ZnO超细纳米线阵列的制备及其电化学性能

以Zn(NO₃)₂· 6H₂O和C₆H₁₂N₄为原材料,采用二步水热法在碳纤维布上合成了形貌尺寸均匀的ZnO超细纳米线阵列。用 X 射线衍射(XRD)和扫描电镜(SEM)对其晶体结构和形貌进行了表征,利用恒流充放电测试等手段对其进行电化学性能测试。测试结果表明,材料表现出优异的电化学性能。在200 mA/g的电流密度下循环150次后,ZnO超细纳米线阵列仍然约有730 mAh/g的充放电比容量,库伦效率保持在95%以上。在1 200 mA/g的大倍率条件下,材料的充放电比容量依旧可达481 mAh/g左右,表现出十分良好的循环稳定性和可逆性能,是一种较为理想的锂离子电池负极复合材料。     

手性大孔磷酸镓Hit-5的水热合成与晶体结构

本文采用水热合成法制备了一个三维手性大孔开放骨架磷酸镓Ga16P16O75·4[1,6-C6H18N2]·[C2H10N2]·2H2O(简称Hit-5).反应起始原料摩尔配比为:1 GaOOH:15 H3PO4:7.5 H2N(CH2)6NH2:0.5 C2H8N2:555 H2O.Hit-5属正交晶系,P21212空间群,晶胞参数:a=0.8671(1)nm,b=1.7945(1)nm,c=0.9101(1)nm,β=108.33(1)°,V=1.3443(2)nm3,Z=4.Hit-5的骨架是由Ga3P3六聚体和Ga4P4八聚体两个不同的二级结构单元通过共顶点联接构成三维纳米孔结构,在[001]方向呈现16-元环孔道.     

BaY2F8晶体生长基元与结晶机理的探讨

本文通过对BaY2F8晶体结构的分析,从晶体的生长基元为负离子配位多面体理论出发,对自然冷却条件下BaY2F8晶体自发结晶习性进行了研究,提出了以Ba2+为中心的近八配位十二面体和以Y3+为中心的近八配位十二面体是晶体生长的基元.并根据自发结晶的BaY2F8的XRD,说明了BaY2F8晶体的{200}、{130}、{021}、{330}、{-111}、{111}、{221}、{002}等面族比较发育的原因.本文证实了仲维卓的负离子配位多面体理论对BaY2F8晶体生长的适用性,并对探索新的BaY2F8单晶生长方法有参考作用.     

聚合物受限结晶的研究进展

随着纳米材料研究的迅速发展,聚合物由于其分子固有的纳米尺度结构,无论作为纳米器件或在模板应用方面都受到广泛瞩目.在微纳领域的应用中,特定受限环境下,结晶聚合物的结晶行为也因此受到广泛关注.本文从均聚物(及无规共聚物)和半晶型嵌段聚合物两方面总结了近年来聚合物受限结晶领域的研究进展.对于均聚物和无规共聚物,人们主要关注其在薄膜、超薄膜条件下的受限结晶性能,关注点为随着膜厚减小而引入的空间效应和界面效应对聚合物结晶性能的影响.而对于半晶型嵌段共聚物受限结晶的研究则多从本体出发,来研究纳米相分离与结晶的竞争过程、纳米相分离区域对于可结晶嵌段结晶生长的几何限制(空间效应)以及嵌段连接点(结晶嵌段的末端)对于结晶嵌段结晶行为的影响.     

