Determination of pesticides and some metabolites in different kinds of milk by solid-phase microextraction and low-pressure gas chromatography-tandem mass spectrometry

A new analytical method is proposed to determine more than 40 multiclass pesticides in different kinds of processed (whole, skimmed and powdered) and unprocessed (goat and human) milk samples using solid-phase microextraction (SPME). A comparative study between headspace (HS) and direct immersion (DI) was carried out. The effect of milk dilution and the use of acid to reduce the influence of the matrix in DI-SPME mode were also evaluated. DI of the SPME fiber into previously diluted and acidified milk samples achieved the best sensitivity results. Pesticides were determined using low-pressure gas chromatography-tandem mass spectrometry (LP-GC-MS/MS). Both of the selected techniques have been shown to be effective at reduce fat interference and can determine analytes present at very low concentrations (limits of quantification between 0.02 and 1.00 g L^–1). Performance characteristics such as linearity, recovery, precision, and lower limits, together with an estimation of the measurement uncertainty using validation data, are presented for each pesticide. All of the pesticides presented recovery rates of between 81 and 110% and precision values lower than 12% (expressed as the relative standard deviation). The overall uncertainty of the method was estimated at three different concentrations (10, 25 and 50 g L^–1) and was lower than 25.5% in all cases. The proposed analytical methodology was applied to the analysis of target pesticides in 35 samples: 15 commercial, 3 human and 17 goat milk samples. The metabolite p,p-DDE was the compound most frequently found in both the breast and goat milk samples, at concentration levels <20 g L^–1. However, pesticide residues were not found in any of the other 15 commercial milk samples (skimmed, powdered and whole milk) analyzed.     

邻苯二酚的高效液相色谱分析

本文提出了邻苯二酚成品质量的高效液相色谱分析方法。     

高效阳离子交换法分离纯化蛋清中的溶菌酶

 建立了用高效阳离子交换分离纯化蛋清中溶菌酶的新方法 ,讨论了纯化的工艺条件。蛋清样品匀浆后 ,用氯化钠初步纯化 ,然后用弱阳离子交换柱XIDACE WCX分离。结果表明 ,被纯化的溶菌酶和杂蛋白得到很好分离。经活性检测 ,溶菌酶过柱后的活性回收率为 10 7% ,蛋白的比活为 15 4 6 7U/mg ,纯化倍数提高了 5 6倍。用尺寸排阻 (SEC)鉴定 ,得到的溶菌酶呈均一性。该法较传统软基质低压离子交换分离速度快 ,纯化效率高。     

Chiral resolution of diphenylalanine by high-performance liquid chromatography on a crown-ether-based chiral stationary phase and by NMR spectroscopy

Summary The enantiomers of diphenylalanine (DPA) were well separated by chiral HPLC and NMR spectroscopy on the chiral stationary phase (CSP) derived from (18-crown-6)-2,3,11,12-tetracarboxylic acid (18-C-6-TA). The chromatographic parameters such as separation factors and retention times were greatly influenced by the mobile phase conditions. The (+)-18-C-6-TA used in the CSP was also employed as a chiral solvating agent for the enantiodiscrimination of the DPA enantiomers by NMR spectroscopy. The proton of the DPA analyte showing the chemical shift nonequivalences was used in determining the enantiomeric composition of the analyte.     

Effects of ion-pairing reagents on the electrospray signal suppression of sulphonated dyes and intermediates

High-performance liquid chromatography/mass spectrometry (HPLC/MS) analysis of anionic species such as sulphonic acid dyes and intermediates requires volatile ion-pairing mobile phase additives. Six di- and trialkylammonium acetates were compared with tetraalkylammonium salts and ammonium acetate in the concentration range 0-20 mmol l(-1) as mobile phase additives for HPLC/MS of polysulphonated compounds. The effects of the structure and concentration of the ion-pairing reagents on the electrospray response of mono-, di- and tetrasulphonic aromatic acids and acid dyes were studied in detail. Further, five different mass analysers and instrument geometries were compared. A higher signal decrease is observed with linear geometry instruments in comparison to orthogonal or even Z-spray geometry mass spectrometers. The concentration of mobile phase additives has a significant influence on the abundance ratios of multiply charged ions in the mass spectra of polysulphonated compounds. The competing ions of sulphonic acids may also cause significant signal suppression.     

