Hydrothermal synthesis of potassium molybdenum oxide bronzes: structure-inheriting solid-state route to blue bronze and dissolution/deposition route to red bronze

The hydrothermal syntheses of the alkali metal molybdenum bronzes from starting solids (H_xMoO₃) with structural affinities to the desired products were investigated. Single-phase potassium blue and red bronzes were prepared by the hydrothermal treatments at around 430 K, and characterized by powder X-ray diffraction, IR spectroscopy, and SEM. The formation processes of these two bronzes during the hydrothermal treatments were found to differ. The blue bronze was formed by a structure-inheriting solid-state route from H_xMoO₃ with x<0.3, whereas the red bronze was formed for x>0.3 through a solution dissolution/deposition route via the formation of MoO₃+MoO₂.     

胶束溶液中高氯酸二水(四胺)合钴(Ⅲ)配合物催化磷酸二酯水解的研究

本文合成了疏水性高氯酸二水（四胺）合钴（Ⅲ）配合物，研究了它与非离子表面活性剂Brij35形成的金属2胶束催化二（对硝基苯酚）磷酸二酯水解的动力学及其机理。结果表明此金属胶束对磷酸二酯水解的速率大约提高10^4倍，这主要是由于表面活性剂胶束的pH效应和浓聚效应所致，暗示着顺式二水类配合物形成的金属胶束是一个潜在的磷酸二酯水解剪切的催化剂。     

Investigation of the chemical heterogeneity of polyphenylenes using the condensation of methyl aryl ketones as a model reaction

The chemical heterogeneity of polyphenylenes obtained by trimerization poiycycio-condensation of acetylaromatic compounds has been investigated by GLC-MS analysis of the products of trimerization cyclocondensation of acetophenone. The mechanism for the formation of side products of the reaction is discussed. The presence of dypnone fragments in the polyphenylene structure results in a decrease in the thermal stability of these polymers.Deceased March, 1993.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 9, pp. 1595–1601, September, 1993.     

Kinetic Analysis of the Mechanism of Oxidation of CO on Co/ZSM-5

We have studied the kinetic behavior of oxidation of carbon monoxide on Co-containing zeolite ZSM-5. We have shown that the kinetic curves obtained for the dependence of the reaction rate on the reagent concentration can be described by an Eley–Rideal mechanism, which assumes that oxygen can be adsorbed on the surface of the catalyst in both atomic and molecular form, followed by reaction of CO from the gas phase with the adsorbed oxygen.     

过硫酸盐和N,N,N′,N′-四甲基乙二胺体系引发烯类聚合机理的研究

<正> 过硫酸盐和N,N,N′,N′-四甲基乙二胺(TMEDA)体系用作烯类聚合的引发剂已有报道。本文报道该引发体系的反应机理。1.实验方法     

Highly efficient redox isomerization of allylic alcohols at ambient temperature catalyzed by novel ruthenium-cyclopentadienyl complexes--new insight into the mechanism

A range of ruthenium cyclopentadienyl (Cp) complexes have been prepared and used for isomerization of allylic alcohols to the corresponding saturated carbonyl compounds. Complexes bearing CO ligands show higher activity than those with PPh3 ligands. The isomerization rate is highly affected by the substituents on the Cp ring. Tetra(phenyl)methyl-substituted catalysts rapidly isomerize allylic alcohols under very mild reaction conditions (ambient temperature) with short reaction times. Substituted allylic alcohols have been isomerized by employing Ru-Cp complexes. A study of the isomerization catalyzed by [Ru(Ph5Cp)(CO)2H] (14) indicates that the isomerization catalyzed by ruthenium hydrides partly follows a different mechanism than that of ruthenium halides activated by KOtBu. Furthermore, the lack of ketone exchange when the isomerization was performed in the presence of an unsaturated ketone (1 equiv), different from that obtained by dehydrogenation of the starting allylic alcohol, supports a mechanism in which the isomerization takes place within the coordination sphere of the ruthenium catalyst.     

Pulse radiolysis study of I− oxidation with radical anions Cl2 ⋅− in an aqueous solution

Radiation-chemical transformations of chloride solutions in the presence of iodide additives were studied by pulse radiolysis. Radical anion Cl₂ ^⋅− oxidize I⁻ ion, while in the secondary reactions Cl₂ reacts with I⁻ to form a mixed trihalide ion ICl₂ ⁻. A reaction model that satisfactorily describes the experimental data was proposed. Published in Russian in Izvestiya Akademii Nauk. Seriya Khimicheskaya, No. 6, pp. 1336–1340, June, 2005.     

橡胶增韧环氧树脂机理的研究

本文研究了固化剂种类、环氧基体平均网链长度和分散相与基体间键合情况对体系韧性等的影响.结果说明,基体平均网链长度是一个更为重要的影响因素.分散相与基体间的化学键合也是重要的.文中对橡胶增韧环氧树脂的机理提出了见解.在交联密度较低的材料中,在橡胶颗粒附近叠加的应力场诱发下发生纵深度较大的断裂过程.分散相与基体间的化学键合增大该应力场强度有利于加大断裂过程区.     

Sol-gel polyimide-silica composite membrane: gas transport properties

The effect of introduction of silica particles prepared by the sol-gel technique on the gas transport properties of a polyimide film was studied. The sorption and permeation of N₂, O₂, CO₂, H₂ and CH₄ were studied and correlated with morphological changes in the polymer structure. From sorption isotherms, we observed that the composite membrane presents higher solubility coefficients than the polyimide one. The solubility coefficient ratio between the composite and the polyimide is about 1.5–2.0. The isotherms were analyzed in terms of the dual mode sorption. The Henry's coefficient and the Langmuir's affinity and saturation constants were obtained allowing to calculate the Langmuir to Henry concentration ratios as function of the gas pressure. These ratios decrease until zero within a certain pressure range as long as the Langmuir's mode is acting and they are higher for the polyimide membrane when compared with the composite one. This study was completed with calorimetric measurements during the sorption. The gas interaction energy in kJ/mol decreases within the same pressure range as previously described. The measured energies are higher for the polyimide film when compared with the composite one because the polyimide membrane presents a stronger energetic effect caused by a higher Langmuir's contribution. From permeation studies at 3.15⁵ Pa, the composite membrane showed higher permeability coefficients and permselectivities than the polyimide one. All these results were explained, taking into account the difference on the imidization degree of both membranes and the morphological changes which may be induced by the silica nodules in the organic/inorganic interphases.     

Mechanism and Kinetics of Thermal Dissociation of Inclusion Complex of Benzaldehyde with β-Cyclodextrin

The inclusion complex of benzaldehyde (BA) with β-cyclodextrin (β-CD) was prepared and was studied by thermal analysis and X-ray diffractometry. The composition of the complex was identified by TG and elemental analysis as β-CD·BA·9H₂O. TG and DSC studies showed that the thermal dissociation of β-CD·BA·9H₂O took place in three stages: dehydration in the range 70-120°C; dissociation of β-CD·BA in the range 235-270°C; and decomposition of β-CD above 280°C. The kinetics of dissociation of β-CD·BA in flowing dry nitrogen was studied by means of TG both at constant temperature and at linearly increasing temperature. The results showed that the dissociation of β-CD·BA was dominated by a one-dimensional random nucleation and subsequent growth process (A₂). The activation energy E was 124. 8 kJ mol^-1, and the pre-exponential factor A 5.04·10¹¹ min^-1. This revised version was published online in July 2006 with corrections to the Cover Date.