氧化锶催化性质：Ⅱ.SrO,MgO上异丙醇的分解反应

ＳｒＯ，ＭｓＯ对异丙醇的分解反应有各自的作用形式，因而产物分布也有明显差别．ＭｇＯ上异丙醇分解，在较低温度时，主要产物为丙酮和丙烯；随温度升高，生成丙烯的量增加，而丙酮的量减少，直至消失，在ＳｒＯ上，异丙醇在较高温度时反应，产物几乎为丙酮，丙烯的生成量极少。认为：产物中丙烯来源于异丙醇在催化剂表面强酸中心上的脱水；丙酮在ＭｇＯ上来源于强碱中心和酸中心协同作用异丙醇的脱氢，而在ＳｒＯ上则是ＳｒＯ表面极强的碱中心作用异丙醇而脱氢制得。     

Degradation of ²-O-4 lignin model and related compounds by the ascomyceteChrysonilia sitophila (TFB 27441 strain)

Growth of the ascomyceteChrysonilia sitophila during degradation of lignin model dimers and monomers was compared to a glucose control. An inhibition of growth by Cα-carbonyl monomers and stimulation by β-O-4 lignin model and vanillyl alcohol were observed. A comparison of the degradation by this ascomycete with the basidiomycetePhanerochaete chrysosoporium showed similarities in relation to the type of degradation caused.     

Pt/HL和Pt/KL沸石在异丙醇分解反应中的不同催化行为

Ｐｔ／ＫＬ沸石在异丙醇分解反应中具有很高的脱氢活性,而Ｐｔ／ＨＬ沸石具有明显的缺电子性,在此反应中难以显示出脱氢活性,通过加氢作用,可使沸石的酸位免受积炭覆盖,从而可增强Ｐｔ／ＨＬ沸石的酸性催化作用。     

Degradative analysis of aquatic fulvic acid: CuO oxidation versus pyrolysis after tetramethylammonium hydroxide treatments in air and helium atmospheres

The structural composition of Nordic aquatic reference fulvic acid was investigated using chemical and thermal degradation methods: alkaline CuO oxidation and analytical pyrolysis after tetramethylammonium hydroxide (TMAH) pretreatment. Off-line procedures of the TMAH treatments were carried out under both air and helium atmospheres, with the aim of clarifying the effect of oxygen. Irrespective of the fact that the chemical and thermal degradation methods gave qualitatively quite similar basic products (mainly phenols and phenolic acids together with aromatic and aliphatic carboxylic acids), they also revealed their unique selectivity and efficiency for releasing different kinds of structural constituents. The results verify the formation of additional carboxyl functionality in the CuO oxidation. However, some similar oxidative reactions also appeared to take place during the pretreatment procedures of strongly basic TMAH, especially under an air atmosphere. The use of inert and protective atmosphere during the TMAH pretreatment is therefore recommended for producing more relevant structural information about the complex composition of humic substances.     

Solar Photocatalytic Degradation of 4‐Chlorophenol in Kaolinite Catalysts

This research applies semiconductor photocatalysts, which are formed by metal ion exchange on the surface of kaolinite catalyst with cations, to the study of photocatalytic degradation of 4‐chlorophenol. The analysis results of catalyst properties shows that, after sintering at 400 °C, kaolinite catalyst has a particle size of between 10–100 nm indicating the nano level of synthesized catalysts. Under the same condition, kaolinite‐Ag/Zn catalyst works better in degradation efficiency than single kaolinite‐Ag and kaolinite‐Zn catalysts. Kaolinite‐Zn catalyst declines in degradation efficacy after 150 minutes and performs poorer than the other three types of kaolinite catalysts. In the experiments of different amounts of catalysts, when the concentration exceeds 0.1 wt%, utilization of light energy and degradation efficiency will be reduced due to shielding effect. When at different pH values, the higher the pH value, the more OH‐will be released and that is beneficial for reaction with substances and the increase of reaction rate. Finally multivariate analysis proves that there is one determining factor that influences the photocatalytic degradation of 4‐chlorophenol in kaolinite catalysts, named as “the factor with intermediates competition degree,” the one affecting the 4‐CP degradation at different weight percentages that is referred to as the “shielding effect factor.”     

