流动注射法同时测定海水中氨氮和磷酸盐

采用流动注射法同时测定海水中氨氮和磷酸盐的含量。在优化的试验条件下,氨氮和磷酸盐的线性范围分别为0.25 mg·L-1和0.30 mg·L-1以内,检出限(3S/N)分别为0.42μg·L-1和0.56μg·L-1。氨氮和磷酸盐加标回收率分别在85.0%~103%和86.7%~103%之间,测定值的相对标准偏差(n=6)分别在0.43%~5.3%和0~4.1%之间。方法用于分析标准物质,测定结果与分光光度法的结果一致。     

β-TCP/HAP多孔生物陶瓷的制备

以牛松质骨为原料,采用低温煅烧工艺,通过调整浸泡溶液浓度及煅烧温度等工艺参数,制备出具有良好生物活性,并保持天然骨多孔结构的β-TCP/HAP双相生物陶瓷。并采用XRD,SEM等手段对其成分、微观结构进行表征。结果表明:所制备的β-TCP/HAP多孔生物陶瓷的大孔孔径在300~500μm之间,微孔孔径在1~5μm之间,具有良好的生物活性和生物可降解性。通过控制煅烧温度和浸泡溶液浓度,制备出含较高TCP的β-TCP/HAP多孔生物陶瓷,而煅烧温度或浸泡溶液浓度过高会导致制备的样品中TCP的含量降低,焦磷酸钙的含量增加。     

磷酸酯合成油在高压下的固化现象及分析

采用超高压毛细管黏度计考察了磷酸酯合成油和常压下黏度与之相近的合成油A及合成油B的压黏关系,并进行了磷酸酯合成油在高压下固化现象的研究,利用红外光谱和凝胶渗透色谱对固化前后的磷酸酯合成油进行了分析,并从机械力化学角度分析了产生固化的原因.结果表明:磷酸酯合成油的压黏关系上升速度远大于合成油A和B;固化后,磷酸酯的物理状态由液态变成"玻璃态",颜色由透明色变成乳白色;磷酸酯合成油发生了氧化反应,分子量增大;磷酸酯合成油经高压高剪切速率作用后,发生化学反应的原因是机械力作用导致较长分子链断裂,形成大分子自由基,具有很高活性的大分子自由基发生氧化等化学反应.     

高比能LiFePO4的制备及性能研究

应用液相沉淀法-固相烧结法制备高密度的LiFePO4/C及纯相LiFePO4.X射线衍射、扫描电镜、傅立叶红外光谱仪、电化学性能测试表明:该样品具有单一的橄榄石结构和3.4 V左右的放电平台,掺碳的LiFe-PO4具有更优良的性能,粒度较小粒径分布均匀,振实密度达1.46 g/cm3,0.1C首次放电比容量为144.6mAh/g,循环20次后容量保持率为93.2%,1C倍率首次放电比容量为133.5 mAh/g,循环20次后容量下降8.76%.     

Phase modulation in dipolar-coupled A2 spin systems: effect of maximum state mixing in H NMR in vivo

Coupling constants of nuclear spin systems can be determined from phase modulation of multiplet resonances. Strongly coupled systems such as citrate in prostatic tissue exhibit a more complex modulation than AX connectivities, because of substantial mixing of quantum states. An extreme limit is the coupling of n isochronous spins (A_n system). It is observable only for directly connected spins like the methylene protons of creatine and phosphocreatine which experience residual dipolar coupling in intact muscle tissue in vivo. We will demonstrate that phase modulation of this “pseudo-strong” system is quite simple compared to those of AB systems. Theory predicts that the spin-echo experiment yields conditions as in the case of weak interactions, in particular, the phase modulation depends linearly on the line splitting and the echo time.     

Bioactive calcium phosphate coating formed on micro-arc oxidized magnesium by chemical deposition

In order to improve the bioactivity of the micro-arc oxidized magnesium, a calcium phosphate coating was formed on the surface of micro-arc oxidized magnesium using a chemical method. The microstructures of the substrate and the calcium phosphate coating before and after the simulated body fluids (SBF) incubation were characterized by X-ray diffraction, Fourier-transformed infrared spectroscopy and scanning electron microscopy. The results showed that the calcified coating was composed of calcium deficient hydroxyapatite (HA) and dicalcium phosphate dihydrate (DCPD). After SBF incubation, some new apatite formation on the calcified coating surface from SBF could be found. The corrosion behaviours of the samples in SBF were also investigated by potentiodynamic polarization curves and immersion tests. The results showed that calcium phosphate coating increased the corrosion potential, and decreased the hydrogen gas release.     

