Applicability of the Levich Equation for a Two-Phase Solution in the Rotating Disk Electrode System

The mass-transter characteristics of a two-phase system formed by mixing a fixed quantity (20 v/v%) of organic solvent with an aqueous ferricyanide electrolyte solution in an RDE system were studied. The Levich eqution, I₁ = 0.62 nFAC_bD^2/3v^?1/6_ω^1/2, was found to be applicable to the two-phase system with only a minor modification in the angular velocity (ω) at Reynolds numbers between 3–5 × 10⁴. The experimental results indicate that the interfacial tension is the most important variable for the two-phase system. One group of organic solvents with smaller interfacial tension, such as benzene or toluene, needs a modification of the Levich equation by replacing the observed angular velocity (ω_o) with the true angular velocity (ω_t) which was observed to be 1.1 times the observed angular velocity. For the other group with larger interfacial tension, such as n-hexane or cyclohexane, there is no need to modify the observed angular velocity. In other words, the Levich equation may be expressed as I₁ = 0.65 nFAC_bD^2/3v^?1/6ω^1/2 for two-phase solution if the interfacial tension is smaller than 37.0 dyne/cm.     

Mass transport in gas channels of electrochemical cells with a solid-oxide electrolyte: Allowing for the electrode reaction rates in numerical calculations

The concentration fields, Nusselt number distributions along the electrode, and ratios of concentrations of electrochemically active components at the entrance into and exit out of an electrochemical cell are determined by numerical integration of the convective-diffusion equation for a broad range of rate constants of electrode reactions, Peclet numbers, and geometrical parameters of channels. Three regions of parameter values are revealed. At low reaction rates (K _l < 0.5), mass transfer is completely determined by electrode kinetics; at high rates (K _l > 20), it is completely determined by the diffusion in the gas phase; and in the intermediate region of values of K _l it is necessary to allow for both the diffusion processes and the electrode reactions.Translated from Elektrokhimiya, Vol. 41, No. 3, 2005, pp. 317–324.Original Russian Text Copyright © 2005 by Ezin, Somov.     

电化学氟化的新进展

电化学氟化是利用电极反应将氟直接引入有机或无机物的一种重要方法。有机物的电化学氟化方法有两种: 一是Simons于1941年发明的, 用镍作阳极, 在无水氟化氢溶液中, 电解制备全氟化合物的方法。此方法在近年来有不少改进。另一是1970年Rozhkov提出的, 以有机溶剂(如含Et3N.3HF的MeCN)为介质, 在铂阳极上,氧化得到单氟化产物的方法。本文全面地综述了这两种方法, 并着重于最新民发展。     

Enhanced deep-red emission in donor-acceptor molecular architecture: The role of ancillary acceptor of cyanophenyl

Cyanophenyl as ancillary acceptor to modify donor-acceptor compound,plays an effective role in shifting the emission color to deep red and maintaining the luminescent efficiency.     

Application of Nafion／Cobalt Hexacyanoferrate Chemically Modified Electrodes for the Determination of Electroinactive Cations by Ion Chromatography

Ｉｎｔｒｏｄｕｃｔｉｏｎ　　Ｉｏｎｃｈｒｏｍａｔｏｇｒａｐｈｙ (ＩＣ)ｈａｓｂｅｅｎｒｅｃｏｇｎｉｚｅｄａｓａｕｓｅｆｕｌｍｅｔｈｏｄｆｏｒｔｈｅｓｅｐａｒａｔｉｏｎｏｆｉｎｏｒｇａｎｉｃａｎｉｏｎｓａｎｄｃａｔｉｏｎｓｓｉｎｃｅｉｔｓｉｎｔｒｏｄｕｃｔｉｏｎｂｙＳｍａｌｌｅｔａｌ .ｉｎ 1975 .1ＡｓｉｇｎｉｆｉｃａｎｔｔｒｅｎｄｉｎｔｈｅｄｅｖｅｌｏｐｍｅｎｔｏｆＩＣｍｅｔｈｏｄｉｓｓｅａｒｃｈｆｏｒｓｅｎｓｉｔｉｖｅａｎｄｕｎｉｖｅｒｓａｌｄｅｔｅｃｔｉｏｎｍｅｔｈｏｄｓ .Ｔｈｅｍａｉｎｄｅｔ…     

Electrochemical detector with a 20 nl volume for micro-columns liquid chromatography

