Parametric analysis of lugged wheel performance for a lunar microrover by means of DEM

The purpose of this study was to develop a numerical tool to simulate the performance of lugged wheels designed for a lunar microrover. The performance was analyzed using a Discrete Element Method (DEM) whose accuracy was validated for interactions between lugged wheels and soil. DEM analysis indicated that, on flat horizontal lunar surfaces, wheels with 18 10-mm-high lugs would provide less net traction than would wheels with 36 5-mm-high lugs.     

并行计算机和计算流体力学并行算法

对研制计算流体力学高效并行算法及软件具有重要意义的并行计算问题提出了导引性的看法．首先综述了并行计算机的主要设计特征并简要描述了市场现有的几种并行系统．接着介绍了一些有关研制并行算法及评价其性能的重要概念．然后讨论了如何使分布式内存并行计算机的运行负载不平衡和通信开销达到最小．最后列举了计算流体力学某些算例的测试结果．本文的重点是结构网格和分程序结构网格的应用，但这些概念和方法对非结构网格同样有效     

硅相锌基复合材料减摩抗磨性能的研究

为了改善锌铝合金在干摩擦条件下的耐磨性能，拓宽它的工程应用范围，在其中添加质量分数为１０％的Ｓｉ，同时以质量分数０．１％～０．３％的Ｐ－Ｃｕ对硅相进行变质处理，研制出硅相增强锌基复合材料，并且对这种材料的减摩抗磨性能进行了试验研究．结果表明：硅相锌基复合材料分别在干摩擦和２０＃机械油滴油润滑条件下的减摩抗磨性能良好．扫描电子显微镜观察发现，硅相锌基复合材料中的硅相经变质处理得以细化和分布均匀化，这对改善锌铝合金的综合性能具有重要作用；由于硅相的硬度远比基体的高，在滑动摩擦过程中可以起支撑作用，减少偶件与基体的直接接触而降低摩擦磨损     

Preparation of a monolith functionalized with zinc oxide nanoparticles and its application in the enrichment of fluoroquinolone antibiotics

This study describes the enrichment ability of ZnO‐modified methacrylic acid‐co‐ethylene dimethacrylate polymer monoliths as stationary phases for the simultaneous determination of antibiotics (ofloxacin, ciprofloxacin, enoxacin, and pefloxacin) combined with high‐performance liquid chromatography. The prepared monolith was characterized by scanning electron microscopy, X‐ray photoelectron spectroscopy, Fourier‐transformed infrared spectroscopy, and thermogravimetric analysis. The polymer monolith microextraction method has been applied to the enrichment of fluoroquinolone antibiotics and satisfactory results were obtained in the analysis of water samples. Compared with the conventional methacrylic acid based monolith, the developed monolith exhibited a higher enrichment capacity because of the introduction of zinc oxide into the preparation process.     

Determination of diflubenzuron and chlorbenzuron in fruits by combining acetonitrile‐based extraction with dispersive liquid–liquid microextraction followed by high‐performance liquid chromatography

In this study, a simple and low‐organic‐solvent‐consuming method combining an acetonitrile‐partitioning extraction procedure followed by “quick, easy, cheap, effective, rugged and safe” cleanup with ionic‐liquid‐based dispersive liquid–liquid microextraction and high‐performance liquid chromatography with diode array detection was developed for the determination of diflubenzuron and chlorbenzuron in grapes and pears. Ionic‐liquid‐based dispersive liquid–liquid microextraction was performed using the ionic liquid 1‐hexyl‐3‐methylimidazolium hexafluorophosphate as the extractive solvent and acetonitrile extract as the dispersive solvent. The main factors influencing the efficiency of the dispersive liquid–liquid microextraction were evaluated, including the extractive solvent type and volume and the dispersive solvent volume. The validation parameters indicated the suitability of the method for routine analyses of benzoylurea insecticides in a large number of samples. The relative recoveries at three spiked levels ranged between 98.6 and 109.3% with relative standard deviations of less than 5.2%. The limit of detection was 0.005 mg/kg for the two insecticides. The proposed method was successfully used for the rapid determination of diflubenzuron and chlorbenzuron residues in real fruit samples.     

