稀土锗钨钒酸根多元杂多配合物的合成和性质

合成了通式为Ｋ１３Ｈ２「Ｌｎ（ＧｅＷ１０ＶＯ３９）２」．ｎＨ２Ｏ（Ｌｎ＝Ｌａ,Ｃｅ,Ｐｒ,Ｎｄ,Ｓｍ,Ｅｕ,Ｇｄ,Ｔｂ,Ｄｙ,Ｙｂ）的１０种杂多配合物。利用ＩＲ,ＵＶ,ＥＳＲ,ＸＰＳ,Ｘ射线粉末衍射和磁化率对其结构进行了表征：循环伏安和极谱法研究了配合物的氧化还原性质,得出配合物经历了３步还原,第一步为钒的双电子可逆还原,第二步和第三步均为钨的不可逆还原;借助认温ＩＲ、变温ＸＲＤ和ＴＧ－ＤＴＡ研究     

固体杂多酸盐的催化性能Ⅲ．钼磷、钼硅杂多酸碱金属盐的合成、表征和催化酯化反应

合成了Ｈ３ＰＭｏ１２、Ｈ４ＳｉＭｏ１２杂多酸的一系列铯盐：ＣｓｘＨ３－ｘＰＭｏ１２Ｏ４０·ｍＨ２Ｏ（ｘ＝０～３，ｍ＝４～７），ＣｓｘＨ４－ｘＳｉＭｏ１２Ｏ４０·ｍＨ２Ｏ（ｘ＝０～４，ｍ＝４～７）。测定了它们的酸强度、ｐＨ滴定曲线、ＮＨ３－ＴＰＤ、ＩＲ光谱和比表面积。以乙酸和正丁醇的酯化为探针反应，考察了催化剂的酸催化活性。实验结果表明，杂多酸铯盐对乙酸和正丁醇的催化酯化活性只与总酸量有关，与表面积无关，属假液相反应     

负载型杂多酸催化下N2O5对甲苯的选择性硝化

用负载型杂多酸为催化剂,N2O5为硝化剂的新型硝化体系,对甲苯的硝化反应进行研究. 分别考察了杂多酸类型、载体种类、杂多酸负载量及催化剂循环使用次数等因素对硝化反应的影响. 结果证明,负载型杂多酸能显著提高N2O5的硝化能力;催化剂回收后可直接重复使用,甲苯硝化反应得率为34%,对位选择性达到58.9%,表明N2O5是一种具有应用前景的硝化试剂.     

三维有序大孔SiW12/SiO2杂化材料的制备及表征

 用自然沉降法组装成规则排列的聚苯乙烯胶晶,并以此作为模板剂,用Keggin结构的杂多酸SiW12和正硅酸乙酯组成溶胶作为先驱物,成功制备了三维有序大孔(3DOM)SiW12/SiO2杂化材料. XRD和IR等测试结果表明,所得样品中的杂多酸SiW12能够保持其Keggin结构,SEM观察显示,样品具有三维大孔规则排列的结构. 研究发现,溶胶组成对杂化材料的3DOM结构影响很大,纯SiW12难以形成3DOM结构,随着SiO2含量的增加,样品的孔结构三维规整性和强度明显增强,而且引入SiO2可有效提高杂多酸的热稳定性.     

Study of the P2O5?MoO3 system in acrolein oxidation

Catalytic properties of the binary phosphorus-molybdenum system with Mo/P=3–24.5 in acrolein oxidation have been studied. The selectivity to acrylic acid and carbon oxides practically does not depend on the chemical composition of the system, and the maximum activity is observed for Mo/P=12. The catalytic properties of the system are determined by an X-ray amorphous phase, apparently molybdenyl phosphate.     