四川某金矿中非金属单矿物的元素分析及意义

利用中子活化分析法对四川某地区的非金属单矿物(热液脉矿物)的元素进行了测试,并利用元素地球化学研究方法对元素间的相关关系进行了分析。结果表明,在该地区可以利用元素间的伴生关系指导找矿。     

矿化剂浓度和温度对水热法合成氧化锌晶体形态的影响

采用水热法，通过改变矿化剂浓度和温度合成了具有不同形态的氧化锌晶体。在较低的温度(350℃)，填充度为35％。矿化剂KOH浓度小于2mol／L时，只合成了氧化锌微晶。当矿化剂KOH浓度大于3mol/L时，合成出多种形态氧化锌晶体，大的晶体达到几十到几百微米，小晶体仅几微米。当矿化剂KOH浓度从4mol／L增加到5mol／L时，晶体的大小没有明显改变。在高矿化剂条件下合成的晶体显露完整的晶面结构，主要显露柱面m{1010}、锥面p{1011}、负极面O面{0001}，有时也显露Zn面{0001}。晶体表面出现斑坑，显示出晶体的表面缺陷。在430℃，填充度为35％，矿化剂KOH浓度大于1．5moL／L时。合成了多种形态氧化锌晶体，大晶体有几十到几百微米，小晶体仅几微米。当矿化剂KOH浓度为2mol／L，KBr浓度为lmol/L时，最大晶体的长度达到1mm。矿化剂KOH浓度为4mol/L时，晶体没有增大。粒度较大的氧化锌晶体形状多为六棱锥体，显露柱面m{1010}、锥面p{1011}、负极面O面{0001}。晶体表面光滑，完整性好。质量高于350℃时合成的晶体。     

非晶钛酸铋的晶化过程

利用差热分析、X射线衍射和透射电子显微镜等技术对溶胶-凝胶法合成的凝胶的晶化过程进行了分析，实验结果表明，Bi₄Ti₃O₁₂非晶凝胶晶化过程经历了四个过程：首先在433℃先形成了Bi₂O₃和TiO₂亚稳相，然后在488℃时TiO₂亚稳相与Bi₂O₃反应形成Bi，Ti复合氧化物亚稳相Bi₂T 关键词： 钛酸铋 铁电材料 溶胶凝胶 非晶 晶化过程     

A Simple Hydrothermal Method for the Growth of ZnO Crystals

ZnO microstructures have been grown from zinc chloride (ZnCl₂) and ammonia solution at 100 °C for 1 – 24 hours. X‐ray diffraction, scanning electron microscope and field‐emission scanning microscope were utilized to investigate the structural properties and morphology of the ZnO crystals. Structural investigations show that phase‐pure hexagonal structure ZnO has been successfully synthesized, and the hexagonal structure ZnO can be achieved in solutions with an appropriate range of concentrations. Under our experimental conditions, several different morphologies of ZnO structures were obtained, including flower‐like and bar flower‐like. The relationship between the morphology and experimental conditions are discussed.     

Stroboscopic microscopy—direct imaging of structure development and phase separation during spin‐coating

Spin‐coated polymer blends possess a rich variety of accessible non‐equilibrium morphologies, formed through a process of phase separation and self‐assembly, the complexities of which remain incompletely understood. The technique of stroboscopic microscopy has now been developed to allow direct observations of microscopic and mesoscopic morphological development during spin‐coating and has afforded unequivocal information regarding morphological development. The technique so far has three modes of operation providing information on topographical, compositional, and crystal development. In this review, we look at the technique's development, its applications and comment on the future potential for this technique. © 2013 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2014 , 52, 17–25     

One dimensional main-chain crystallization kinetics of poly(3-octylthiophenes) investigated by infrared spectroscopy

Time-resolved infrared spectroscopy has been used to study the melt crystallization behavior of poly(3-octylthiophenes) (P3OT), which is a typical conductive polymer among the family of poly(3-alkylthiophenes) (P3ATs). It is found that, during the isothermal crystallization process at high temperature, the alkyl side chains of P3OT always keep in disordered state, whereas the ordering packing of conjugated backbone takes place. In order to reveal the structural changes and the crystallization kinetics corresponding to the main-chain ordering process, two spectral regions that associated with π–π stacking and the effective conjugation length of P3OT have been analyzed in detail. The characteristic IR bands of crystalline and amorphous phase are identified in each spectral region. Moreover, a simple spectral method has been proposed to calculate the evolution of crystallinity during the isothermal crystallization process of P3OT. Of particular note, the distinct one-dimensional growth kinetic of P3OT crystal has been revealed by Avrami analysis.