新型重整催化剂的研究—Pt／BaKL型沸石中钡的作用

本文采用XRD,NH_3-TPD,IR以及TEM等方法考察了Pt/BaKL沸石中Ba~(2+)的作用。NH_3-TPD结果表明,交换Ba~(2+)后的L型沸石的酸性,由于阳离子的作用仅在弱酸范围内有些改变,但与载铂的沸石的催化活性无明显的对应关系。IR及XRD谱线表明,BaKL沸石中Ba~(2+)在最佳交换度(26.3%)时,随预培烧温度的提高,使Ba~(2+)处于沸石孔道中B、C、D位置,接近于最佳分布,此时IR谱线上1421cm~(-1)处有一新峰。当沸石负载铂后,因铂与Ba~(2+)的相互作用,新峰消失,导致铂粒在沸石上分布更加均匀;铂粒在1.5—3.0nm之间占有最大比例,使得Pt/BaKL沸石呈现芳构化活性及选择性高于Pt/KL沸石,分别为～98%和～95%。     

用θ-2θ型衍射仪测定溶液结构的新方法

叙述了用θ－２θ型Ｘ射线衍射仪精确测定电解质溶液结构的新实验技术。设计制作了具有恒温功能的超厚液体样品池，并建立了样品池窗口强度的校正方法。优化了液体Ｘ射线衍射数据和结构参数精细化的计算机程序，获得了非常令人满意的实验结果。由θ－２θ型Ｘ射线衍射仪精确测定的径向分布函数与θ－θ型衍射仪自由散射比较，表明ＤＲＦ分辨率有所提高。     

Chloride distribution coefficient on strongly basic anion-exchange resin: Dependence on co-ion in alkali fluoride solutions

Summary The dependence of the chloride distribution coefficient on the co-ion of solutions of different alkali fluorides, MF, up to 11M is tested on the strongly basic anion-exchange resin AG1-X10. Under the same experimental conditions the distribution coefficient decreases in the following order for M⁺: Na⁺>K⁺>Rb⁺>Cs⁺. This can be explained by the different co-ion-chloride interactions. The consequence of this interaction for a chromatographic separation of chloride is shown with 5M KF and CsF solutions, used as eluants. Depending on the fluoride concentration, the distribution coefficient passes through a minimum value to increase again at higher electrolyte concentration. The non-exchange electrolyte in the resin phase is responsible for this effect. In addition, the bromide and the iodide distribution coefficients up to 10M KF solutions are determined. One results is that the selectivity coefficient between halide ions increases at higher electrolyte concentrations.     

The Mathematical Theory of Ito Diffusions on Hypersurfaces, with Applications to NMR Relaxation Problems

A mathematical framework for translational Brownian motion on hypersurfaces is presented, using an imbedding of the surface and Ito diffusions in the ambient space. This includes a survey of Ito calculus and differential geometry. Computational methods for time correlation functions relevant to spin relaxation studies on curved interfaces are given, and explicit calculations of time correlation functions and order parameters for a Rippled surface are presented.     

Multidimensional separation of isomeric species of chlorinated hydrocarbons such as PCB,PCDD, and PCDF

A multidimensional GC-system containing two capillary columns of different polarities, operated within a double oven instrument, was used for the optimized separation of complex isomeric mixtures of various types of chlorinated aromatic compounds such as PCB, PCDD, or PCDF. Electron capture was applied parallel to flame ionization detection to obtain sensitive signals of the PCB or PCDD and the n-alkane standards required for identification by Kovats indices, respectively. Electron capture detection within a valvelessly operated MDGC system forced changes in the usual instrumental set-up, the live-switching coupling piece being located within the second oven of the double oven instrument. This oven is operated isothermally to ensure optimal and interference-free detection, for stable flow conditions within the coupling piece and for the determination of the isothermal retention indices (Kovats), which are much more suitable for identification by retention than the so-called “linear” indices.     

