铈杂多配离子-水滑石超分子层柱材料ZnAl-Ce(PMoV)2的插层组装、表征及催化性能

以十四酸根阴离子柱撑Zn-Al水滑石Zn0.77Al0.22(OH)2.0.22C13H27COO.0.81 H2O(记为ZnAl-14A)为预撑前体,在水溶液中用离子交换法将以2∶17缺位杂多酸根离子(P2Mo16VO61)11-记为(P Mo V)为配体的稀土杂多配阴离子Ce(P2Mo16VO61)219-(记为Ce(PMoV)2)插层组装到水滑石层板间,合成了一种具有大的层间距(3.37 nm)的超分子插层材料Zn0.77Al0.23(OH)2.0.0105[Ce(P1.9Mo15.7V1.1O61)2].0.011C13H27COO.0.83H2O(记为ZnAl-Ce(PMoV)2)。用ICP,IR,XRD和DTA对产物的组成和结构进行了表征。结果表明,该产物中Ce(PMoV)2配阴离子沿其长轴垂直于层板的方向分布于水滑石层间;产物具有规整的层状结构和热稳定性;产物对乙酸与正丁醇的酯化反应,二甘醇的脱水-环化反应和H2O2氧化环己烷的反应有良好的催化性能,且易于回收重复使用。     

单斜层状LiMnO2的球磨-离子交换法合成及其电化学性能研究

通过球磨促进固相反应法合成出了具有单斜层状结构的前驱物NaMnO₂，随后通过离子交换得到了单斜层状LiMnO₂。XRD测试结果显示产物为单相。扫描电镜(SEM)和透射电镜(TEM)观测结果显示LiMnO₂的粒子尺寸为300～500 nm，HRTEM分析显示干扰条纹的间距为0.485 nm，基本对应于m-LiMnO₂的(001)晶面间距。红外吸收光谱(IR)和X射线光电子能谱(XPS)被用来测量m-LiMnO₂中Mn-O键的伸缩和弯曲振动吸收和Mn元素的价态。合成的m-LiMnO₂在电化学充放电循环初期表现了较好的电化学性能，但其循环寿命仍需要进一步改善。     

微乳液法合成LiFePO4 / C正极材料及其电化学性能

本文采用微乳液方法合成了纳米LiFePO₄ / C正极材料。制备样品分别用XRD和SEM进行表征，充放电测试其电化学性能。600 ℃制备样品为单一物相，平均粒径90 nm，在室温2.0～4.0 V (vs Li) 放电电压范围和15 mA·g^-1放电速率下，首次放电容量达到159 mAh·g^-1。制备样品同样展现良好的循环性能。在15 mA·g^-1速率下40次循环后，制备样品放电容量仍保持首次放电容量的98.9%。优异的电化学性能得益于样品颗粒的纳米尺寸、均匀分布以及表面碳层包覆提高了活性材料的电子电导率。     

Effect of lithium oxide dopants on electrophysical and sorption properties of zinc oxide

The effects of lithium oxide dopants (0.5–0.8 at. % Li) on the electrophysical and sorption properties of ZnO were studied in the temperature range from 150 °C to 410 °C. The introduction of lithium increases the activation energy of the conductivity of ZnO, decreases its conductivity, and increases the amount of S0₂ sorbed. Two forms of chemisorbed SO₂ (donor and acceptor) are observed on the surface.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 5, pp. 1096–1100, May, 1996.     

冠醚B15C5萃取分离锂同位素的阴离子效应

本文研究了B15C5冠醚萃取锂盐时,不同阴离子对体系的同位素分离效应的影响。结果表明,阴离子在冠醚萃取过程中不仅对萃取络合物的稳定性有显著影响,而且阴离子半径及软度越大时,萃取体系的锂同位素分离系数(α_(LI))也越大。     

Synthesis of New Lithium Ionic Conductor Thio-LISICON—Lithium Silicon Sulfides System

The new lithium ionic conductors, thio-LISICON (LIthium SuperIonic CONductor), were found in the ternary Li₂S-SiS₂-Al₂S₃ and Li₂S-SiS₂-P₂S₅ systems. Their structures of new materials, Li_4+xSi_1−xAl_xS₄ and Li_4−xSi_1−xP_xS₄ were determined by X-ray Rietveld analysis, and the electric and electrochemical properties were studied by electronic conductivity, ac conductivity and cyclic voltammogram measurements. The structure of the host material, Li₄SiS₄ is related to the γ-Li₃PO₄-type structure, and when the Li⁺ interstitials or Li⁺ vacancies were created by the partial substitutions of Al³⁺ or P⁵⁺ for Si⁴⁺, large increases in conductivity occur. The solid solution member x=0.6 in Li_4−xSi_1−xP_xS₄ showed high conductivity of 6.4×10^-4 S cm⁻¹ at 27°C with negligible electronic conductivity. The new solid solution, Li_4−xSi_1−xP_xS₄, also has high electrochemical stability up to ∼5 V vs Li at room temperature. All-solid-state lithium cells were investigated using the Li_3.4Si_0.4P_0.6S₄ electrolyte, LiCoO₂ cathode and In anode.     

3-Cyanopyridine-2(1H)-thiones and 3-cyano-2-(methylthio)pyridines in the synthesis of substituted 3-(aminomethyl)pyridines

The reactions of substituted 3-cyanopyridine-2(1H)-thiones and 3-cyano-2-(methylthio)pyridines with lithium aluminum hydride in anhydrous diethyl ether afforded the corresponding 3-aminomethyl derivatives, which were used in the synthesis of the corresponding amides.     

Application of the chiral base desymmetrisation of imides to the synthesis of the alkaloid jamtine and the antidepressant paroxetine

The synthesis of the alkaloid jamtine and the antidepressant paroxetine have been addressed by a strategy involving asymmetric desymmetrisation of prochiral imides by a chiral lithium amide base. A short reaction sequence, starting with a cyclohexane fused succinimide, led to the structures originally reported for the alkaloid jamtine and its derived N-oxide. The structures synthesised are shown not to correspond with those originally reported. A second sequence involves desymmetrisation of a 4-arylglutarimide, and provides a short enantioselective synthesis of the drug substance paroxetine.     

Lithium bromide in acetonitrile: Thermodynamics,theory, and simulation

A variety of methods has been used for the study of lithium bromide solutions in acetonitrile yielding by their combination reliable information on different levels of approximation. Osmotic coefficients based on precise vapor pressure measurements are reproduced by CM (chemical model) and HNC (hypernetted chain) calculations and by BD (brownian dynamics) simulations. The results of neutron scattering experiments are treated with the help of HNC and BD methods. Hartree-Fock calculations on isolated LiBr pairs and solvated lithium ions yield reliable particle distances and reveal the geometry of the lithium solvation sphere.