Effects of <Emphasis Type="Italic">L</Emphasis>-Carnitine on Sucrose-Induced Hyperlipidaemia

Summary. L-Carnitine, L-(−)-β-hydroxy-γ-trimethylaminobutyrate, plays an important role as a factor necessary for the transport of long-chain fatty acids into the mitochondria. In order to investigate the influence of L-carnitine on hyperlipidaemias, the experimental model of the sucrose-induced hypertriglyceridaemia of the rat was used. In these experiments L-carnitine in the dose of 11 mg per day and 100 g body weight (over the period of 1 week) was able to antagonize the sucrose-induced hypertriglyceridaemia and the increase of serum free fatty acid level in female rats of the Wistar strain. Carnitine administration did not change the activities of lipogenic enzymes and fatty acid synthesis in the liver. However, L-carnitine increases the rate of hepatic fatty acid oxidation. Our results indicate a hypotriglyceridemic and free fatty acid lowering effect of L-carnitine, and suggest the use of this compound in the therapy of hyperlipidaemias.     

K对Mn—Co—O的结构及氧化活性的影响

利用XRD,TPD,TFD-MS及催化氧化反应等实验技术,研究了K对Mn-Co-O的结构及氧化活性的影响。XRD结果表明,Mn-Co-O系已形成反尖晶石型的MnCo_2O_4结构;K-Mn-Co-O系中除MnCo_2O_4型结构外,还有新相KMnO_2存在。根据O_2的TPD-MS及吡啶的TPD结果,Mn-Co-O中添加适量的K能提高供氧活性和增加供氧数目,但酸中心数目减少,强度降低。K对Mn-Co—O催化剂氧化活性的影响随反应物分子结构的不同而异,对乙酸乙脂、苯甲酰氯等极性有机物的完全氧化反应,K能提高氧化活性,但对苯、正己烷等非极性有机物的完全氧化反应,K使其活性降低。     

Voltammetry in Undiluted Acetic Acid. In Situ Determination of Water

Water present in undiluted acetic acid can be monitored in situ with Pt and Au microelectrodes using differential pulse and square‐wave voltammetries. Both reduction and oxidation peaks can be obtained. The best quantitative analytical results were obtained for the anodic peak, the Pt microelectrode, and differential pulse voltammetry. The anodic water peak is located at +1.55 V vs. the quasi reference Pt electrode. The voltammetric peak obtained at Pt electrode is apparently not a diffusional one, however, the calibration plot obtained by employing this peak is linear over a wide concentration range, up to 4 mol dm^?3. The detection limit has been estimated as 2.3 mM or 0.0043 v/v%. The developed method may be particularly useful, since the Karl Fischer method can not be used to determine water in glacial acetic acid due to the estrification reaction of acetic acid with methanol. A voltammetric wave of undiluted acetic acid could not be obtained in the positive and negative ranges of potential.     

Electroless preparation and electrochemical behavior of a platinum-doped nickel hexacyanoferrate film–zinc modified electrode: catalytic ability of the electrode for electrooxidation of methanol

The use of a zinc substrate as an electrode and the modification of its surface by means of a thin film of platinum-doped nickel hexacyanoferrate (Pt-NiHCF) were developed. The modification conditions of the zinc surface including the electroless deposition of metallic nickel on the electrode surface from NiCl₂ solution, chemical derivatization of the deposited nickel to the NiHCF film in 0.5 M K₃[Fe(CN)₆] solution, and electrochemical penetration of metallic platinum into the modified film are described. The modified zinc electrodes prepared under optimum conditions show a well-defined redox couple due to the [Ni^IIFe^III/II(CN)₆]^1–/2– system. The effects of pH, the alkali metal cation, and the anion of the supporting electrolyte on the electrochemical characteristics of the modified electrode were studied in detail. The diffusion coefficients of hydrated alkali metal cations in the film (D), the transfer coefficient (), and the transfer rate constant for the electron (k_s) were calculated in the presence of some alkali metal cations. The electrocatalytic activity of the modified electrode for methanol oxidation was demonstrated. The stability of the modified electrode under various experimental conditions was investigated.     

