Influence of concentration on the activation energy for diffusion in polymer-solvent systems

The self-diffusion of benzene, toluene, and ethylbenzene in polystyrene have been analyzed using the Vrentas/Duda free-volume diffusion model. Diffusion coefficient predictions suggest an exponential concentration dependence of the activation energy required to overcome attractive forces, E. Without the use of any diffusion data approximating E as zero over the entire concentration range yields self-diffusion coefficient predictions which are in good agreement with experimental data. © 1992 John Wiley & Sons, Inc.     

19F+27Al深部非弹性碰撞产物的角分布

完成了19F+27Al深部非弹性碰撞产物的角分布测量.初步分析了反应产B,C,N,O,F,Ne,Na,Mg和Al的实验室系角分布,展现出深部非弹性反应机制的特点,显示了反应系统随时间的演化过程. Angular distributions of fragments produced in the deep inelastic collision of~(19)F+~(27)Al have been measured for incident energy of 114 MeV at θ_(lab)= 9~(o), 24~(o), 40~(o), 55~(o), 70~(o) and 85~(o). Angular distributions of dissipative products B, C, N, O, F, Ne, Na, Mg and Al are analyzed to provide an evolution process of the intermediate dinuclear system formed in the reaction.     

Reagent concentration effects in the REM resin solid phase synthesis of tertiary amines

The use of reagent concentration has resulted in increased rates for all stages of the REM resin synthesis of tertiary amines. These increases in rate translate into faster reaction times, higher yields and lower reagent consumption. Of the methods examined, the most successful was the use of perfluorous solvents, either alone or with a small amount of organic co-solvent.     

Depth profiling of latex blends of fluorinated and fluorine‐free acrylates with laser‐induced secondary mass spectrometry

We explored phase separation and self‐assembly of perfluoroalkyl segments at the surface of polymer films obtained from latices of semifluorinated acrylate copolymers and the corresponding latex blends of nonfluorinated and semifluorinated polyacrylates. With laser‐induced secondary mass spectrometry the fluorine distribution was measured after annealing above the minimum film‐forming temperature of the polymers up to a depth of several micrometers. Depth profiles of a semifluorinated acrylate homopolymer and latex blends thereof with fluorine‐free alkylacrylates with 25, 50, and 75 mol % semifluorinated acrylate as well as a copolymer comprised of alkyl acrylate and semifluorinated acrylate (50/50 mol %) were investigated. In the case of latex blends containing both semifluorinated polyacrylates and fluorine‐free or low‐fluorine polymers, self‐assembly accounted for enrichment of the perfluoroalkyl segments at the surface. Coatings exhibiting low surface energy and having a substantially reduced total fluorine content were obtained. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 360–367, 2003     

Effect of pressure on the solubilities ofo-,m- andp-xylene in water

The solubilities of o-, m- and p-xylene in water were measured at 25.0°C up to 250, 385, and 50 MPa, respectively. The solubility increased with increasing pressure up to 120 MPa (50 MPa for p-xylene) and then decreased. The reaction volumes, V^o accompanying the dissolution at 0.1 MPa were estimated as –3.6±0.5, –3.4±0.5, and –4.1±0.5 cm³-mol^–1 for o-, m-, and p-xylene, respectively, from the pressure dependences of the solubilities. The limiting partial molar volumes, of p- and o-xylene in water under high pressure were estimated from V^o and the molar volume of the xylene. The partial molar volumes decreased with increasing pressure. The reaction volume for the formation of intra-molecular pairwise hydrophobic interaction between the methyl groups, as proposed by Ben-Naim, is discussed for the V^o of p- and o-xylene at 0.1 MPa.     

有机溶剂化效应对多元配合物显色反应作用的研究 Ⅰ.有机溶剂对 M-CAS-CTMAB 体系显色反应微环境影响之初探

本文研究了有机溶剂加入后,表面活性剂增敏型体系微环境的变化。用核磁共振方法确定了有机溶剂分子与CTMAB胶束分子的作用部位。通过CTMAB溶液电导率测定及c.m.c值的测定,发现有机溶剂加入确实形成了一种新胶束。还研究了有机溶剂对显色反应速度的影响。并考察了体系微环境变化与相应显色液吸光度值的关系。我们的实验初步表明,有机溶剂的存在,改变了原有的CTMAB胶束,是增敏作用的重要因素,因而改变了发生显色反应的微环境。     

高强度高电导率聚乙炔的合成——醚类溶剂的结构对性能的影响

通过选用不同醚类结构做溶剂加热回流Ti(OBu)_4-AIEt_3催化剂,并采用非溶剂聚合方法进行乙炔聚合发现,所得HPPA膜的强度和电导率都有了较大提高。其中直链醚制得的PA膜强度(抗张强度大于100MPa)和空气稳定性比用环醚得到的PA膜高得多,但用前者时的乙炔聚合速率远低于后者。两体系得到的HPPA膜的碘掺杂电导率值相近(～10~3S/cm),拉伸后可达10~4S/cm量级。SEM、TEM及IR光谱的结果表明,不同醚制得的PA膜的纤维束直径及顺式含量有较大差别。     

减压渣油供氢剂减黏裂化研究

减黏裂化作为一种不生成焦炭的热加工方法主要涉及两类化学反应，裂解反应和缩合反应。裂解反应使减压渣油的平均分子量及其胶团直径变小，改善渣油的倾点和黏度；缩合反应使减压渣油及其中间产物中的芳烃、烯烃等缩合成大分子量产物，产生新的胶核，甚至生成焦炭。常规减黏裂化过程中，这两类化学反应主要与反应温度和反应时间有关。在热作用下渣油中的大分子裂解为H／C原子比相对较高的饱和烃自由基和H／C原子比相对较低的芳香性自由基。后者还可失去自身的环烷氢而使其H／C原子比进一步降低。如果体系中有足量的氢化芳烃存在，那么氢化芳烃分子上的活泼氢就可能转移到芳香性自由基的单电子位，将自由基封闭，从而阻止芳香性自由基之间的相互缩合，抑制使分子长大的缩合反应。如果体系中的氢化芳烃含量不足。则热反应体系中就没有足够的活泼氢将芳香性自由基封闭，芳香性自由基缩合反应的几率较高，造成过早地生焦。这种来自渣油分子自身的活泼氢的化学行为与渣油热反应生焦诱导期有一定关系。