Nanocrystalline ceramic films for efficient conversion of light into electricity

Transparent nanocrystalline films of oxide semiconductors such as TiO₂ and Fe₂O₃ have been prepared on a conducting glass support employing a sol-gel procedure. The films are composed of nanometer-sized particles sintered together to allow for percolative charge carrier transport. The internal surface of these films is very high, roughness factors of the order of 1000 being readily obtained. Electric polarization was applied for forward and reverse biasing of the films and the resulting optical changes have been analyzed to derive their flat band potential. Band gap excitation of such nanocrystalline semiconductors produces electron-hole pairs which migrate through the film to be collected as electric current. Steady state photolysis and time resolved laser techniques have been applied to scrutinize the mechanism of light induced charge separation within the nanostructure. When derivatized with a suitable chromophore, TiO₂ films give extraordinary efficiencies for the conversion of incident photons into electric current, exceeding 90% for certain transition metal complexes within the wavelength range of their absorption band. The underlying physical principles of these astonishing findings will be discussed. Exploiting this discovery, we have developed a new type of photovoltaic device whose overall light to electric energy conversion yield is 10% under simulated AM 1.5 solar radiation.     

微分脉冲溶出伏安法同时测定食品中的锌铁锰

在1％乙二胺-0．1mol／L酒石酸钠-pH11．82 Britton—Robinson缓冲溶液体系中用微分脉冲溶出伏安法同时测定锌、铁、锰三种微量元素。它们的峰电位分别为-1184，-1392和-1456mV(vs．Ag/AgCl)；线性范围分别为：0.001—0.015，0．005—0．05和0．04—0．7μg／mL，最低检出浓度分别为0．0007，0．0014和0．0193μg／mL。本法操作简便、准确、灵敏度较高，用于食品中这三种元素的分析，结果令人满意。     

Magnetic properties of lanthanum orthoferrite fine powders prepared by different chemical routes

Fine powders of lanthanum iron oxide, LaFeO₃, have been prepared by solid state reaction as well as sol-gel synthesis and nebulized spray pyrolysis. Structures, morphologies and magnetic susceptibility measurements of these powders have been examined. The powders prepared by all the three low-temperature routes contain nearly spherical particles with an average diameter of 40 nm. These samples show a lower Neel temperature than the powder prepared by solid state reaction besides showing much lower magnetic susceptibility at low temperatures. Dedicated to Professor C N R Rao on his 70th birthday     

水浸对含钕熔铁氨合成催化剂的影响

已有熔铁氨合成催化剂中添加稀土的报道.我们通过添加稀土得到了几种活性较高的催化剂,经进一步改进制备工艺(水浸处理后),活性又有所提高.本文利用XRD和AES等,对经水浸前后的含稀土催化剂的结构进行了测试,探讨了水浸后活性提高的原因.     

A Novel Green Preparation of a, a''''-Bis (substituted benzylidene)-cycloalkanones Promoted by FeCl_3 6H-2O in Ionic Liquid

a, a'-Bis(substituted benzylidene)cycloalkanones were efficiently prepared from cycloalkanones and benzaldehydes in [bmim][BF4] by using iron(III) chloride hexahydrate as a catalyst. It is shown that [bmim][BF4] and iron(III) chloride hexahydrate can be quantitatively recovered and be reused effectively for many times. Compared with the known methods, this novel process has the advantage of being an envkonmentally benign process together with good yields and mild reaction conditions.     

铁基超细粒子催化剂结构与还原行为的Mssbauer谱研究

铁基超细粒子催化剂具有优良的F-T反应性能。本工作利用原位Mssbauer谱辅以XRD技术研究了含有钾助剂的F-T合成铁基超细粒子催化剂的结构与还原行为,考察了催化剂组成和第二金属组分(Mn,Zn,Mg)的影响。“纯”铁超细粒子催化剂在氢气中很容易经Fe_3O_4还原为零价铁。第二金属组分的引入,一方面阻碍了催化剂的还原,另一方面稳定了Fe~(2+)的存在而使其成为还原的主要中间相,这有利于反应条件下形成类尖晶石结构的活性相。对于Fe-Mn催化剂,上述效应随锰含量的增加而更趋显著。铁基超细粒子催化剂在氢气中的还原能力依“纯”Fe>Fe-Zn>Fe-Mn>Fe-Mg的顺序递减,这在一定程度上反映了铁与第二金属组分之间相互作用的强弱。     

三氯化钛存在下碘酸钾滴定法测定锡

提出了采用铝加铁混合还原剂还原,三氯化钛存在下碘酸钾滴定法测定锡的绝对测量方法,研究了三氯化钛抑制氧的作用效果及作用机理。应用于巴氏合金中锡含量的测定,方法简便、快速,结果准确可靠。     

镀铜铁屑-H_2O_2催化氧化降解含酚废水

采用镀铜铁屑代替传统Fenton体系中的FeSO4作为催化剂,通过改变H2O2与镀铜铁屑的投加量、溶液的pH值、反应温度、反应时间等条件,研究了该体系对处理苯酚废水的影响。结果表明,常温下处理实际含酚印染废水,在pH值为4~6,30%H2O2 12mL/L,镀铜铁屑5g/L,反应时间为45min时,COD去除率可达96%,其CODCr从5827mg/L降至419mg/L,色度从2000降至30,符合国家三级排放标准。     

Thermal and structure analysis of FeSO4·H2O-BaO2 mixtures

Investigations on the thermal decomposition of FeSO₄·H₂O-BaO₂ mixtures were carried out under isothermal conditions by using simultaneously solid electrolyte cell (EMF-method). Evoked interactions producing oxygen in the temperature range 553-673 K were established by means of a solid electrolyte oxygen analyzer. Based on Mössbauer spectroscopy data and X-ray analysis it was proved that these reactions were associated with the release of oxygen from barium peroxide, oxidation of ferrosulphate-monohydrate to FeOHSO₄, and formation of barium ferrites such as BaFe₂O₄ and BaFe₁₂O₁₉.