Investigation in thorium phosphate by NMR II-phosphorus dipolar networks

With through space and through bond experiments in two-dimensional NMR we analyze the transformation from the thorium phosphate-hydrogen phosphate hydrate (TPHPH) to the β form of the thorium phosphate diphosphate (β-TPD) in relation with the phosphorus networks. These techniques are complementary: the through space coupling gives an insight on the dipolar phosphorus networks while the through bond coupling is particularly efficient in the detection of the P₂O₇ groups. With these experiments we show that in a first step, by heating the precursor TPHPH above 250 °C, it transforms into an form of TPD. This transformation is due to the complete condensation of hydrogen phosphate groups HPO₄ into P₂O₇ entities. By heating -TPD above 950 °C it transforms into its well-known β form. The form is characterized by a hygroscopic behavior: some water molecules are present near the P₂O₇ groups that makes non-equivalent their phosphorus nuclei. PO₄ dipolar networks are always present in the form. The main effect of these PO₄ and P₂O₇ units is to give the system a channel structure and the water enters in them.     

Eu2+,Mn2+在BaZnP2O7中的发光及Eu2+→Mn2+能量传递

采用高温固相法合成了BaZnP₂O₇:Eu²⁺,Mn²⁺荧光粉，并对其发光性质及Eu²⁺对Mn²⁺的能量传递机理进行了研究.Eu²⁺和Mn²⁺在380 nm和670nm的发射峰分别由Eu²⁺的5d—4f跃迁和Mn²⁺的⁴T₁(^{4相似文献}   

Modeling and Simulation of Saturation Gain of IR Integrated Photonic Amplifiers

IR integrated photonic amplifiers at 1.55m operation will have good foreground in optical phasedarray radars for splitters and signal processing. The saturation gain characteristics of IR integrated photonic waveguide amplifiers (taken Er³⁺Yb³⁺ co-doped phosphate glass waveguide amplifiers as an example) are studied theoretically. For the homemade laser glass materials the calculated saturation intensities are 2.22kw /cm² for signal and 10.15kw/cm² for pump. The effects of absorption saturation of signal and pump lights on the gain of amplifiers are discussed.     

若干具有[(PO_4)_4Mo_6~ⅤO_(15)]~(12-)簇骼的化合物的光谱研究

用FTIR ,NIRFT Raman ,UV VisDRS和荧光光谱等对五个新型具有 [(PO4) 4 MoⅤ6O15]12 -阴离子簇的化合物 :Na·(H4TETA) 3 ·(H3 O) 5·{Zn[(HPO4) 2 (PO4) 2 Mo6O15]2 } (2 ) ,(H2 en) 7·(H3 O) 4 ·{Cu[(HPO4) 2(PO4) 2 Mo6O15]2 }·H2 O (3) ,(H3 DETA) 2 ·(H3 O) 3 ·{Co0 5[(HPO4) 2 (PO4) 2 Mo6O15]}·H2 O (4) ,[Co(H3 TETA) ]2 {Co0 5[(HPO4) (PO4) 3 Mo6O15]}· 3 5H2 O (5 )和 (H3 DETA)· (H3 O ) 4 · {Co1 5[(HPO4) 2(PO4) 2 Mo6O15]}·0 5H2 O (6 ) ,进行研究 ,并探讨其结构和性能的关系。这些化合物具有 {M [(PO4) 4 Mo6O15]2 }二聚体单元 ,化合物 2～ 4的二聚体间通过与有机分子和水分子的氢键形成三维网状结构 ;化合物 5和 6的 {Co[(PO4) 4 Mo6O15]2 }二聚体间是分别通过 [CoH3 TEATA]基团和CoO4四面体组成网状结构。磷钼酸盐的特征振动频率和这些化合物的结构相关 ;化合物的三个UV VisDRS特征谱带分别属于Od→Mo,Oμ→Mo和O→M电荷转移 ;观察到以 2 4 0nm激发 ,在 4 10nm附近出现的由Oμ→Mo跃迁激发引起的较强的荧光发射谱带。