Novel fixed‐site–carrier polyvinylamine membrane for carbon dioxide capture

Fixed‐site–carrier membranes were prepared for the facilitated transport of CO₂ by casting polyvinylamine (PVAm) on various supports, such as poly(ether sulfone) (PES), polyacrylonitrile (PAN), cellulose acetate (CA), and polysulfone (PSO). The cast PVAm on the support was crosslinked by various methods with glutaraldehyde, hydrochloric acid, sulfuric acid, and ammonium fluoride. Among the membranes tested, the PVAm cast on polysulfone and crosslinked by ammonium fluoride showed the highest selectivity of CO₂ over CH₄ (>1000). The permeance of CO₂ was then measured to be 0.014 m³ (STP)/(m² bar h) for a 20 μm thick membrane. The effect of the molecular weight of PVAm and feed pressure on the permeance was also investigated. The selectivity increased remarkably with increasing molecular weight and decreased slightly with increased pressure in the range of 1 to 4 bar. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 4326–4336, 2004     

Pressure and temperature dependence of the gas‐transport properties of dense poly[2,6‐toluene‐2,2‐bis(3,4‐dicarboxylphenyl)hexafluoropropane diimide] membranes

The gas‐transport properties of poly[2,6‐toluene‐2,2‐bis(3,4‐dicarboxylphenyl)hexafluoropropane diimide] (6FDA‐2,6‐DAT) have been investigated. The sorption behavior of dense 6FDA‐2,6‐DAT membranes is well described by the dual‐mode sorption model and has certain relationships with the critical temperatures of the penetrants. The solubility coefficient decreases with an increase in either the pressure or temperature. The temperature dependence of the diffusivity coefficient increases with an increase in the penetrant size, as the order of the activation energy for the diffusion jump is CH₄ > N₂ > O₂ > CO₂. Also, the average diffusion coefficient increases with increasing pressure for all the gases tested. As a combined contribution from sorption and diffusion, permeability decreases with increases in the pressure and the kinetic diameter of the penetrant molecules. Even up to 32.7 atm, no plasticization phenomenon can be observed on flat dense 6FDA‐2,6‐DAT membranes from their permeability–pressure curves. However, just as for other gases, the absolute value of the heat of sorption of CO₂ decreases with increasing pressure at a low‐pressure range, but the trend changes when the feed pressure is greater than 10 atm. This implies that CO₂‐induced plasticization may occur and reduce the positive enthalpy required to create a site into which a penetrant can be sorbed. Therefore, a better diagnosis of the inherent threshold pressure for the plasticization of a glassy polymer membrane may involve examining the absolute value of the heat of sorption as a function of pressure and identifying the turning point at which the gradient of the absolute value of the heat of sorption against pressure turns from a negative value to a positive one. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 354–364, 2004     

Barriola-Vilenkin黑洞的统计熵

利用量子统计方法 ,直接计算Barriola_Vilenkin黑洞背景下玻色场和费米场的配分函数 ,然后利用砖墙膜模型计算和讨论黑洞背景下玻色场和费米场的熵     

PURIFICATION OF L-METHIONINE AND N-ACETYL-D-METHIONINE FROM THE MIXTURE OF ENZYMATICALLY DEACYLATED N-ACETYL-DL-METHIONINE

1. INTRODUCTION Methionine, namely 2-amido-4-thiomethyl butyric acid with a structure of CH3SCH2CH2CHCOOH, is one of the essential amino acids and has two natural enantionmers, D and L-methionine. The mixture of L- and D-isomers can be used as analeptics or nutritive additives to maintain the equilibrium of amino acids of feed [1,2]. L-methionine can release active methyl and accelerate the synthesis of choline, which further speeds up the conversion of the lipid accumulated in liv…     

Kinetic Parameters of Ion-Exchange Membrane in Amino Acid Solutions

Kinetic parameters of amino acid cations in an MK-40 ion-exchange membrane are calculated from the conductivity data. A theoretical quantum-chemical analysis of experimental activation energies for conduction suggests a mechanism of elementary act of transport of amino acid cations in the membrane.     

3-正则图的分割问题是NP-完全问题

证明了3-正则图的最小平分问题和最小α-分割问题都是NP-完全问题.     

Self-Interactions of Strands and Sheets

Physical strands or sheets that can be modelled as curves or surfaces embedded in three dimensions are ubiquitous in nature, and are of fundamental importance in mathematics, physics, biology, and engineering. Often the physical interpretation dictates that self-avoidance should be enforced in the continuum model, i.e., finite energy configurations should not self-intersect. Current continuum models with self-avoidance frequently employ pairwise repulsive potentials, which are of necessity singular. Moreover the potentials do not have an intrinsic length scale appropriate for modelling the finite thickness of the physical systems. Here we develop a framework for modelling self-avoiding strands and sheets which avoids singularities, and which provides a way to introduce a thickness length scale. In our approach pairwise interaction potentials are replaced by many-body potentials involving three or more points, and the radii of certain associated circles or spheres. Self-interaction energies based on these many-body potentials can be used to describe the statistical mechanics of self-interacting strands and sheets of finite thickness.     

Determination of residual monomers in acrylate dispersions by gas chromatography

The content of residual monomers is one of the most important characteristics of polymer dispersions. As a result of the similar physicochemical parameters of ethyl acrylate and methyl methacrylate, it is very difficult to determine the residual monomers in acrylate dispersions obtained by emulsion polymerization of both monomers. Gas chromatography with capillary columns, however, permits separation of these monomers and their quantitative determination in acrylate dispersions.     

A highly selective solid phase extraction sorbent for pre-concentration of sameridine made by molecular imprinting

Summary A novel approach to solid phase extraction, based on the use of a highly selective molecularly imprinted polymer, is presented. The versatility of this type of sorbent for solid phase extraction was demonstrated in a model batch-wise pre-concentration of sameridine prior to gas chromatography. Problems associated with leakage of remaining imprint molecules during the desorption phase could be eliminated by the use of a close structural analogue of sameridine as the imprint species. It was found that a major benefit of the imprinted polymer was its specificity, which lead to distinctly cleaner chromatographic traces and ability to improve sensitivity by extracting sameridine from larger sample volumes.