PMo_(12-x)V_x和PMo_(12-x)W_x杂多酸的XPS研究 Ⅰ.杂多酸中氧的俄歇谱

用XPS对杂多酸PMo_(12-x) V_x和PMo_(12-x) W_x的研究表明:在用V部分取代Mo时,虽然O1s峰没有给出什么有意义的结构信息,但OKL_(23)L_(23)俄歇跃迁动能随X增大而增大;在W部分取代Mo时,OKL_(23)L_(23)俄歇峰的动能随X增大而减少。杂多酸中酸性与OKL_(23)L_(23)数值有一定的关系。从OKL_1L_1与OKL_(23)L_(23)俄歇峰强度之比,求出氧成键时增加电荷,进一步表明了杂多酸中氧原子成键情况。     

The Catalytic Performance of Preyssler's Anion, [NaP5W30O110]14−, in the Oxidation of Benzyl Alcohols

Under mild conditions, monosubstituted benzyl alcohols were oxidized to benzaldehydes and benzoic acids in the presence of sodium 30-tungstopentaphosphate (Preyssler's anion), [NaP₅W₃₀O₁₂₀]^14? , and hydrogen peroxide as an oxidant. This polyanion with high hydrolytic stability (pH = 0–12), high thermal stability, and high acidic strength shows good activities. The effects of various parameters on the yield of the products, including a catalyst type, a nature of the substitutents, and temperature, were studied. Comparison between Keggin's heteropolyacids, H₃[PW₁₂O₄₀], H₃[PMo₁₂O₄₀], H₄[SiW₁₂O₄₀], and H₄[SiMo₁₂O₄₀], and Preyssler's anion shows that this polyanion reacts similar to Keggin's acids whitout any degradation of the structure.     

Highly Efficient and Novel Method for Synthesis of 1,3,5-Triarylbenzenes from Acetophenones

Heteropolyacid–phosphomolybdic acid has been found to be an efficient and recyclable catalyst for cyclotrimerization of acetophenones into 1,3,5-triarylbenzenes in good yields.     

固体酸催化烷基化反应中微量氟化氢反应助剂的作用 Ⅰ.助剂对反应的促进效应

 研究了负载型杂多酸催化剂20%H3PW12O40/SiO2催化的异丁烷与丁烯的烷基化反应. 发现当在反应物料中加入0.0192%(质量分数)含强电负性元素F的反应助剂HF后,在超临界烷基化反应条件下（137 ℃和5.0 MPa）,反应产物烷基化汽油中C8烷烃的含量和目的产物三甲基戊烷的收率均大幅度提高,三甲基戊烷与二甲基己烷的摩尔比值提高了一倍以上. 这是一个重要和有趣的实验现象,它说明微量HF反应助剂可大幅度提高固体酸催化剂对烷基化反应的选择性. 我们把微量反应助剂在固体酸催化烷基化反应中的这种特殊作用称为对烷基化反应的促进效应,这种促进效应已经在我们实验室中被反复证实.     

Supported Poly(Ionic Liquid)-Heteropolyacid Based Materials for Heterogeneous Catalytic Fructose Dehydration in Aqueous Medium

Two sets of four different supported catalyst materials were prepared. One set was obtained by polymerization of a bis-vinylimidazolium salt, which formed a poly(ionic liquid) coating on SiO₂, TiO₂, boron nitride BN, and carbon nitride C₃N₄. The other set was, instead, obtained by immobilizing Keggin heteropolyacid H₃PW₁₂O₄₀ onto poly-imidazolium functionalized materials. All the catalysts, including the bare supports, were subjected to physical and chemical characterization by XRD, SEM, Specific Surface Area and pore size measurements, TGA, FTIR, and acidity-basicity measurements. The catalytic activity of the materials was tested versus the fructose dehydration in water solution at two different sugar initial concentrations (0.3 and 1 M). Tests lasted 3 h with an amount of catalyst of 2 g∙L⁻¹. The presence of the poly-imidazolium on the surface of the supports increased the catalytic conversion of fructose to 5-hydroxymethylfurfural (the most abundant compound obtained) and was further improved by the contemporary presence of the heteropolyacid, at least for the highest initial fructose concentration. In the latter conditions, the highest yield of 5-hydroxymethylfurfural (>40%) was also obtained.