高功率横流CO2激光器脉冲预电离过程研究

本文给出了对高功率横流CO_2激光器脉冲预电离过程的理论和实验研究.表明了预电离过程中光电离的重要作用.实验结果表明,脉冲预电离可增大高功率横流CO_2.激光器的pd值(p为放电气压、d为放电间隔),增大放电区注入功率密度.对于提高此类型激光器的放电稳定性和输出激光功率是一种技术简单而有效的手段.     

New fluorescence probes for monitoring the kinetics of laser-initiated polymerization

Several new fluorescence probes useful for following photopolymerization have been characterized. Among these are probes which can be used in rapidly gelling monomer mixtures and for photochemical polymerization initiated by very high laser powers. Systems which can be used with polyolacrylates and either with visible initiators or with UV initiators are reported. © 1993 John Wiley & Sons, Inc.     

谱任意的符号模式矩阵

一个n阶符号模式矩阵A称为是谱任意的,如果对任意的实系数n次首1多项式r(x),在A的定性矩阵类Q(A)中至少存在一个实矩阵B,使得B的特征多项式是r(x),文中证明了当n为奇数时n阶谱任意符号模式矩阵是存在的。     

Effects of Spatial Noncommutativity on Energy Spectrum of a Trapped Bose-Einstein Condensate

In noncommutative space, we examine the problem of a noninteracting and harmonically trapped BoseEinstein condensate, and derive a simple analytic expression for the effect of spatial noncommutativity on energy spectrum of the condensate. It indicates that the ground-state energy incorporating the spatial noncommutativity is reduced to a lower level, which depends upon the noncommutativity parameter θ. The gap between the noncommutative space and commutative one for the ground-state level of the condensate should be a signal of spatial noncommutativity.     

磁控溅射技术制备ZnO透光薄膜

采用RF磁控溅射方法,在玻璃衬底上制备了择优取向的ZnO薄膜;通过台阶仪、X射线衍射技术、原子力显微镜和分光光度计分别测量了不同溅射功率条件下淀积的ZnO薄膜厚度(淀积速率)、结晶质量、表面形貌与粗糙度、透光光谱,报道了该薄膜结晶质量、薄膜粗糙度与其在可见光区透光率的关系.     

BRD96N光调制吸收增强现象的实验研究

通过光谱响应特性实验和记录／读出图像实验，研究了基因变异型细菌视紫红质（BR_D96N）分子膜对单色光的光调制特性.发现BR_D96N分子膜在550nm—600nm范围内对调制光有吸收增强的现象，且对此范围内不同波长的单色光其调制程度有差异.利用曲线拟和方法发现550nm—600nm吸收增强的变化过程分为快过程和慢过程，其对应的时间常数分别为30s和5min.利用强度调制器的吸收强度与图像灰度之间的关系，分析了560nm—600nm范围内出现图像反转的实验现象. 关键词： 细菌视紫红质D96N分子膜 光谱响应 吸收增强现象 图像反转现象     

Induced focusing and conversion of a Gaussian beam into an elliptic Gaussian beam

We have presented an investigation of the induced focusing in Kerr media of two laser beams, the pump beam and the probe beam, which could be either Gaussian or elliptic Gaussian or a combination of the two. We have used variational formalism to derive relevant beam-width equations. Among several important findings, the finding that a very week probe beam can be guided and focused when power of both beams are well below their individual threshold for self-focusing, is a noteworthy one. It has been found that induced focusing is not possible for laser beams of any wavelength and beam radius. In case both beams are elliptic Gaussian, we have shown that when power of both beams is above a certain threshold value then the effective radius of both beams collapses and collapse distance depends on power. Moreover, it has been found that induced focusing can be employed to convert a circular Gaussian beam into an elliptic Gaussian beam.     

Champ de vitesse dans un échangeur à vortex en régime turbulentHeat exchanger velocity field with turbulent inlet condition

We consider the isothermal flow through a cylindrical flat chamber, a model of some particular heat exchanger, for which LDV measurements and a numerical simulation have been performed. Experimental results show the establishment of an important vortex zone, the secondary flow extending all along the chamber radius. This observation leads to an expected significant increase of the fluid mixing. Results issued from the numerical simulation appear to be in close agreement with experimental data. Nevertheless, the k–ε model used here must be improved to obtain a better approach near the vortex centre. To cite this article: S. Petitot et al., C. R. Mecanique 330 (2002) 593–599.     

全固态多波长飞秒脉冲激光系统

利用棱镜对引进频谱空间啁啾来补偿飞秒脉冲激光二次谐波产生中的相位失配,提高了倍频效率建立了一套全固态、多波长(1065nm, 532nm,823.1nm, 402nm)飞秒脉冲激光系统自制的Nd:YVO4激光器输出532nm绿光激光,最高平均功率可达5.6W当用2.5W绿光激光泵浦时,从自制的钛宝石激光器及经BBO倍频可分别输出中心波长为823.1nm和402nm,平均功率300mW和73mW,谱宽32.3nm和5.1nm,脉宽22fs和33.3fs、重复率108MHz的近红外和蓝光激光整个系统具有结构紧凑、倍频效率高、运行稳定的特点.     

Study on the possibilities of controlling the laser output beam properties by an intracavity deformable mirror

The possibilities of controlling the laser beam properties by a deformable mirror introduced into the laser optical cavity were studied theoretically and experimentally. The experiments were performed under conditions of an industrial high power transverse flow cw CO₂ laser operating with a stable resonator of a folded configuration. A deformable bimorph mirror of a surface profile controlled by the voltage applied to the mirror electrodes is implemented to the laser system as a back cavity mirror or as a one of the inner folding mirrors. The near-and far-field characteristics of the laser beam versus the resonator configuration controlled by the changes of the focal length of the deformable mirror are discussed in the paper. The analysis reveals that the resonator with an inner deformable mirror is much more sensitive to the mirror curvature variations than the resonator in which the deformable mirror is used as a back cavity mirror. The presented results show that dynamic and controllable changes in the resonator properties result in the controlled modification and optimisation of the laser output power and spatial parameters of the laser radiation.