酸洗液中总酸度结果与酸碱中和滴定方法具有较好的一致性。相对标准偏差小于0.6%,能够满足生产检验的要求。     

Experimental Evaluation of the Additive Compounds Performance on Asphaltene Precipitation Using Automatic Titration Method

The use of soluble amphiphiles oil types provide the most practical and economical solution for crude oil treatment in order to control the asphaltene precipitation phenomenon. In this article, the inhibition performance of a number of new chemical additives to asphaltene precipitation is examined on two types of Iranian crude oil. An automatic titration method is used in experimental evaluation. The vegetable oil types (hazelnut, wheat germ, and walnut), organic acids (oleic and linoleic) and chemical additives (4-dodecylresorcinol and benzyl alcohol) displayed the highest capacity to inhibit asphaltene precipitation. A remarkable onset displacement is displayed by dodecyl resorcinol. The results also revealed that the vegetable oil have high potential in delaying asphaltene precipitation.     

Diffusion layer titration of dipyrone in pharmaceuticals at a dual-band electrochemical cell

This paper describes the use of a thin-layered dual-band electrochemical cell operating at flow conditions to determine dipyrone (sodium salt of 1-phenil-2,3-dimethyl-4-methylaminomethanesulfonate-5-pyrazolone) by reaction with electrogenerated iodine. The electrolytic cell consisted of two closely spaced gold electrodes, the upper stream electrode serving as the generator electrode and the downstream electrode working as the collector electrode. A linear dynamic range from 2 to 15 μmol l⁻¹ dipyrone was obtained by using a sample volume of 100 μl, with a detection limit of 1.1 μmol l⁻¹. Standard deviation (S.D.) of 3.4% for 20 repetitive injections of a 40 μmol l⁻¹ dipyrone solution and sampling frequency of 90 h⁻¹ were achieved. The results obtained with the thin-layered dual-band electrochemical cell for dipyrone determination in three different pharmaceutical samples compared well with those found by iodimetry with coulometrically generated iodine.     

Determination of cationic polyelectrolytes using a photometric titration with crystal violet as a color indicator

The reaction of the cationic dye, crystal violet (CV) with the anionic polyelectrolytes such as potassium poly (vinyl sulfate) (PVSK) results in a decrease of the absorbance of CV at the maximum absorption wavelength (590 nm). This change of the absorption spectra of the CV has been already applied to the determination of anionic polyelectrolytes using flow injection analysis method. In this paper, CV was applied to the indicator for the determination of cationic polyelectrolytes such as poly (diallyldimethylammonium chloride) (Cat-floc) by photometric titration, using a PVSK solution as a titrant. The end-point of the titration is detected as the break point of the titration curve. A linear relationship between the concentration of cationic polyelectrolyte and the end-point volume of the titrant exists in the concentration range from 0 to 5×10⁻⁵ eq. mol dm⁻³ for Cat-floc, glycol chitosan and methylglycol chitosan. The effects of the concentration of CV and coexisting electrolytes in the sample solution and the effect of pH of the sample solution on the degree of the change of absorbance at the end-point were also examined.     

倒数示波计时电位滴定新技术

倒数交流示波极谱具有抑制充电电流、突出电解电流的优点,利用(dE/dt)~(-1)-E曲线上去极剂峰的突然消失或出现指示滴定终点的方法称作倒数示波计时电位滴定法.由运算放大器组装的模拟电子线路可以对(dE/dt)~(-1)-E曲线进行反馈、反对数及微分处理,从而获得各种类型的倒数示波计时电位曲线(图1),以进一步提高滴定的灵敏度。     

电位法测定明胶的还原性

使用电位滴定法测定了30种不同类型的LAG明胶的还原性,并进行了比较。结果表明:不同工艺过程,不同原料所制造的明胶的还原性大不相同。即使是同属于一种类型的惰胶,它们的还原性仍表现出了很大的差别。由于工艺条件的不同,明胶中还原组份的组成和化学本性可以有较大的差别,从而导致明胶的还原性质也会大不相同。这在一定程度上能解释同一类型的惰胶在照相性能上的差别。