A convenient synthesis of enantiopure (4aS,7aR)-1,4,4a,7a-tetrahydrocyclopenta[c]pyran-3,7-dione

1. Download : Download high-res image (69KB)
2. Download : Download full-size image

     

Degradation-fragmentation of marine plastic waste and their environmental implications: A critical review

This review critically evaluates the plastic accumulation challenges and their environmental (primarily) and human (secondarily) impacts. It also emphasizes on their degradation and fragmentation phenomena under marine conditions. In addition, it takes into account the leachability of the various chemical substances (additives) embedded in plastic products to improve their polymeric properties and extend their life. Regardless of their effectiveness in enhancing the polymeric function of plastic products, these additives can potentially contaminate air, soil, food, and water. Several findings have shown that, regardless of their types and sizes, plastics can be degraded and/or fragmented under marine conditions. Therefore, the estimation of fragmentation and degradation rates via a reliable developed model is required to better understand the marine environmental status. The main parameter, which is responsible for initiating the fragmentation of plastics, is sunlight/UV radiation. Yet, UV- radiation alone is not enough to fragment some plastic polymer types under marine conditions, additional factors are needed such as mechanical abrasion. It should be also mentioned that most current studies on plastic degradation and fragmentation centered on the primary stages of degradation. Thus, further studies are needed to better understand these phenomena and to identify their fate and environmental effects.     

Practical limitations of capillary gas chromatography

Glass capillary gas chromatography is a high resolution separation method which allows the qualitative and quantitative analysis of even complex mixtures, which may contain many components–also isomeric–in a wide range of volatilities, polarities and concentrations. The principal limitation of gas chromatographic application is given by an insufficient volatility of the species to be separated. Elevated temperatures have to be applied if the application range is to be extended and to achieve steep peak profiles, i.e. low detection limits at high resolution. The use of elevated temperatures is limited, of course, by the temperature stability of both the solvent (stationary liquid and support) and the solutes. The problems of trace analysis for low volatility compounds at high resolution and its limitational parameters regarding sampling, separation and detection are discussed. The applicability of glass capillary columns in this field is influenced by the following parameters: tailing behaviour; irreversible adsorption of polar and decomposition of unstable solutes; thermal stability of stationary liquid (including the support deactivation); separation efficiency and sample capacity (film thickness). Multidimensional gas chromatography using capillary columns coupled either with a packed or another capilllary column for preseparations may be applied with advantage in the analysis of complex mixtures.     

Investigation on the thermal degradation of acrylic polymers with fluorinated side-chains

The thermal degradation of poly-2,2′,3,3′,4,4′,5,5′,6,6′,7,7′,7″-tridecafluoroheptylacrylate and poly-2,2′,3,3′,4,4′,5,5′,6,6′,7,7′-dodecafluoroheptylmethacrylate has been studied in isothermal conditions at 450-750 °C using pyrolysis-gas chromatography. The type and composition of the pyrolysis products give useful information about mechanism of thermal degradation. It was shown that the main thermal degradation process for both polymers is random main-chain scission. The major degradation products for fluorinated polyacrylate are monomer, dimer, saturated diester, trimer, and corresponding methacrylate. The fluorinated polymethacrylate gives monomer as the main product of thermal destruction. As a result of side-chain reaction, the thermal degradation of the fluorinated polyacrylate also produces remarkable amounts of alcohol. On the other hand, the respective alcohol is only a minor component among the pyrolysis products of the fluorinated polymethacrylate. For both polymers, the main nontrivial degradation product coming from the alkyl ester decomposition is the corresponding fluorinated cyclohexane. The formation of the fluorinated cyclohexanes may be accounted for a nucleophilic bimolecular substitution pathway.