Summary A flow-through two electrode wall-jet cell with a platinum measuring electrode and a cell volume of 20 nl has been designed and evaluated. It has been used to detect phenols by reversed phase liquid chromatography using short micro bore columns. The linear dynamic range between the measured current and the concentration is greater than 10³ (1.5×10^–7–5×10^–4 mol/l) and the minimum analyzable amount was found to be 10 pg for pyrocatechol. A negligible broadening in the detector permits the use of micro columns down to 0.5 mm internal diameter, packed with 5 m particles, without any substantial distortion of eluted zones.Presented at the 14th International Symposium on Chromatography London, September, 1982     

壳聚糖作用下一步法合成具有高电活性的AgCl@聚苯胺核壳结构

在壳聚糖的作用下，采用简单的一步法合成了具有星状结构的氯化银/聚苯胺核壳型复合材料。当壳聚糖的浓度为1%时，所制备的氯化银/聚苯胺复合材料具有高度的分散性，壳层厚度为30～80 nm、核的直径在25～60 nm范围内。通过透射电镜、红外光谱和X-射线衍射对样品的形态和组成进行了表征。循环伏安实验结果表明这种复合材料在中性条件下具有很好的电化学活性。     

New organic metals: Radical cation salts of bis(ethylenedioxo)tetrathiafulvalene with halide mercurate anions

Radical cation salts with halide mercurate anions were obtained by the electrochemical oxidation of bis(ethylenedioxo)tetrathiafulvalene (BEDO-TTF), and their conductivity was studied. The compounds (BEDO-TTF)₄Hg₃X₈ (X = Cl or Br), (BEDO-TTF)₄Hg_3.5I₉, and (BEDO-TTF)₂HgBr₃ possess the conductivity of the metallic type down to helium temperatures.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 5, pp. 1167–1170, May, 1996.     

Study on the anodic reaction of Ni in an alkaline solution by transient pH detection based on scanning electrochemical microscopy (SECM)

The anodic reaction of Ni in an alkaline solution was studied by the tip–substrate voltammetry mode of scanning electrochemical microscopy (SECM) and cyclic voltammetry (CV). A platinum microdisc electrode was selected as the tip electrode, which functioned as a pH sensor with transient response capability. The pH value of the solution near the Ni electrode surface varied while the Ni substrate oxidation reaction occurred, and the pH variation could be detected by the tip faradic current. The cyclic voltammogram results showed that two types of hydroxides: i.e. α‐Ni(OH)₂ and β‐Ni(OH)₂ were formed during Ni oxidation in the lower potential region. In the proceedings of α‐Ni(OH)₂ → γ‐NiOOH and β‐Ni(OH)₂ → β‐NiOOH, the process of OH^? concentration decrease in the solution was ahead and behind of electron transfer in the solid phase, respectively. These results indicate that the OH^? adsorption process occurs as an elementary step in the former reaction and the H⁺ diffusion process from the inner to the outer layer of the solid phase occurs as a subsequent step in the latter reaction. The results also revealed that the oxide film on the Ni surface has a two‐layer structure. The real potential of the oxygen evolution reaction (OER) on the Ni surface with different cycles is also analyzed in the paper. Copyright © 2007 John Wiley & Sons, Ltd.     

Influence of Urbach Energy,Temperature, and Longitudinal Position in the Active Layer on Carrier Diffusion Length in Perovskite Solar Cells

The diffusion length of charge carriers in the active layer of a perovskite solar cell (PSC) of the structure Glass/PEDOT: PSS/CH₃NH₃PbI₃/PC60BM/Al is modelled. It is found that the diffusion length depends on the position x in the active layer measured from the PEDOT: PSS interface, Urbach energy and temperature. By varying the voltage in the range from zero to , it is shown that the dependence of diffusion length on the position x in the active layer reduces at higher voltage. The combined influence of applied voltage and temperature on the diffusion length of charge carriers is investigated and it is found that in the low voltage range the diffusion length is temperature independent, but it becomes significantly temperature dependent at higher voltages. Also, it is found that the diffusion length decreases as the applied voltage increases and this reduction becomes much more significant at higher voltage and temperatures. The combined influence of applied voltage and Urbach energy on diffusion length of charge carriers reveals that the diffusion length decreases when both the applied voltage and Urbach energy increase. However, the reduction in the diffusion length due to the increase in Urbach energy becomes less significant at higher voltage.