High‐performance liquid chromatographic column packings with different particle sizes: Chromatographic behavior for the quality analysis of HuanglianShangqing pill

The chromatographic separation of traditional Chinese medicines is still a highly challenging task in analytical science with respect to its hundreds and thousands of chemical compounds, while increase of separation efficiency can greatly improve the separation power of chromatographic column for traditional Chinese medicine. In this study, 13 bioactive components in HuanglianShangqing pill were selected as an index to optimize the separation conditions and evaluate the system suitability of three commercially available columns packed with 1.8, 3.5, and 5.0 μm particles. The chromatographic separations were obtained by the most appropriate Eclipse Plus C₁₈ column (100 × 2.1 mm, 3.5 μm) within 45 min using gradient elution with aqueous‐ammonium acetate (10 mmol/L, pH 5.0) and acetonitrile, at a flow rate of 0.3 mL/min and an operating temperature of 30°C. The quality of HuanglianShangqing pill was assessed through combining simultaneous quantification of 13 compounds with fingerprint analysis. For the qualitative analysis, mass spectrometry was used to confirm the 13 compounds. All the validation data conformed to the acceptable requirements. For the fingerprint analysis, 32 peaks were selected as the common peaks at 254 nm to evaluate the similarities among HuanglianShangqing pills obtained from ten manufacturers.     

Reversed‐phase vortex‐assisted liquid–liquid microextraction: A new sample preparation method for the determination of amygdalin in oil and kernel samples

A novel, simple, and rapid reversed‐phase vortex‐assisted liquid–liquid microextraction coupled with high‐performance liquid chromatography has been introduced for the extraction, clean‐up, and preconcentration of amygdalin in oil and kernel samples. In this technique, deionized water was used as the extracting solvent. Unlike the reversed‐phase dispersive liquid–liquid microextraction, dispersive solvent was eliminated in the proposed method. Various parameters that affected the extraction efficiency, such as extracting solvent volume and its pH, vortex, and centrifuging times were evaluated and optimized. The calibration curve shows good linearity (r² = 0.9955) and precision (RSD < 5.2%) in the range of 0.07–20 μg/mL. The limit of detection and limit of quantitation were 0.02 and 0.07 μg/mL, respectively. The recoveries were in the range of 96.0–102.0% with relative standard deviation values ranging from 4.0 to 5.1%. Unlike the conventional extraction methods for plant extracts, no evaporative and re‐solubilizing operations were needed in the proposed technique.     

Analysis of a new drug of abuse: Cathinone derivative 1‐(3,4‐dimethoxyphenyl)‐2‐(ethylamino)pentan‐1‐one

Recently, novel psychoactive drugs for human abuse such as amphetamines, phenethylamines, benzofuries, and tryptamines, cathinones have gained high popularity. These designer drugs are mainly sold via online stores as “bath salts” and are labeled “not for human consumption.” Due to the novelty of the compounds, only a little information about pharmacology, toxicology, and the long‐term damage they may cause is available. Moreover, there are only few analytical methods for their identification and analysis. Among new cathinone derivatives, 1‐(3,4‐dimethoxyphenyl)‐2‐(ethylamino)pentan‐1‐one (DL‐4662), became available via an internet shop. A sample of this compound was purchased and investigated. The first aim of our study was an identity check by NMR spectroscopy and gas chromatography with mass spectrometry. As many of the recreational drugs are chiral and are mainly sold as racemates, a further goal of our research was enantioseparation by gas chromatography with mass spectrometry and high‐performance liquid chromatography with UV detection, to prove whether DL‐4662 was traded enantiomerically pure or as racemic mixture. Both chiral separation methods showed the presence of a racemate.     

Ultrasound‐assisted emulsification microextraction coupled with high‐performance liquid chromatography for the simultaneous determination of fragrance allergens in cosmetics and water

A simple, inexpensive, and environmentally friendly method based on ultrasound‐assisted emulsification microextraction followed by solidification of floating organic drop and high‐performance liquid chromatography coupled to diode array detection was developed for the simultaneous determination of 18 potentially allergenic fragrance substances. Several parameters affecting the microextraction process were investigated in detail by the “one‐variable‐at‐a‐time” approach. Optimal conditions were the following: 50 μL of 2‐dodecanol as extraction solvent, 10 mL of sample containing 150 g/L of salt, and 5 min of sonication at 35°C. Under the optimized conditions, method showed good linearity in the selected ranges, with squared correlation coefficients ranging from 0.948 to 0.999. Limits of detection ranged from 0.001 to 0.154 μg/mL and enrichment factors from 9 to 237. Precision of the method, expressed as relative standard deviation, was checked at two levels obtaining good results (3.3–14.4%). Recovery studies were made in baby bath water and in eau de cologne showing acceptable accuracy. Finally, the developed method was successfully applied to different commercial cosmetic and water samples. The most commonly found analyte was linalool followed by cinnamal and lilial. Most of the analyzed samples contained at least one of the target compounds.