Catalytic degradation of polystyrene using HUSY catalysts

Summary The addition of carbon dioxide to phenyl glycidyl ether (PGE) was investigated in a semi-batch reactor using immobilized quaternary ammonium chloride catalysts. Five different catalysts were prepared with the following supports : (1) soluble poly(ST-<Emphasis Type=Italic>co</Emphasis>-VBC) [C1], (2) insoluble poly(ST-DVB-VBC) [C2], (3) macroporous poly(ST-DVB-VBC) [C3], (4) poly(ST-<Emphasis Type=Italic>co</Emphasis>-VBC)-MMT [C4] (5) modified MCM-41 [C5]. The addition of carbon dioxide to PGE can be considered as a pseudo-first order process with respect to the concentration of PGE. The pseudo-first order rate constant for the catalysts decreased in the series C1&gt;C3&gt;C2&gt;C4&gt;C5. The activation energy for C1 to C5 catalysts was 8.6, 20.9, 19.9, 23.9, and 26.8 kJ/mol, respectively. The immobilized catalysts can be reused in least 4 successive runs without any considerable loss of their initial reactivities.     

探针反应和FTIR法研究Pt与L型沸石的相互作用

探针反应和ＦＴＩＲ法研究Ｐｔ与Ｌ型沸石的相互作用董家禄,朱建华,须沁华,张婕,刘大壮（南京大学化学系,南京,２１０００８）（郑州工学院化工系,郑州,４５０００２）关键词Ｐｔ／Ｌ沸石,沸石催化剂,异丙醇分解反应,Ｐｔ－载体相互作用Ｐｔ的分散度和电子状态...     

液晶光定向层材料

本文综述了近10年来液晶显示用光定向层材料领域的研究现状和进展情况，主要概述了光降解型、光致异构型、光交联型以及自组装等材料，并对目前报道的液晶光定向机理进行了总结和归纳。     

Non isothermal heat capacities and chemical reactions using a modulated DSC

An evaluation of measurements of heat capacities by modulated differential scanning calorimetry, MDSC is presented. Heat capacities were obtained from 130 to 550 K by a non isothermal technique in which a periodic modulation was added to the linear heating rate. Effects of amplitude and period of modulation, sample weight, sample type, pan type, and cell imbalance are described. Results are compared with those obtained using the isothermal technique. Heat capacity could be measured well into the decomposition region and separated from the non reversing signal due to chemical reaction (degradation), thus allowing a precise detection of onsets of the thermal degradation. This additional information will aid in the interpretation of the degradation chemistry, a field vital for the petroleum-industry.Dedicated to Professor Bernhard Wunderlich on the occasion of his 65th birthdayPart of this paper was presented at the 23rd Conference of the North American Thermal Analysis Society, Toronto, Canada, September 25–28, 1994.The author (MVN) acknowledges the experimental assistance provided by J. Balogh of Exxon Research and Engineering Company, Linden. Helpful discussions with A. Boller of the University of Tennessee at Knoxville, Dr. Y. Jin, General Electrical, and Dr. S. Sauerbrunn formerly of TA Instruments are also acknowledged.     

Initiation of polymer degradation via transfer of infectious species

A novel dual stage chemiluminescence detection system incorporating individually controlled hot stages has been developed and applied to probe for material interaction effects during polymer degradation. Utilization of this system has resulted in experimental confirmation for the first time that in an oxidizing environment a degrading polymer A (in this case polypropylene, PP) is capable of infecting a different polymer B (in this case polybutadiene, HTPB) over a relatively large distance. In the presence of the infectious degrading polymer A, the thermal degradation of polymer B is observed over a significantly shorter time period. Consistent with infectious volatiles from material A initiating the degradation process in material B it was demonstrated that traces (micrograms) of a thermally sensitive peroxide in the vicinity of PP could induce degradation remotely. This observation documents cross-infectious phenomena between different polymers and has major consequences for polymer interactions, understanding fundamental degradation processes and long-term aging effects under combined material exposures.