QEPAS系统中石英音叉模态仿真计算与研究

对石英音叉增强型光声光谱(QEPAS)系统中常用的石英音叉进行了有限元模态计算，获得石英音叉前6阶振型与模态频率，认知了第4阶对称摆动振型为有效振动，利用单因素法分析了石英音叉的音臂长度l₁、音臂宽度w₁、音臂厚度t、音臂切角θ、音臂圆孔直径d及音臂圆孔高度h对低阶有效共振频率(Fre)的影响，敏感度依次为： l₁> w₁>d>θ>t>h，考虑实际设计情形，筛选出了l₁，w₁，d与h四个石英音叉设计变量，采用Box-Behnken实验设计方案与RSM(response surface methodology)方法，以Fre为函数目标，建立l₁，w₁，d与h的二次回归响应面模型，得到了参数之间的交互作用，利用Design-Expert软件对响应面模型进行设计参数反求，结果表明，在15 000 Hz≤Fre≤25 000 Hz计算区域内误差较小，基本满足QEPAS系统的计算需求，所提出的研究与设计方法具有一定通用性，可为QEPAS系统中石英音叉结构参数设计提供参考。     

Improved spacer design and cost reduction in an electrodialysis system

In electrodialysis using thin membranes and spacers, the compactness of the membrane cell-pairs leads to a small potential drop, and hence to energy saving. The spacer design itself has a great effect on the cost of the plants, since spacers act as turbulence promoters. A careful design, to increase the mass transfer coefficients, can reduce the membrane surface area required for a given application. Limiting current measurements, cell-pair resistance and pressure losses are presented for several thin spacers, for different flow-velocity values and feed water concentrations. It was possible to find an advantageous geometry of the separating mesh leading to substantial savings on investment and operation costs.     

固体力学有限元体系的结构拓扑变化理论

本文是文[1]的继续.文[1]提出了杆件系统的结构拓扑变化理论和拓扑变化法本文将这一理论和方法推进到连续体有限元体系;且在此基础上揭示出有限元体系的一个新性质,称为基本位移之梯度的正交性定理,从而给出一套设计敏度的显式表达式,可直接用于计算.     

Preliminary Contribution to the Quantification of HMF in Honey by Electrochemical Biosensor Chips

Several hydroximethylfurfural (HMF) microbiosensors, based on a microelectrode configuration built by photolithographic techniques, have been developed. Two different biosensors based on the aldehyde dehydrogenase (ALDH) enzyme coupling with NADH oxidase (NOD) or diaphorase (Diaph) are described. Experimental variables were optimized using experimental design methodology, by central composite designs, taking the intensity registered for a given HMF solution as response. Given the reproducibility (residual standard deviation (RSD), 7.20%), repeatability (RSD=3%) and limit of detection (LOD)=1.68×10^?4 mol dm^?3 (α=β=0.05 and a replicate) reached by the ALDH‐Diaph microbiosensor under the optimum conditions, the analysis of HMF in honey was successfully accomplished.     

A profit-maximizing supply chain network design model with demand choice flexibility

We present a profit-maximizing supply chain design model in which a company has flexibility in determining which customers to serve. The company may lose a customer to competition if the price it charges is too high. We show the problem formulation and solution algorithm, and discuss computational results.     

Large set of P3‐decompositions

Let G=(V(G),E(G)) be a graph. A (n,G, λ)‐GD is a partition of the edges of λK_n into subgraphs (G‐blocks), each of which is isomorphic to G. The (n,G,λ)‐GD is named as graph design for G or G‐decomposition. The large set of (n,G,λ)‐GD is denoted by (n,G,λ)‐LGD. In this work, we obtain the existence spectrum of (n,P₃,λ)‐LGD. © 2002 Wiley Periodicals, Inc. J Combin Designs 10: 151–159, 2002; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/jcd.10008     

第一类永动机幻梦的破灭

介绍了13~18世纪物理学史和科技史上曾名噪一时的第一类永动机的设计方案的破灭.第一类永动机幻梦破灭的历史引起了人们的反思与启示,有力地促进了19世纪中叶能量转化和守恒定律的确立.     

Commuting and stable feedback design for switched linear systems

In the paper, commuting and stable feedback design for switched linear systems is investigated. This problem is formulated as to build up suitable state feedback controller for each subsystem such that the closed-loop systems are not only asymptotically stable but also commuting each other. A new concept, common admissible eigenvector set (CAES), is introduced to establish necessary/sufficient conditions for commuting and stable feedback controllers. For second-order systems, a necessary and sufficient condition is established. Moreover, a parametrization of the CAES is also obtained. The motivation comes from stabilization of switched linear systems which consist of a family of LTI systems and a switching law specifying the switching between them, where if all the subsystems are stable and commuting each other, then the total system is stable under arbitrary switching.     

On c‐Bhaskar Rao designs with block size 4

Several new families of c‐Bhaskar Rao designs with block size 4 are constructed. The necessary conditions for the existence of a c‐BRD (υ,4,λ) are that: (1)λ_min=?λ/3 ≤ c ≤ λ and (2a) c≡λ (mod 2), if υ > 4 or (2b) c≡ λ (mod 4), if υ = 4 or (2c) c≠ λ ? 2, if υ = 5. It is proved that these conditions are necessary, and are sufficient for most pairs of c and λ; in particular, they are sufficient whenever λ?c ≠ 2 for c > 0 and whenever c ? λ_min≠ 2 for c < 0. For c < 0, the necessary conditions are sufficient for υ> 101; for the classic Bhaskar Rao designs, i.e., c = 0, we show the necessary conditions are sufficient with the possible exception of 0‐BRD (υ,4,2)'s for υ≡ 4 (mod 6). © 2002 Wiley Periodicals, Inc. J Combin Designs 10: 361–386, 2002; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/jcd.10009