Kinetic model ofCO oxidation on nonuniform surface analyzed regardingCOads spillover, 2. homotopic method. Effect ofm1 surface portion

The homotopic method has been used to analyze the kinetic model of three-stageCO oxidation on two nonuniform surface patches conjugated byCO ₂ spillover. Diagrams of steady states depending on the portion of surface patchm ₁ at various temperatures and pressure ratiosP(O ₂)/P(CO) have been constructed. The ratios of different type patches corresponding to the maximum overall reaction rate have been found.     

Study of cryostructurization of polymer systems

Summary A possibility of obtaining insoluble gels with the help of freezing-thawing procedures was demonstrated on an example of aqueous solutions of a thiol-containing poly(acryl amide) derivative. The gel formation was proved to occur as a result of oxidation of free SH groups of polymer chains by water-dissolved air oxygen.     

Enantioselective oxidation of olefins catalyzed by chiral copper bis(oxazolinyl)pyridine complexes: a reassessment

Copper complexes of chiral tridentate pybox ligands synthesized using a modified procedure have been studied as catalysts for the enantioselective allylic oxidation of olefins. A variety of olefins have been used in this reaction. Using 5 mol% of a Cu(II) complex of the tridentate pybox ligand, phenylhydrazine, and tert-butyl perbenzoate as oxidant in acetone, optically active allylic benzoates were obtained up to 94% ee in few hours. It was also observed that the use of molecular sieves in the reaction did not alter the enantioselectivity. Temperature was found to be very crucial in rate of the enantioselective allylic oxidation of olefins. Using EPR spectra, it has been shown that the Cu(II) species is reduced to Cu(I) by phenylhydrazine and phenylhydrazone, but the reduction with the former is faster in comparison to the latter. It was concluded that the rate enhancement was not specific to the presence of phenylhydrazine or phenylhydrazone, but both were equally responsible provided acetone was used as a solvent.     

Physico-chemical aspects of polyethylene processing in an open mixer. Part 23: Mechanisms and kinetics of trans-vinylene group consumption

There are many potential reactions for trans-vinylene groups in oxidizing polyethylene melts. The main possibilities are reactions with peroxy radicals, molecular oxygen, hydroperoxides and peracids. These different reactions can all contribute to the removal of trans-vinylene groups to some extent. This is especially so, for the reactions with hydroperoxides that have been found to be the dominant reactions with vinylidene and vinyl groups in the low temperature range. The reaction with peroxy radicals is thought to be as important relatively as with vinylidene groups. Therefore, the importance of the reaction is decreasing with increasing temperature. However, the most characteristic reaction for trans-vinylene groups can be detected without any doubt only in the advanced stages of processing. It is mechanical stress induced oxygen addition to the double bond. The discussion shows that the reaction should be important from the beginning of processing. The reaction cannot operate with vinyl and vinylidene groups, which are not part of the polyethylene main chain. After oxygen addition to the trans-vinylene group, the “ene” reaction yields an allylic hydroperoxide so that the double bond is not immediately removed. It is acid catalyzed hydroperoxide decomposition that leads to chain scission with aldehyde formation at the new chain ends.     

Use of Ag(II) as a removable template in porphyrin chemistry: diol cleavage products of [meso-tetraphenyl-2,3-cis-diolchlorinato]silver(II)

The use of Ag^II as a removable template in synthetic porphyrin chemistry is described. Mild procedures for the insertion of Ag^II into chlorins and the demetallation of the [chlorinato]Ag^II complexes are delineated. The UV-vis spectra of the novel [chlorinato]Ag^II complexes are discussed. The diol cleavage products of [meso-tetraphenyl-2,3-diolchlorinato]silver(II) under a number of conditions are characterized and compared to those resulting from the cleavage of the corresponding free base diol chlorin or its Ni^II complex, highlighting the unique templating effect of Ag^II. The scopes and limits of electrospray ionization mass spectrometry (ESI-MS) for the analysis of Ag^II chlorins is described. The use of Ag^II as a templating metal is superior over Ni^II or Zn^II for the preparation of free base pyrrole-modified porphyrins along metal templated pathways.     

Oxidation of mandelic acid derivatives catalysed by Bi(0)/O2 systems: mechanistic considerations

Mandelic acid and some aryl substituted derivatives were oxidised under molecular oxygen and a catalytic amount of Bi(0). The corresponding aldehydes and/or the carboxylic acids were obtained selectively depending on the nature of the substituent. Aldehydes and α-keto acids were oxidised under the same Bi(0)/O₂ system and α-keto acids were proposed as intermediates in the formation of benzoic acid derivatives.