Molecular modeling of cytochrome P450 3A4

The three-dimensional structure of human cytochrome P450 3A4 was modeled based on crystallographic coordinates of four bacterial P450s: P450 BM-3, P450cam, P450terp, and P450eryF. The P450 3A4 sequence was aligned to those of the known proteins using a structure-based alignment of P450 BM-3, P450cam, P450terp, and P450eryF. The coordinates of the model were then calculated using a consensus strategy, and the final structure was optimized in the presence of water. The P450 3A4 model resembles P450 BM-3 the most, but the B helix is similar to that of P450eryF, which leads to an enlarged active site when compared with P450 BM-3, P450cam, and P450terp. The 3A4 residues equivalent to known substrate contact residues of the bacterial proteins and key residues of rat P450 2B1 are located in the active site or the substrate access channel. Docking of progesterone into the P450 3A4 model demonstrated that the substrate bound in a 6-orientation can interact with a number of active site residues, such as 114, 119, 301, 304, 305, 309, 370, 373, and 479, through hydrophobic interactions. The active site of the enzyme can also accommodate erythromycin, which, in addition to the residues listed for progesterone, also contacts residues 101, 104, 105, 214, 215, 217, 218, 374, and 478. The majority of 3A4 residues which interact with progesterone and/or erythromycin possess their equivalents in key residues of P450 2B enzymes, except for residues 297, 480 and 482, which do not contact either substrate in P450 3A4. The results from docking of progesterone and erythromycin into the enzyme model make it possible to pinpoint residues which may be important for 3A4 function and to target them for site-directed mutagenesis.     

In-gel deglycosylation of sodiumdodecyl sulfate polyacrylamide gel electrophoresis-separated glycoproteins for carbohydrate estimation by matrix-assisted laser desorption/ionization time-of-flight mass spectrometry

Mass determination by mass spectrometric methods (electrospray ionization mass spectrometry (ESI-MS), matrix-assisted laser desorption/ionization time-of-flight mass spectrometry (MALDI-TOFMS)) of sodiumdodecyl sulfate polyacrylamide gel electrophoresis (SDS-PAGE)-separated proteins is a well known procedure and reliable protocols are available. In our efforts to use the established methods to determine the molecular mass of the disulfide bridged, heterodimeric glycoprotein GP3 and to determine the carbohydrate content of each protein subunit we developed an in-gel chemical deglycosylation method. For this purpose we established experimental conditions that allow maximum extraction of the high molecular mass protein subunits and developed a routine method to apply the HF-pyridine deglycosylation protocol to proteins isolated from polyacrylamide gel pieces. The novel protocol and extraction procedure described can be used to analyze O-glycosylated proteins up to 150 kDa after SDS-PAGE separation.     

The electronic structure of molecules by a many-body approach

The vertical valence ionization potentials of cyclopropane, ethylene oxide and ethylene imine are calculated by a many-body Green's function method. For C₃H₆ the ordering of the ionization potentials is 2e(), 1e(), 2a₁(), 1a₂(), 1e(). The assignment of the 2a₁ and the 1a₂ ionization potentials which has been controversial is thus clarified. The ordering is in agreement with the result obtained via Koopmans' theorem. For ethylene oxide and ethylene imine Koopmans' theorem fails in predicting the correct order of ionic states. For C₂H₄O the ordering of the ionization potentials is 2b ₁(), 4a ₁, 1a ₂(), 2b ₂,3a ₁, 1b ₁(), 1b ₂, 2a ₁ and for C₂H₅N 6a, 5a, 3a, 2a, 4a, 3a, 1a, 2a. The agreement of the computed ionization potentials with the experimental values is very satisfactory.     

Cathodoluminescence Depth Profiling in SiO2:Ge Layers

 For investigation of the luminescent center profile cathodoluminescence measurements are used under variation of the primary electron energy E ₀ = 2…30 keV. Applying a constant incident power regime (E ₀·I ₀ = const), the depth profiles of luminescent centers are deduced from the range of the electron energy transfer profiles dE/dx. Thermally grown SiO₂ layers of thickness d = 500 nm have been implanted by Ge⁺-ions of energy 350 keV and doses (0.5–5)10¹⁶ ions/cm². Thus Ge profiles with a concentration maximum of (0.4 – 4) at% at the depth of d_m≅240 nm are expected. Afterwards the layers have been partially annealed up to T _a = 1100 °C for one hour in dry nitrogen. After thermal annealing, not only the typical violet luminescence (λ = 400 nm) of the Ge centers is strongly increased but also the luminescent center profiles are shifted from about 250 nm to 170 nm depth towards the surface. This process should be described by Ge diffusion processes, precipitation and finally Ge nanocluster formation. Additionally, a Ge surface layer is piled-up extending to a depth of roughly 25 nm.